(8)(9)Which of the following compounds would be most suitable to be analyzed by gas chromatography?A) glucoseB) olive oilC) NaNO3 aqueous solutionE) none of the above is suitable.D) rubbing alcoholFor packed columns, decreasing the particle size can decrease the plate height and improve theresolution. A decrease in particle size is accompanied by an increase inA) pressureB) retention timeC) void volumeD) peak area

1) Gas chromatography is used for the separation and analyzing the substances that can be vaporized…

(8) 9) Which of the following compounds would be most suitable to be analyzed by gas chromatography? A) glucose B) olive oil D) rubbing alcohol C) NaNO3 aqueous solution E) none of the above is suitable. For packed columns, decreasing the particle size can decrease the plate height and improve the resolution. A decrease in particle size is accompanied by an increase in_ A) pressure B) retention time C) void volume D) peak area

(8) 9) Which of the following compounds would be most suitable to be analyzed by gas chromatography? A) glucose B) olive oil D) rubbing alcohol C) NaNO3 aqueous solution E) none of the above is suitable. For packed columns, decreasing the particle size can decrease the plate height and improve the resolution. A decrease in particle size is accompanied by an increase in_ A) pressure B) retention time C) void volume D) peak area

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

In a reverse-phase separation, a solute was found to have a retention time of 19.6 min, while an unretained peak had a retention time of 1.45 min when the mobile phase was 20/80 v/v% methanol/water. (b) Calculate the k’ for the solute. (c) Calculate the new k’ if the mobile phase is changed to 60/40 methanol/water assuming identical void volume. (d) Calculate a solvent composition that would bring k’ from initial value to a value of 1.20 using tetrahydrofuran/water mobile phase rather than 20/80 v/v % methanol/water.
4. The paper chromatogram of an unknown mixture is shown below: final solvent level 5.3 ст 6.0 cm B 2.0 cm A 1.0 cm origin A. Using the measured distances find the retention factor of components A, B, and C. B. If the paper was run using hexane as the solvent, (a) which compound is the most polar? (b) the least polar? Explain your answer. C. What would you expect to happen to the Rf values if acetone was used instead of hexane as the solvent?
A gas chromatogram of a mixture of toluene and ethyl (a) Measure w1/2 for each peak to the nearest 0.1 mm. When the thickness of the pen trace is significant relative to the length being measured, it is important to take the pen width into account. It is best to measure from the edge of one trace to the corresponding edge of the other trace, as shown at the bottom of the left column. (b) Find the number of theoretical plates and the plate height for each peak.
Use the following information collected from a SIZE-EXCLUSION CHROMATOGRAPHY experiment to answer the questions below. MW Standards Molecular Weight (kDa) Elution Volume (mL) blue dextran 1000 85 myoglobin 17.2 200 TIM 53.3 178 hemoglobin 62.2 156 IgG 140 122 ATCase 307.9 94 Prepare a graph showing the linear relationship between log function of molecular weight against Ve/Vo. The R2value must be 0.9 or higher. What is the linear equation from the standards given? What is the R2value?
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.
In centrifugation chromatography (Ka), the main criterion is the division of the species in the sample between the two phases of the poison. *Depending on what factors
You perform a concentration of a single component using displacement chromatography, and the following data applies: Concentration of binding sites: 4*10^(-4) M Kd for displacer: 2.0*10^(-5) M Kd for component A: 4*10^(-5) M Kd for component B: 1.5*10^(-4) M The concentration of the injected displacer is 2.0*10^(-4) M Determine and justify whether the components are part of a displacement system, and if so, provide their free and bound concentrations. Assume that the number of binding sites is the same for all components.
Classify the descriptions based on whether they apply to ion‑exchange, size‑exclusion, or both types of chromatography columns. - Proteins move through the column at rates determined by their net charge. - The gel bed will contain polymer beads with charged functional groups. - Proteins move through the column at rates determined by their size. - The gel bed will contain porous polymer beads. - The properties of the proteins affect the rate at which they migrate. - Proteins are separated based on differences in their amino acid sequences.
The figure below shows a typical separation of several fat-soluble vitamins by HPLC. The x-axis is retention time in minutes. From the graph try to estimate retention times for peaks 2 and 3. Retention time peak 2 = Retention time peak 3 = Assume that w1/2 is 0.15 minutes for peak 2 and 0.16 minutes for peak 3. Assume that tm is 2.00 minutes. How much time does gamma-tocopherol spend in the stationary phase? From tr and w1/2 find N for the peak that elutes first. From tr and w1/2 find the resolution of peaks 2 and 3 Calculate α for these peaks. If the flow rate for the column is 1.2 mL/minute what is the retention volume for peak 4?
QUESTION 5 In a chromatographic separation using a polar stationary phase and a mobile phase composed of 60% hexane and 40% ethyl acetate, two compounds, benzene (peak A) and toluene (peak B), are eluted. The width of peak A at its base is 1.2 min, the width of peak B at its base is 1.3 min, and the retention time of peak A is 5.2 min and peak B is 3.5 min. What is the resolution (Rs) between these two peaks and is it acceptable? R = 1.36. It is not an acceptable resolution. R = 0.74. It is an acceptable resolution. R = 1.36. It is an acceptable resolution. R = 0.74. It is not an acceptable resolution.
The data in the following table were extracted from a gas chromatographic analysis of a two- component mixture. Air nonane decane Retention time (s) 5 26 32 Peak width, baseline (s) 5 4 (i) Calculate the capacity factor, k, for the two compounds. (ii) Calculate the selectivity factor, a, for the two compounds.
You run the chromatography system with paper as the stationary phase and 70% isopropanol as the mobile phase. You determine the Rf of a polar analyte to be 0.40. If you use 100% isopropanol (a less polar solvent) instead of isopropanol as the mobile phase what would you expect to happen to the Rf value? No value effect on Rf higher lower could be higher or lower