Concept explainers
(a)
Interpretation:
The block of periodic table to which phosphorus belongs to has to be identified.
Concept Introduction:
Elements that are present in the periodic table can be classified based on the valence electron that is present in the electronic configuration. The elements present in the periodic table are classified as s-block, p-block, d-block, and f-block elements. If the valence electron is present in the
This classification can also be done by considering the group number. Elements present in Group 1 and 2 are known as s-block elements, Group 3 to 12 are known as d-block elements, Group 13 to 18 are known as p-block elements. f-block elements are known as inner
(b)
Interpretation:
The block of periodic table to which
Concept Introduction:
Refer part (a).
(c)
Interpretation:
The block of periodic table to which
Concept Introduction:
Refer part (a).
(d)
Interpretation:
The block of periodic table to which
Concept Introduction:
Refer part (a).
(e)
Interpretation:
The block of periodic table to which osmium belongs to has to be identified.
Concept Introduction:
Refer part (a).
(f)
Interpretation:
The block of periodic table to which krypton belongs to has to be identified.
Concept Introduction:
Refer part (a).
Want to see the full answer?
Check out a sample textbook solutionChapter F Solutions
Chemical Principles: The Quest for Insight
- Assume that the radius of Earth is 6400 km, the crust is 50. km thick, the density of the crust is 3.5 g/cm3, and 25.7% of the crust is silicon by mass. Calculate the total mass of silicon in the crust of Earth.arrow_forward4.48 Elemental phosphorous is used in the semiconductor industry. It can be obtained from an ore called fluoroapatite via reaction with SiO2 and C: 4Ca5( PO4)3F+18SiO2+30C3P4+30CO+18CaSiO3+2CaF2 Suppose a particular semiconductor production plant requires 1500 kg of P4. If the recovery of P4 from this reaction is 73% efficient, what mass of fluoroapatite is needed?arrow_forwardThe present average concentration (mass percent) of magnesium ions in seawater is 0.13%. A chemistry textbook estimates that if 1.00 × 108 tons Mg were taken out of the sea each year, it would take one million years for the Mg concentration to drop to 0.12%. Do sufficient calculations to either verify or refute this statement. Assume that Earth is a sphere with a diameter of 8000 mi, 67% of which is covered by oceans to a depth of 1 mi, and that no Mg is washed back into the oceans at any time.arrow_forward
- Given that the density of argon is 1.78 g/L under standard conditions of temperature and pressure, how many argon atoms are present in a room with dimensions 4.0 m 5.0 m 2.4 m that is filled with pure argon under these conditions of temperature and pressure?arrow_forwardA compound is composed of carbon, hydrogen, nitrogen and oxygen. When a 1.500-g sample of the compound is completely combusted, it yields 1.476 g of CO2and 0.605 g of H2O. In a separate analysis to determine nitrogen, 1.500 g of the compound is found to produce 0.313 g of N2. (a) Calculate the mass percent of each element in the compound. (b) Determine the empirical formula of the compound. (c) If the compound has a molar mass of 134 g/mol, what is the molecular formula?arrow_forwardWhen tin comes into contact with oxygen in the air, tin (IV) oxide, SnO2 is formed. Sn (s) + O2 (g) SnO2 (s) A piece of tin foil, 8.25 cm x 21.5 cm x 0.600 mm (d = 7.28 g / cm), exposed to oxygen. (A) Assuming the reaction of all tin, what is the mass of the oxidized tin foil? (B) Air is about 21% oxygen by volume (d = 1.309 g / L at 25 ° C, 1 atm). How many liters of air is required to fully react with tin foil?arrow_forward
- Mg(OH)2(s)+2HNO3(aq)→ the balanced chemical formula?arrow_forwardFor each of the following reactions, suggest two soluble ionic compounds that, when mixed together in water, result in the net ionic equation given: (a) 2 Ag+ (aq) + CO3²¯ (aq) → Ag₂CO3(s) (b) Mg²+ (aq) + 2 OH¯(aq) → Mg(OH)₂(s), the suspension present in milk of magnesia 3+ (c) 3 Ca³+ (aq) + 2 PO2 (aq) → Ca3(PO4)2(s), gypsum, a component of concretearrow_forwardWhat mass of Cu(IO3)2 can be formed from 0.650 g of CuSO4 · 5H2O? What mass of KIO3 is needed to convert the copper in 0.2750 g of CUSO4 - 5H2O to Cu(IO3)2?arrow_forward
- . A sample of 1.000 g of a compound containing carbon and hydrogen reacts with oxygen at elevated temperature to yield 0.692 g H2O and 3.381 g CO2.(a) Calculate the masses of C and H in the sample.(b) Does the compound contain any other elements?(c) What are the mass percentages of C and H in thecompound?(d) What is the empirical formula of the compound?arrow_forwardIndustrially, hydrogen gas can be prepared by combining propane gas (C3H8) with steam at about 400 degrees C. The products are carbon monoxide gas (CO) and hydrogen gas (H2). (a) Write a balanced equation for the reaction. (b) How many kilograms of H2 can be obtained from 2.75 X 103 kg of propane?arrow_forwardCalculate the molar mass of barium hydroxide octahydrate, Ba(OH)2·8H2O(s).arrow_forward
- General Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage Learning