Power System Analysis and Design (MindTap Course List)
6th Edition
ISBN: 9781305632134
Author: J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Videos
Textbook Question
Chapter 3, Problem 3.24P
For Problem 3.18, the motor operates at full load, at 0.8 power factor leading, and at a terminal voltage of 10.45 kV. Determine (a) the voltage at bus 1, which is the generator bus, and (b) the generator and motor internal EMFs.
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Answer True or False, then correct errors or explain if any:
1. The term pole in filter terminology refers to the feedback circuit.
2, A voltage shunt feedback with Ai-10, A-20, p 0.45, then Aif will be 1.
3. The integrator Op-Amp circuit can be used to produce square waves.
4. The equivalent circuit of the crystal oscillator is series and parallel (R, C) components.
5. The transistor in a class A power amplifier conducts for the entire input cycle.
6. Bypass capacitors in an amplifier determine the low and high-frequency responses.
7. The midrange voltage gain of an amplifier is 100. The input RC circuit has a lower critical
frequency of 1 kHz. The actual voltage gain at f- 100 Hz is 100.
8. The Bessel filter types produce almost ripple frequency response.
9. RC phase shift oscillators are based on both positive and negative feedback circuits.
10. In a high-pass filter, the roll-off region occurs above the critical frequency,
Q.1. Answer True or False and correct errors if found
1. In a certain Op-Amp. if Ad=3500, Ac=0.35, the CMRR=100dB.
2. The voltage series feedback can increase both input and output impedances.
3. A two-pole Sallen-Key high-pass filter contains one capacitor and two resistors.
4. The main feature of a crystal oscillator is the high frequency operation.
Each transistor in a class B power amplifier conducts for the entire input cycle.
✓ The Q-point must be centered on the load line for maximum class A output signal swing
7. The differentiator Op-Amp can convert the triangle waveform into sinewave.
✗Class AB power amplifier eliminates crossover distortion found in pure class A.
9. Wien-bridge oscillators are based on positive feedback circuits.
10. The band-reject filter is composed of multiplication of LPF and HPF.
Solve by Hand not using Chatgpt or AI
Chapter 3 Solutions
Power System Analysis and Design (MindTap Course List)
Ch. 3 - The Ohms law for the magnetic circuit states that...Ch. 3 - For an ideal transformer, the efficiency is (a) 0...Ch. 3 - For an ideal 2-winding transformer, the...Ch. 3 - An ideal transformer has no real or reactive power...Ch. 3 - For an ideal 2-winding transformer, an impedance...Ch. 3 - Consider Figure 3.4. For an ideal phase-shifting...Ch. 3 - Consider Figure 3.5. Match the following, those on...Ch. 3 - The units of admittance, conductance, and...Ch. 3 - Match the following: (i) Hysteresis loss (a) Can...Ch. 3 - For large power transformers rated more than 500...
Ch. 3 - For a short-circuit test on a 2-winding...Ch. 3 - The per-unit quantity is always dimensionless. (a)...Ch. 3 - Consider the adopted per-unit system for the...Ch. 3 - The ideal transformer windings are eliminated from...Ch. 3 - To convert a per-unit impedance from old to new...Ch. 3 - In developing per-unit circuits of systems such as...Ch. 3 - Prob. 3.17MCQCh. 3 - Prob. 3.18MCQCh. 3 - With the American Standard notation, in either a...Ch. 3 - Prob. 3.20MCQCh. 3 - In order to avoid difficulties with third-harmonic...Ch. 3 - Does an open connection permit balanced...Ch. 3 - Does an open- operation, the kVA rating compared...Ch. 3 - It is stated that (i) balanced three-phase...Ch. 3 - In developing per-unit equivalent circuits for...Ch. 3 - In per-unit equivalent circuits of practical...Ch. 3 - Prob. 3.27MCQCh. 3 - Prob. 3.28MCQCh. 3 - For developing per-unit equivalent circuits of...Ch. 3 - Prob. 3.30MCQCh. 3 - Prob. 3.31MCQCh. 3 - Prob. 3.32MCQCh. 