Physics for Scientists and Engineers: Foundations and Connections
Physics for Scientists and Engineers: Foundations and Connections
1st Edition
ISBN: 9781133939146
Author: Katz, Debora M.
Publisher: Cengage Learning
bartleby

Videos

Textbook Question
Book Icon
Chapter 9, Problem 8PQ

A 537-kg trailer is hitched to a truck. Find the work done by the truck on the trailer in each of the following cases. Assume rolling friction is negligible. a. The trailer is pulled at constant speed along a level road for 2.30 km. b. The trailer is accelerated from rest to a speed of 88.8 km/h. c. The trailer is pulled at constant speed along a road inclined at 12.5° for 2.30 km.

(a)

Expert Solution
Check Mark
To determine

The work done for by the truck on the trailer when the trailer is pulled at constant speed.

Answer to Problem 8PQ

The work done for by the truck on the trailer when the trailer is pulled at constant speed is 0_.

Explanation of Solution

Write the equation of work done.

  Wtot=KfKi                                                                                                    (I)

Here, Wtot is the work done, Kf is the final kinetic energy and Ki is the initial kinetic energy.

At constant speed, the initial and final kinetic energy is same.

  Kf=Ki                                                                                                              (II)

Conclusion:

Substitute, Kf for Ki in equation (I) to find Wtot.

  Wtot=KfKi=0

Thus, the work done for by the truck on the trailer when the trailer is pulled at constant speed is 0_.

(b)

Expert Solution
Check Mark
To determine

The work done for by the truck on the trailer when the trailer is pulled at 88.8km/h.

Answer to Problem 8PQ

The work done for by the truck on the trailer when the trailer is pulled at 88.8km/h is 1.64×105J_.

Explanation of Solution

Write the equation of work done.

  Wtot=KfKi                                                                                                  (III)

Here, Wtot is the work done, Kf is the final kinetic energy and Ki is the initial kinetic energy.

In this case, the initial kinetic energy is zero.

  Ki=0                                                                                                              (IV)

Write the expression for the final kinetic energy.

  Kf=12mv2                                                                                                        (V)

Here, m is the mass and v is the speed.

Rewrite the expression from equation (I).

  Wtot=12mv2                                                                                                    (VI)

Conclusion:

Substitute 537kg for m and 88.8km/h for v in equation (VI) to find Wtot.

  Wtot=12(537kg)[(88.8km/h)(0.277778m/s1km/h)]=(268.5kg)[(88.8km/h)(0.277778m/s1km/h)]=1.64×105J

Thus, the work done for by the truck on the trailer when the trailer is pulled at 88.8km/h is 1.64×105J_.

(c)

Expert Solution
Check Mark
To determine

The work done for by the truck on the trailer when the trailer is pulled at an angle 12.5°.

Answer to Problem 8PQ

The work done for by the truck on the trailer when the trailer is pulled at an angle 12.5° is 2.62×106J_.

Explanation of Solution

Write the equation of work done.

  WT=Wg                                                                                                 (VII)

Here, WT is the work done by the truck and Wg is the work done by gravity.

Write the expression for the work done by gravity.

  Wg=mgrcos(90+θ)                                                                                     (VIII)

Here, m is the mass g is the gravitational acceleration, r is the distance and θ is the angle.

Rewrite the expression from equation (VIII).

  WT=mgrcos(90+θ)                                                                                 (IX)

Conclusion:

Substitute 537kg for m, 9.8m/s2 for g, 2.30km for r and 12.5° for θ in equation (IX) to find WT.

  WT=(537kg)(9.8m/s2)[(2.30km)(1×103m1km)]cos(90°+(12.5°))=(537kg)(9.8m/s2)(2.30×103m)cos(102.5°)=2.62×106J

Thus, the work done for by the truck on the trailer when the trailer is pulled at an angle 12.5° is 2.62×106J_.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!
Students have asked these similar questions
Consider the circuit shown in the figure below. (Let R = 12.0 (2.) 25.0 V 10.0 www 10.0 Ω b www 5.00 Ω w R 5.00 Ω i (a) Find the current in the 12.0-0 resistor. 1.95 × This is the total current through the battery. Does all of this go through R? A (b) Find the potential difference between points a and b. 1.72 × How does the potential difference between points a and b relate to the current through resistor R? V
3.90 ... CP A rocket designed to place small payloads into orbit is carried to an altitude of 12.0 km above sea level by a converted airliner. When the airliner is flying in a straight line at a constant speed of 850 km/h, the rocket is dropped. After the drop, the air- liner maintains the same altitude and speed and continues to fly in a straight line. The rocket falls for a brief time, after which its rocket motor turns on. Once its rocket motor is on, the combined effects of thrust and gravity give the rocket a constant acceleration of magnitude 3.00g directed at an angle of 30.0° above the hori- zontal. For reasons of safety, the rocket should be at least 1.00 km in front of the airliner when it climbs through the airliner's alti- tude. Your job is to determine the minimum time that the rocket must fall before its engine starts. You can ignore air resistance. Your answer should include (i) a diagram showing the flight paths of both the rocket and the airliner, labeled at several…
1. In an industrial fabrication process, a fluid, with density p = 800 kg/m and specific heat capacity c = 5000 J/kg-C°, emerges from a tank at a temperature, T, = 400 °C. The fluid then enters a metal pipe with inner radius a = 2.0 cm and outer radius b = 3.0 cm and thermal conductivity k = 180 W/m•C°. Outside the pipe the temperature is fixed at Tout = 15 °C. If the fluid flows at speed v = 8.0 m/s and the length of the pipe is L = 25 m, what is the temperature of the fluid at the end of the pipe? (Answer: 83 °C) please I need to show All work problems step by step

