A chromatographic column was found to have the following constants: A= 0.01 cm, B= 0.30 cmis and C-0.015s. What are the optimum flow rate? A none of the choices Bp-15 cmis p-45 cm/s D p=3.6 cm/s E u-26 cm/s

A chromatographic column was found to have the following constants: A= 0.01 cm, B= 0.30 cmis and C-0.015s. What are the optimum flow rate? A none of the choices Bp-15 cmis p-45 cm/s D p=3.6 cm/s E u-26 cm/s

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: MS: m/z=148 (M,100%),149 (11%) IR (liquid film): 3077‐2835 (multitude of weak peaks)…

A: The IR peaks observed are as shown below:IR (liquid film): 3077‐2835 (multitude of weak peaks),…

Q: A chromatographic analysis is performed with a sample containing toluene and benzene. The column…

Q: The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds…

A: To find out the retention time for component A and B given the following chromatogram. The…

Q: ▾ Standard deviation hint The average or mean, is defined by: where, each is the value of the data…

A: The average concentration of HCl solution is calculated using the following formula:

Q: Statement 1: TLC is considered more convenient and efficient than paper chromatography. Statement 2:…

A: Thin layer chromatography is chromatography in which glass plate is used and it is also known as TLC…

Q: Identify the % recovery in Sample A from this particular data set under recovery study? Ca2* added…

A: To calculate % recovery in sample A from the given data set.

Q: You are asked to do quality control and quality assurance during the determination of lead…

A: The limit of quantitation is given by the expression: Limit of quantitation=10 sm where,…

Q: 2. Several standards were chromatographed, 0.5 1.0 2.0 Conc (ug/ml) Peak area 5.0 10.1 17.2 and the…

A: The graph is to be plot by taking concentration(μg/mL) in X-axis and peak area in Y-axis.

Q: Fill in each blank with the correct choice: When comparing two chromatographic methods, the better…

A: The resolution in a chromatographic method depends on two factors such as plate number and plate…

Q: In your General Chemistry Lab, you and your partner inject a mixture of the three molecules shown…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: How to interept this data to match the structure? It gives the peak/PPM and having trouble matching…

A: The given NMR data is needed to be interpreted and the each signal obtained is needed to be assigned…

Q: in a standard addition calibration method, 50.0 ml volumetric flasks were used. A 5.0 ml aliquot of…

Q: 4. The chromatogram below shows the separation of a mixture obtained by gas chromatography (GC)…

A: The principle of separation in gas chromatography (GC) is based on the partitioning of the sample…

Q: The method of internal standard was used to analyze and measure the concentration of chemical X by…

A: Volume of unknown X =3.0 mL Concentration of Y in the mixture = 1.6 x 10-5 M Volume of Y in the…

Q: During Size exclusion chromatography, if VT = 30 mL, Vs = 15 cm3 , and VL = 15 mL, Vi is 7 mL…

A: Here VT = 30 mL, Vs = 15 cm3 , and VL = 15 mL,

Q: 4-1. What is the relation between the standard deviation and the precision of a procedure? What is…

A: Dear student, according to Bartleby guidelines we're supposed to answer the first question at this…

Q: 23. An aqueous mixture of two substances are analysed by both paper chromatography and high…

A: Few questions based on general chemistry that are to be accomplished.

Q: A peak elutes from an HPLC column 13.8 cm in length in 14.8 min. What would be the width at…

A: The time spent by solute in a chromatographic column is called the interaction time ().Half-height…

Q: 1. Predict the product of the Mixed Adol Condensation reaction below, under basic conditions with…

Q: Notation R VUKOV Reference Data Units Description Universal gas HQ molar H2 heating value 2 (P.T) -…

A: Given: Z(P,T)=1+P…

Q: Consider a separation performed on a 30.0 mm long open tubular column with a 0.50 mm diameter and a…

A: Length of column(L) = 30.0 mmDiameter of column(d) = 0.50 mmThickness(t) = 2.0 micrometerRetention…

Q: Calculate the pl values after addition of the following volume 0.0500 M NH41 to 30.00 mL 0.0500 M…

A: The volume of AgNO3 = 30.00 mL The molarity of AgNO3 = 0.0500 M The moles can be calculated as…

Q: Solvent Front Highest point of the dye Lowest point of the dye Rf Value Baseline Chromatogram A 15.0…

Q: Electron impact ionization (El) is designed to produce what kind of molecular ions predominately? O…

A: The question pertains to the process of electron impact ionization (EI) and its primary outcome in…

Q: None

A: Note that, Plate theory is a simplified model, and real chromatography behavior might deviate…

Q: Swer sections C, D and E in the same answer book. ction D (Chromatography) The following data were…

A: N = 1757.286 K' = 9.285 RS = 1.578

Q: An internal standard is incorporated into an analysis method when systematic sources of variation…

A: High-performance liquid chromatography, formerly known as high-pressure liquid chromatography, is a…

Q: Find the molarity of NaOH for each trial, the average molarity, the standard deviation, the % RSD,…

A: The molarity (M) is calculated by dividing the moles of solute by the volume of solution in…

Q: Aspartame was measured in 3 diet sodas using RP-HPLC: Sample Soda A Soda B Soda C Peak Area 7.86…

A: Dilution factor: It is defined as the number of times the original solution is diluted. Dilution by…

Q: A series of standards were analyzed which gave the following results SOLUTION % Transmittance 0 mL…

A: Beer-Lambert Law: The absorbance (A) is proportional to the concentration (c) of the solution and…

Q: A chromatogram gives an ideal Gaussian peak with tr = 8.70 min and win = 0.19 min. How many…

A: 1. The number of theoretical plates (N) = 11616 2. The plate height of the column (H) = 0.00938 mm

Q: A chromatogram gives an ideal Gaussian peak with tR = 9.40 min and win = 0.19 min. How many…

A: Chromatography is a techniques where separation of components takes places depending on various…

Q: Question 2 Retention time is the time spent by analyte in both mobile and stationary phases. True…

A: Kindly get the answer given below.

