Interpretation:
The equilibrium constant values
Concept introduction:
Equilibrium constant
In gas phase reactions, partial pressure is used to write equilibrium equation than molar concentration. Equilibrium constant
Consider the reaction where A reacts to give B.
On rearranging,
Where,
The pressure of each species of ideal gas and its molar concentration are directly proportional to each other.
In same way
Where,
R is gas constant
T is absolute temperature
Want to see the full answer?
Check out a sample textbook solutionChapter 13 Solutions
General Chemistry: Atoms First
- Write the equilibrium constant expression for each of the following reactions in terms of concentrations. (a) CO2(g) + C(s) 2 CO(g) (b) [Cu(NH3)4)2+(aq) Cu2+(aq) + 4 NH3(aq) (c) CH3CO2H(aq) + H2O() CH3CO2(aq) + H3O+(aq)arrow_forwardThe conversion of oxygen to ozone has a very small equilibrium constant. 3/2 O2(g) O3(g) K = 2.5 1029 (a) What is the value of K when the equation is written using whole-number coefficients? 3 O2(g) 2 O3(g) (b) What is the value of K for the conversion of ozone to oxygen? 2 O3(g) 3 O2(g)arrow_forwardCalculate the value of the equilibrium constant for the reaction N2(g)+2O2(g)2NO2(g) if the concentrations of the species at equilibrium are [N2] = 0.0013, [O2] = 0.0024, and [NO2] = 0.00065.arrow_forward
- Ammonium carbamate solid (NH4CO2NH2) decomposes at 313 K into ammonia and carbon dioxide gases. At equilibrium, analysis shows that there are 0.0451 atm of CO2, 0.0961 atm of ammonia, and 0.159 g of ammonium carbamate. (a) Write a balanced equation for the decomposition of one mole of NH4CO2NH2. (b) Calculate K at 313 K.arrow_forwardSuppose K = 4.5 103 at a certain temperature for the reaction PCl5(g)PCl3(g)+Cl2(g) If it is found that the concentration of PCl5 is twice the concentration of PCl3, what must be the concentration of Cl2 under these conditions?arrow_forwardThe equilibrium constant for the reaction N2(g) + O2(g) 2 NO(g) is 1.7 103 at 2300 K. (a) What is K for the reaction when written as follows? N2(g) + O2(g) NO(g) (b) What is K for the following reaction? 2 NO(g) N2(g) + O2(g)arrow_forward
- Use the solubility product constant from Appendix F to determine whether a precipitate will form if 10.0 mL of 1.0 106 M iron(II) chloride is added to 20.0 mL of 3.0 104 M barium hydroxide.arrow_forwardWrite the expression for the equilibrium constant and calculate the partial pressure of CO2(g), given that Kp is 0.25 (at 427 C) for NaHCO3(s) NaOH(s) + CO2(g)arrow_forwardConsider the reaction 2N2O(g) + O2(g) 4NO(g) Suppose the system is at equilibrium, and then an additional mole of N2O(g) is injected into the system at constant temperature. Once the reaction reestablishes equilibrium, has the amount of N2O increased or decreased from its original equilibrium amount? Explain. What happens to the value of the equilibrium constant with this change?arrow_forward
- A 1.00-L flask was filled with 2.00 moles of gaseous SO2 and 2.00 moles of gaseous NO2 and heated. After equilibrium was reached, it was found that 1.34 moles of gaseous NO was present. Assume that the reaction SO-(9) + NO2 (g) = SO; (g) + NO(9) occurs under these conditions. Calculate the value of the equilibrium constant, K, for this reaction. K =arrow_forwardGiven the equilibrium equation: 2A(g) + B2(g) 2AB(g) Solve for the molar concentration of A when Keq = 0.0719, [B2] = 3.15 M and [AB] 0.895 M %3D О 39.2 М 1.88 M О 0.25 М 3.54 Мarrow_forwardthe equilibrium constant (K) is a quantitative measurement of the extent to which a chemical or physical reaction proceeds to completion. If two reactants of known initial concentration are mixed and then the concentrations of the products are measured once equilibrium has been established, then the equilibrium constant can be calculated using an ICE table. In this experiment you will measure the equilibrium constant for the formation of iron(III) thiocyanate from the iron(III) cation and thiocyanate anion: Fe3+(aq) + SCN-(aq) FeSCN2+(aq) The product, FeSCN2+, is intensely red, which means that its concentration can be measured by using an ultraviolet-visible (UV-vis) spectrophotometer. So long as a solution is not too concentrated, the absorption of light at a particular wavelength by a chemical species is described by Beer’s Law: A = εℓ[X] where A = absorption of light (unitless number) ε = molar absorptivity constant (cm-1 M-1) ℓ = path length (cm) [X] =…arrow_forward
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningPrinciples of Modern ChemistryChemistryISBN:9781305079113Author:David W. Oxtoby, H. Pat Gillis, Laurie J. ButlerPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage Learning
- Chemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning