The direction in which the crack propagates to produce the shear stress in shear mode II of fracture.

Question

Want to see the full answer?

Answer 1

Question

Chapter 11, Problem 5CQ

To determine

The direction in which the crack propagates to produce the shear stress in shear mode II of fracture.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Which of the following statements regarding brittle failure and crack propagation is CORRECT? Elastic energy is consumed when a crack propagates, due to unloading of a volume of material. Energy is released when the surface area of a material increases, as a result of crack propagation. O The stress at the tip of a crack is less than the nominal stress (force over the cross-sectional area of the component) because the stress flows around the defect. O The fracture toughness of a material is its resistance to an increase in the radius of curvature of a crack. O A material will fail in brittle fashion when the stress intensity at the crack tip is greater than the fracture toughness of the material.

A thin plate of a ceramic material with E = 225 GPa is loaded in tension, developing a stress of 450 MPa. Is the specimen likely to fail if the most severe flaw present is an internal crack oriented perpendicular to the load axis that has a total length 0.25 mm and a crack tip radius of curvature equal to 1 μm?

2- What is the largest size (mm) internal through crack that a thick plate of aluminium alloy 7075-T651 can support at an applied stress of (a) three-quarters of the yield strength and (b) one-half of the yield strength? Assume Y = 1. for 7075-T651, KỊC = 24.2 MPa ym and oYS = 495 MPa.