The percentage deprotonation of cation has to be calculated if 7.8 g of C 6 H 5 NH 3 Cl is dissolved water and make it in 350 m L of aqueous solution. . Molarity: Molarity of a solution is defined as the number of moles of solute dissolved in per liter of a solution. This can be expressed using the given formula; Molarity = number of moles volume of solution Percentage deprotonation: The deprotonation percentage is calculated using the ratio of concentration of cation and the initial concentration of their respective acid. The obtained value is multiplied with 100 to get the percentage and the respective formula is given below. Percentage deprotonation = Concentration of cation Initial concentration of acid

Question

Want to see the full answer?

Answer 1

Question

Chapter 6, Problem 6D.20E

Interpretation Introduction

Interpretation:

The percentage deprotonation of cation has to be calculated if 7.8 g of C6H5NH3Cl is dissolved water and make it in 350 m L of aqueous solution.

.

Molarity:

Molarity of a solution is defined as the number of moles of solute dissolved in per liter of a solution. This can be expressed using the given formula;

Molarity=number of molesvolume of solution

Percentage deprotonation:

The deprotonation percentage is calculated using the ratio of concentration of cation and the initial concentration of their respective acid. The obtained value is multiplied with 100 to get the percentage and the respective formula is given below.

Percentage deprotonation = Concentration of cationInitial concentration of acid

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A student proposes the following two-step synthesis of an ether from an alcohol A: 1. strong base A 2. R Is the student's proposed synthesis likely to work? If you said the proposed synthesis would work, enter the chemical formula or common abbreviation for an appropriate strong base to use in Step 1: If you said the synthesis would work, draw the structure of an alcohol A, and the structure of the additional reagent R needed in Step 2, in the drawing area below. If there's more than one reasonable choice for a good reaction yield, you can draw any of them. ☐ Click and drag to start drawing a structure. Yes No ロ→ロ 0|0 G Х D : ☐ ப

टे Predict the major products of this organic reaction. Be sure to use wedge and dash bonds when necessary, for example to distinguish between different major products. ☐ ☐ : ☐ + NaOH HO 2 Click and drag to start drawing a structure.

Shown below are five NMR spectra for five different C6H10O2 compounds. For each spectrum, draw the structure of the compound, and assign the spectrum by labeling H's in your structure (or in a second drawing of the structure) with the chemical shifts of the corresponding signals (which can be estimated to nearest 0.1 ppm). IR information is also provided. As a reminder, a peak near 1700 cm-1 is consistent with the presence of a carbonyl (C=O), and a peak near 3300 cm-1 is consistent with the presence of an O–H. Extra information: For C6H10O2 , there must be either 2 double bonds, or 1 triple bond, or two rings to account for the unsaturation. There is no two rings for this problem. A strong band was observed in the IR at 1717 cm-1