The solution that is isotonic with the solution represented by the diagram A should be identified. Concept introduction: All the membranes found in living systems are semi-permeable in the sense that they allow only selective entry and exit of small molecules and restrict the movement of large particles. The phenomenon of osmosis may be defined as the process that allows the movement of solvent from the region of high solvent concentration to region of low solvent concentration. The colligative property associated with osmosis is termed as osmotic pressure which may be defined as the least amount of pressure that must be exerted on the solution side so as to prevent the flow of pure solvent across the membrane. All colligative properties are dependent upon the concentration of particles irrespective of the nature of the particles.

Question

Want to see the full answer?

Answer 1

Question

Chapter 8.9, Problem 8.19P

Interpretation Introduction

Interpretation:

The solution that is isotonic with the solution represented by the diagram A should be identified.

Concept introduction:

All the membranes found in living systems are semi-permeable in the sense that they allow only selective entry and exit of small molecules and restrict the movement of large particles.

The phenomenon of osmosis may be defined as the process that allows the movement of solvent from the region of high solvent concentration to region of low solvent concentration. The colligative property associated with osmosis is termed as osmotic pressure which may be defined as the least amount of pressure that must be exerted on the solution side so as to prevent the flow of pure solvent across the membrane.

All colligative properties are dependent upon the concentration of particles irrespective of the nature of the particles.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

at 32.0 °C? What is the osmotic pressure (in atm) of a 1.46 M aqueous solution of urea [(NH2), CO] at 3 Round your answer to 3 significant digits.

Reagan is doing an atomic absorption experiment that requires a set of zinc standards in the 0.4-1.6 ppm range. A 1000 ppm Zn solution was prepared by dissolving the necessary amount of solid Zn(NO3)2 in water. The standards can be prepared by diluting the 1000 ppm Zn solution. Table 1 shows one possible set of serial dilutions (stepwise dilution of a solution) that Reagan could perform to make the necessary standards. Solution A was prepared by diluting 5.00 ml of the 1000 ppm Zn standard to 50.00 ml. Solutions C-E are called "calibration standards" because they will be used to calibrate the atomic absorption spectrometer. a. Compare the solution concentrations expressed as ppm Zn and ppm Zn(NO3)2. Compare the concentrations expressed as M Zn and M Zn(NO3)2 - Which units allow easy conversion between chemical species (e.g. Zn and Zn(NO3)2)? - Which units express concentrations in numbers with easily expressed magnitudes? - Suppose you have an analyte for which you don't know the molar…

None