Chapter 9 Solutions

Physics for Scientists and Engineers: Foundations and Connections

Ch. 9 - Prob. 5PQCh. 9 - Prob. 6PQCh. 9 - Prob. 7PQCh. 9 - A 537-kg trailer is hitched to a truck. Find the...Ch. 9 - Prob. 9PQCh. 9 - A helicopter rescues a trapped person of mass m =...Ch. 9 - Prob. 11PQCh. 9 - An object is subject to a force F=(512i134j) N...Ch. 9 - Prob. 13PQCh. 9 - Prob. 14PQCh. 9 - Prob. 15PQCh. 9 - Prob. 16PQCh. 9 - Prob. 17PQCh. 9 - Prob. 18PQCh. 9 - Prob. 19PQCh. 9 - Prob. 20PQCh. 9 - Prob. 21PQCh. 9 - Prob. 22PQCh. 9 - A constant force of magnitude 4.75 N is exerted on...Ch. 9 - In three cases, a force acts on a particle, and...Ch. 9 - An object of mass m = 5.8 kg moves under the...Ch. 9 - A nonconstant force is exerted on a particle as it...Ch. 9 - Prob. 27PQCh. 9 - Prob. 28PQCh. 9 - Prob. 29PQCh. 9 - A particle moves in the xy plane (Fig. P9.30) from...Ch. 9 - A small object is attached to two springs of the...Ch. 9 - Prob. 32PQCh. 9 - Prob. 33PQCh. 9 - Prob. 34PQCh. 9 - Prob. 35PQCh. 9 - Prob. 36PQCh. 9 - Prob. 37PQCh. 9 - Prob. 38PQCh. 9 - A shopper weighs 3.00 kg of apples on a...Ch. 9 - Prob. 40PQCh. 9 - Prob. 41PQCh. 9 - Prob. 42PQCh. 9 - Prob. 43PQCh. 9 - Prob. 44PQCh. 9 - Prob. 45PQCh. 9 - Prob. 46PQCh. 9 - Prob. 47PQCh. 9 - Prob. 48PQCh. 9 - Prob. 49PQCh. 9 - A small 0.65-kg box is launched from rest by a...Ch. 9 - A small 0.65-kg box is launched from rest by a...Ch. 9 - A horizontal spring with force constant k = 625...Ch. 9 - A box of mass m = 2.00 kg is dropped from rest...Ch. 9 - Prob. 54PQCh. 9 - Return to Example 9.9 and use the result to find...Ch. 9 - Prob. 56PQCh. 9 - Crall and Whipple design a loop-the-loop track for...Ch. 9 - Prob. 58PQCh. 9 - Calculate the force required to pull a stuffed toy...Ch. 9 - Prob. 60PQCh. 9 - Prob. 61PQCh. 9 - Prob. 62PQCh. 9 - An elevator motor moves a car with six people...Ch. 9 - Prob. 64PQCh. 9 - Figure P9.65A shows a crate attached to a rope...Ch. 9 - Prob. 66PQCh. 9 - Prob. 67PQCh. 9 - Prob. 68PQCh. 9 - Prob. 69PQCh. 9 - Prob. 70PQCh. 9 - Prob. 71PQCh. 9 - Estimate the power required for a boxer to jump...Ch. 9 - Prob. 73PQCh. 9 - Prob. 74PQCh. 9 - Prob. 75PQCh. 9 - Prob. 76PQCh. 9 - Prob. 77PQCh. 9 - Prob. 78PQCh. 9 - Prob. 79PQCh. 9 - A block of mass m = 0.250 kg is pressed against a...Ch. 9 - On a movie set, an alien spacecraft is to be...Ch. 9 - Prob. 82PQCh. 9 - A spring-loaded toy gun is aimed vertically and...Ch. 9 - Prob. 84PQCh. 9 - The motion of a box of mass m = 2.00 kg along the...Ch. 9 - Prob. 86PQCh. 9 - Prob. 87PQCh. 9 - Prob. 88PQ
Knowledge Booster
Background pattern image
Physics
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.
Similar questions
SEE MORE QUESTIONS
Recommended textbooks for you
Text book image
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Text book image
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College
Text book image
College Physics
Physics
ISBN:9781285737027
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
Text book image
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
Text book image
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Text book image
Inquiry into Physics
Physics
ISBN:9781337515863
Author:Ostdiek
Publisher:Cengage
Mechanical work done (GCSE Physics); Author: Dr de Bruin's Classroom;https://www.youtube.com/watch?v=OapgRhYDMvw;License: Standard YouTube License, CC-BY