Concept explainers
(a)
Interpretation:
The block of periodic table to which zirconium belongs to has to be identified.
Concept Introduction:
Elements that are present in the periodic table can be classified based on the valence electron that is present in the electronic configuration. The elements present in the periodic table are classified as s-block, p-block, d-block, and f-block elements. If the valence electron is present in the
This classification can also be done by considering the group number. Elements present in Group 1 and 2 are known as s-block elements, Group 3 to 12 are known as d-block elements, Group 13 to 18 are known as p-block elements. f-block elements are known as inner
(b)
Interpretation:
The block of periodic table to which
Concept Introduction:
Refer part (a).
(c)
Interpretation:
The block of periodic table to which
Concept Introduction:
Refer part (a).
(d)
Interpretation:
The block of periodic table to which barium belongs to has to be identified.
Concept Introduction:
Refer part (a).
(e)
Interpretation:
The block of periodic table to which
Concept Introduction:
Refer part (a).
(f)
Interpretation:
The block of periodic table to which cobalt belongs to has to be identified.
Concept Introduction:
Refer part (a).
Want to see the full answer?
Check out a sample textbook solutionChapter F Solutions
Chemical Principles: The Quest for Insight
- The present average concentration (mass percent) of magnesium ions in seawater is 0.13%. A chemistry textbook estimates that if 1.00 × 108 tons Mg were taken out of the sea each year, it would take one million years for the Mg concentration to drop to 0.12%. Do sufficient calculations to either verify or refute this statement. Assume that Earth is a sphere with a diameter of 8000 mi, 67% of which is covered by oceans to a depth of 1 mi, and that no Mg is washed back into the oceans at any time.arrow_forwardAssume that the radius of Earth is 6400 km, the crust is 50. km thick, the density of the crust is 3.5 g/cm3, and 25.7% of the crust is silicon by mass. Calculate the total mass of silicon in the crust of Earth.arrow_forwardGiven that the density of argon is 1.78 g/L under standard conditions of temperature and pressure, how many argon atoms are present in a room with dimensions 4.0 m 5.0 m 2.4 m that is filled with pure argon under these conditions of temperature and pressure?arrow_forward
- Chlorine exists mainly as two isotopes, 37Cl and 33Cl. Which is more abundant? How do you know?arrow_forwardA compound is composed of carbon, hydrogen, nitrogen and oxygen. When a 1.500-g sample of the compound is completely combusted, it yields 1.476 g of CO2and 0.605 g of H2O. In a separate analysis to determine nitrogen, 1.500 g of the compound is found to produce 0.313 g of N2. (a) Calculate the mass percent of each element in the compound. (b) Determine the empirical formula of the compound. (c) If the compound has a molar mass of 134 g/mol, what is the molecular formula?arrow_forwardWrite the chemical reaction of Iron Sulfide (FeS2) to create Sulfuric acid in mines. It reacts with O2 in the air and 02 saturated in water.arrow_forward
- . A sample of 1.000 g of a compound containing carbon and hydrogen reacts with oxygen at elevated temperature to yield 0.692 g H2O and 3.381 g CO2.(a) Calculate the masses of C and H in the sample.(b) Does the compound contain any other elements?(c) What are the mass percentages of C and H in thecompound?(d) What is the empirical formula of the compound?arrow_forwardYou carefully weigh out 17.00 g g of CaCO 3 CaCO3 powder and add it to 68.85 g g of HCl HCl solution. You notice bubbles as a reaction takes place. You then weigh the resulting solution and find that it has a mass of 78.88 g g . The relevant equation is CaCO 3 (s)+2HCl(aq)→H 2 O(l)+CO 2 (g)+CaCl 2 (aq) CaCO3(s)+2HCl(aq)→H2O(l)+CO2(g)+CaCl2(aq) Assuming no other reactions take place, what mass of CO 2 CO2 was produced in this reaction?arrow_forwardIndustrially, hydrogen gas can be prepared by combining propane gas (C3H8) with steam at about 400 degrees C. The products are carbon monoxide gas (CO) and hydrogen gas (H2). (a) Write a balanced equation for the reaction. (b) How many kilograms of H2 can be obtained from 2.75 X 103 kg of propane?arrow_forward
- (a) A compound MX2 is formed from the M²+ and X ions. The compound contains 86.8% of X by mass. In a reaction, a 0.96 g M²+ ion reacts completely with 0.079 mol X¯ ion. Determine the identity of M²+ and X. (b) In a reaction, the mixture of 13.4 g of calcium fluoride (CaF₂) and 11.1 g of sulfuric acid (H₂SO4) was heated to give off gaseous hydrogen fluoride (HF). The reaction is as shown: CaF2 (s) + H₂SO4 (1) → 2HF (g) + CaSO4 (s) Determine the maximum amount (grams) of hydrogen fluoride that can be obtained. (c) A compound containing barium (Ba) and oxygen, weighed 2.018 g, was dissolved to produce barium ions in solution. The barium ions are then separated from the solution by precipitating method. The precipitate formed was 3.018 g of BaCrO4. Determine the chemical formula of the compound. (d) For the following reaction, determine the mass of sulfur would be needed to obtain 80.0 g of CS₂. The percent yield of the reaction is consistently 92%. CH4 (g) + 4S (g) → CS2 (g) + 2H₂S (g)arrow_forwardMg(OH)2(s)+2HNO3(aq)→ the balanced chemical formula?arrow_forwardHome-Grown Example: Calculation of Mass-Related Concentrations (a) A solution is made by dissolving 1.675 mg of sucrose (C₁2H22011) in 0.01091 g of water. What is the mass percentage of each component of the solution? (b) A 1762-kg sample of groundwater was found to contain 2.443 µg of Fe²+. What is the concentration of Fe²+ in parts per billion?arrow_forward
- Chemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningGeneral Chemistry - Standalone book (MindTap Cour...ChemistryISBN:9781305580343Author:Steven D. Gammon, Ebbing, Darrell Ebbing, Steven D., Darrell; Gammon, Darrell Ebbing; Steven D. Gammon, Darrell D.; Gammon, Ebbing; Steven D. Gammon; DarrellPublisher:Cengage LearningChemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage Learning
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage Learning