The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds labeled A and B. The separation employed a 2.50 meter packed column under isothermal conditions (90 °C) and a flow rate of 10 mL/min. (a) Detector Signal 300.0 250.0 200.0 150.0 100.0 50.0 0.0 1.0 Unretained 1.2 1.3 1.4 1.5 time (min) Find the retention times for A and B.

The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds labeled A and B. The separation employed a 2.50 meter packed column under isothermal conditions (90 °C) and a flow rate of 10 mL/min. (a) Detector Signal 300.0 250.0 200.0 150.0 100.0 50.0 0.0 1.0 Unretained 1.2 1.3 1.4 1.5 time (min) Find the retention times for A and B.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

1. A mixture containing 0.500 mM chloroform and 0.800 mM DDT gave signals of 15.3 UA for chloroform and 10.1 uA for DDT. An unknown solution (10.0 mL) containing DDR was places in a 100 mL volumetric flask and 10.2 ul, of chloroform (FM 119.39, density = 1.484 g/mL) were added. After dilution to the mark with solvent, polarographic signals of 29.4 and 8.7 uA were observed for the chloroform and DDT, respectively. Find the concentration of DDT in the unknown.
You perform a concentration of a single component using displacement chromatography, and the following data applies: Concentration of binding sites: 4*10^(-4) M Kd for displacer: 2.0*10^(-5) M Kd for component A: 4*10^(-5) M Kd for component B: 1.5*10^(-4) M The concentration of the injected displacer is 2.0*10^(-4) M Determine and justify whether the components are part of a displacement system, and if so, provide their free and bound concentrations. Assume that the number of binding sites is the same for all components.
A chromatographic column was found to have the following constants: A= 0.01 cm, B= 0.30 cmis and C=0.015s. What are the optimum flow rate? A none of the choices Bp-15 cmis p-45 cm/s D u-3.6 cmis E-26 cm/s
The substances in the table below were chromatographed on a gel filtration column. Estimate the molecular weight of the unknown. Compound Blue Dextran 2000 Molecular weight 2 x 106 158 000 V. (mL) 17.7 Aldolase 35.6 Catalase 32.3 210 000 Ferritin 28.6 440 000 Thyroglobulin 25.1 669 000 Unknown 30.3
The data in the following table were extracted from a gas chromatographic analysis of a two- component mixture. Air nonane decane Retention time (s) 5 26 32 Peak width, baseline (s) 5 4 (i) Calculate the capacity factor, k, for the two compounds. (ii) Calculate the selectivity factor, a, for the two compounds.
You run the chromatography system with paper as the stationary phase and 70% isopropanol as the mobile phase. You determine the Rf of a polar analyte to be 0.40. If you use 100% isopropanol (a less polar solvent) instead of isopropanol as the mobile phase what would you expect to happen to the Rf value? No value effect on Rf higher lower could be higher or lower