3 - The direct electrical connection of the windings...Ch. 3 - Consider Figure 3.25 of the text for a transformer...Ch. 3 - (a) An ideal single-phase two-winding transformer...Ch. 3 - An ideal transformer with N1=1000andN2=250 is...Ch. 3 - Consider an ideal transformer with...Ch. 3 - A single-phase 100-kVA,2400/240-volt,60-Hz...Ch. 3 - Prob. 3.5PCh. 3 - Prob. 3.6PCh. 3 - Consider a source of voltage v(t)=102sin(2t)V,...Ch. 3 - Prob. 3.8PCh. 3 - Prob. 3.9PCh. 3 - A single-phase step-down transformer is rated...Ch. 3 - For the transformer in Problem 3.10. The...Ch. 3 - Prob. 3.12PCh. 3 - A single-phase 50-kVA,2400/240-volt,60-Hz...Ch. 3 - A single-phase 50-kVA,2400/240-volt,60-Hz...Ch. 3 - Rework Problem 3.14 if the transformer is...Ch. 3 - A single-phase, 50-kVA,2400/240-V,60-Hz...Ch. 3 - The transformer of Problem 3.16 is supplying a...Ch. 3 - Using the transformer ratings as base quantities,...Ch. 3 - Using the transformer ratings as base quantities....Ch. 3 - Using base values of 20 kVA and 115 volts in zone...Ch. 3 - Prob. 3.21PCh. 3 - A balanced Y-connected voltage source with...Ch. 3 - Figure 3.32 shows the oneline diagram of a...Ch. 3 - For Problem 3.18, the motor operates at full load,...Ch. 3 - Consider a single-phase electric system shown in...Ch. 3 - A bank of three single-phase transformers, each...Ch. 3 - A three-phase transformer is rated...Ch. 3 - For the system shown in Figure 3.34. draw an...Ch. 3 - Consider three ideal single-phase transformers...Ch. 3 - Reconsider Problem 3.29. If Va,VbandVc are a...Ch. 3 - Prob. 3.31PCh. 3 - Determine the positive- and negative-sequence...Ch. 3 - Consider the three single-phase two-winding...Ch. 3 - Three single-phase, two-winding transformers, each...Ch. 3 - Consider a bank of this single-phase two-winding...Ch. 3 - Three single-phase two-winding transformers, each...Ch. 3 - Three single-phase two-winding transformers, each...Ch. 3 - Consider a three-phase generator rated...Ch. 3 - The leakage reactance of a three-phase,...Ch. 3 - Prob. 3.40PCh. 3 - Consider the single-line diagram of the power...Ch. 3 - For the power system in Problem 3.41, the...Ch. 3 - Three single-phase transformers, each rated...Ch. 3 - A 130-MVA,13.2-kV three-phase generator, which has...Ch. 3 - Figure 3.39 shows a oneline diagram of a system in...Ch. 3 - The motors M1andM2 of Problem 3.45 have inputs of...Ch. 3 - Consider the oneline diagram shown in Figure 3.40....Ch. 3 - With the same transformer banks as in Problem...Ch. 3 - Consider the single-Line diagram of a power system...Ch. 3 - A single-phase three-winding transformer has the...Ch. 3 - The ratings of a three-phase three-winding...Ch. 3 - Prob. 3.52PCh. 3 - The ratings of a three-phase, three-winding...Ch. 3 - An infinite bus, which is a constant voltage...Ch. 3 - A single-phase l0-kVA,2300/230-volt,60-Hz...Ch. 3 - Three single-phase two-winding transformers, each...Ch. 3 - A two-winding single-phase transformer rated...Ch. 3 - A single-phase two-winding transformer rated...Ch. 3 - Prob. 3.59PCh. 3 - PowerWorid Simulator case Problem 3_60 duplicates...Ch. 3 - Rework Example 3.12 for a+10 tap, providing a 10...Ch. 3 - A 23/230-kV step-up transformer feeds a...Ch. 3 - The per-unit equivalent circuit of two...Ch. 3 - Reconsider Problem 3.64 with the change that now...Ch. 3 - What are the advantages of correctly specifying a...Ch. 3 - Why is it important to reduce the moisture within...Ch. 3 - What should be the focus of transformer preventive...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- A. The ECG signal of a person shows an irregular heartbeat of 180 beats per minute. You areasked to come up with a system that digitises this signal, using an analog-to-digitalconverter (ADC) with a reference voltage of 5 V. The digitised signal should have a resolutionof 1 mV or better.i) How many samples per second should your system take in order to fully capture the ECGsignal?ii) What should the ADC’s resolution in bits be? Alternatively, how many quantisation levelsshould the ADC have; or how many bits per sample should the ADC have? B. You have successfully designed your ECG signal capture device. However, the person fromQuestion A is being examined in a room with fluorescent lights which have recently startedbuzzing. The digitised ECG signal appears to be very noisy, and the medical doctors arefinding it difficult to diagnose the patient. You suspect interference from the electrical mainsis to blame.You also notice that the ECG signal is very faint and not making full use of…arrow_forwardControls Systemsarrow_forwardQuestion about Controls Systemsarrow_forward