Q: How does the chromatogram change when methanol:water (90:10) is used as the mobile phase compared to…

A: Mobile phase is the fluid (liquid or gas) that usually flows through the chromatography system. It…

Q: Describe the following properties of chromatogram (including formula if applicable): Bandwidth…

A: 1.Bandwidth sets the frequency around the wavelength provided by the detector to view and report…

Q: A chromatogram exhibited three peaks for the compounds A, B, and Cat 14.8, 15.5, and 16.2 minutes,…

A: Chromatography is a method by which a mixture is separated by distributing its components between…

Q: A set of samples from an abandoned industrial site detected a suspected groundwater contaminant at a…

Q: 5.) The literature value for the Ksp of lead(II) chromate is 2.8 x 10 13. Calculate the percent…

Q: The following are applications for High Performance Liquid Chromatography, Except: Amplification…

A: Answer = EXCEPT (Amplification)

Q: A 0.0200 gram blood sample was decomposed by a microwave digestion technique followed by dilution to…

A: A 0.0200 gram blood sample containing Pb was estimated with the help of lead complexing agentby…

Q: stationary phase and mobile phase

Q: The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds…

A: To find out the time that components A and B spend in the stationary phase. The chromatogram given…

Q: Olivia developed a new dye called Dye C. It was analyzed against other dyes using paper…

Q: For the data given in Part A, above, from the trendline of your Excel x-y plot, determine and enter…

A: Given data:

Q: A mixture of three components is separated using paper chromatography, and each component is…

A: Given: Absorbance of standard solution- Compound A = 0.72 Compound B = 0.55 Compound C = 0.80 For…

Q: Does the data set of 155.8, 158.4, 194.9, 164.8, 154.5, 184.3, 114.8 and 157.8 ppm contain…

A: The experimental Q value is calculated by the formula, Qexp=x2-x1xN-x1

Question

100%

A chromatographic column was found to have the following constants: A= 0.01 cm, B= 0.30 cmis and C=0.015s. What are the
optimum flow rate?
A none of the choices
Bp-15 cmis
p-45 cm/s
D u-3.6 cmis
E-26 cm/s

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Quality Assurance and Calibration Methods

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Retention volume in a chromatographic experiment 1) increases with decreasing length of the column and lower flow rate of eluent 2) decreases with decreasing length of the column at constant flow rate of eluent 3) decreases with increasing column length at constant flow rate of eluent 4) increases with increasing length and higher flow rate eluent 个个 chromatographic
1
Scientists determined the %w/w H20 in methanol by GC, using a capillary column coated with a nonpolar stationary phase and a TCD detector. A linear regression gives a relationship between %w/w H20 (x) and Peak Height (y) as follows: y= 89.71 x- 0.3024 Calculate the %w/w H20 in a sample giving a peak height of 4.23. O A. 0.0379 O B. 0.0505 O C. 379.17 O D.0.0472 O E. 0.0438
Lli 5 What is the primary advantage of temperature program in gas ?chromatography It improves the detector response O It facilitates the use of the electron capture detector It increases the number of theoretical plates of the column It facilitates the analysis of mixtures of substances with widely differing vapor pressures
A set of samples from an abandoned industrial site detected a suspected groundwater contaminant at a mean concentration of 0.045 µg/L with a standard deviation of 0.007 µg/L. How many samples are required to be collected at a confidence level of 95% and power of 90% if the mean background concentration of the contaminant is 0.035 µg/L? О А.З О В. 4 С. 5 O D. 6
A standard sample contains 15.0 mM of analyte and 25.0 mM of internal standard. The analysis of the standard sample gives peak areas for the analyte and internal standard of 1.782 and 3.539, respectively, in a chromatography analysis. Then sufficient internal standard is added to a sample to make its concentration 10.0 mM. The analysis of this new sample yields peak areas for the analyte and internal standard of 0.894 and 2.981, respectively. Name the calibration method and report the analyte's concentration in the new sample. (e)
Gas chromatography cannot analyze mixtures due to the sensitivity of the instrument. True False
A peak elutes from an HPLC column 17.4 cm in length in 11.4 min. What would be the width at half-height of the peak (in seconds) if the plate height were 4.66 µm? W1/2 What would be the width at half-height of the peak (in seconds) if the plate height were 42.0 µm? W 1/2 = S S
(6) Ms. Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid chromatography using C-18 column with 10 cm long. She has observed that a chromatogram with compound elute in 9.0 min with W½ = 2.0 min. Find the number of theoretical plate and plate height (in mm).
2
A new method is proposed to simultaneously detectand separatefour foodadditives by reversed-phase liquid chromatography. The data were obtained using theliquid chromatographic column with a flow rate of 0.5 mL per min and with the followingparameters: Pore size 100 A Particle Size 3.5 Internal diameter 4.6 mm Length 150 mm The food additives found in the sample resulted in the following data: ( see image for table) a.Calculate the number of plates from each peak. b.Calculate the plate height for the column. c.Retention factor for each peak.
I have set up my spreadsheet and was able to reproduce the result with a pKa of 4.64. TRUE OR FALSE