- A chemical processing plant requires a simplified safety control system to monitor critical conditions in one of its reactors. The system must evaluate three key parameters and activate two response levels. A combinational circuit with 3 sensors and 2 alarms needs to be designed for this purpose. Sensors: A: Reactor temperature (0 = normal, 1 = high) B: Reactor pressure (0 = normal, 1 = high) C: Mixture pH level (0 = normal, 1 = out of range) Alarms: X: Warning alarm Y: Activation of the emergency shutdown system System requirements: 1. The warning alarm (X) should activate when: At least two parameters are out of range. • Or when the temperature is high (A = 1) and any other parameter is out of range. 2. The emergency shutdown system (Y) must activate when: • All parameters are out of range simultaneously (A = 1, B = 1, C=1). • Or when the temperature and pressure are high simultaneously (A = 1 and B = 1), regardless of the pH level. Request: 1. Design the logic circuit for this…arrow_forwardAn industrial soft drink production plant needs to implement a quality control system for its bottling line. The system must monitor four critical parameters and activate different alarms depending on the conditions detected. It is required to design a digital circuit with 4 inputs and 3 outputs for this purpose. Inputs: A: Carbonation level (0 = normal, 1 = high) B: Liquid temperature (0 = normal, 1 = elevated) C: Line pressure (0 = normal, 1 = low) D: Filling speed (0 = normal, 1 = low) Outputs: X: Minor adjustment alarm (triggered when an odd number of parameters are out of range) Y: Major revision alarm (triggered when at least three parameters are out of range) Z: Adjacent parameters alarm (triggered when exactly two adjacent parameters are out of range System requirements: 1. The minor adjustment alarm (X) should activate when an odd number of parameters are out of range, indicating the need to make minor adjustments to the process. 2. The major overhaul alarm (Y) should activate…arrow_forwardPlease I need accurate answers , according to thr book the answers for STS part are (a) 41 , (b) 10828arrow_forward
- An industrial soft drink production plant needs to implement a quality control system for its bottling line. The system must monitor four critical parameters and activate different alarms depending on the conditions detected. Design a digital circuit with 4 inputs and 3 outputs for this purpose, Design the logic circuit for this control system using Karnaugh maps to simplify the Boolean functions of each output. The final design must be efficient and use as few logic gates as possible. Inputs: A: Carbonation level (0 = normal, 1 = high) B: Liquid temperature (0 = normal, 1 = elevated) C: Line pressure (0 = normal, 1 = low) D: Filling speed (0 = normal, 1 = low) Outputs: X: Minor adjustment alarm (triggered when an odd number of parameters are out of range) Y: Major revision alarm (triggered when at least three parameters are out of range) Z: Adjacent parameters alarm (triggered when exactly two adjacent parameters are out of range)arrow_forwardPlease solve it for STS and TSTarrow_forwardQ3) The ECL circuit as shown in fig. 3 has: (VBE (ECL) = 0.75V, B = 99, VBC (sat) = 0.6V And VOH(min) (VOH - 0.04), determine:- 1. The dissipation power (avg.). 2. The IoH and IiH when excluding red-colored components. (12 Marks) NG RCIB RCIA RCR QBO 100 100 112 LoVo ALQIA QR1 0 QR2 QIB VBB -1,31 REA 365 VEE 365 REB ¥ 5.2arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Power System Analysis and Design (MindTap Course ...Electrical EngineeringISBN:9781305632134Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. SarmaPublisher:Cengage Learning
Power System Analysis and Design (MindTap Course ...
Electrical Engineering
ISBN:9781305632134
Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma
Publisher:Cengage Learning
How does a Transformer work - Working Principle electrical engineering; Author: The Engineering Mindset;https://www.youtube.com/watch?v=UchitHGF4n8;License: Standard Youtube License