Processing stages: The processing of an instruction has number of operations. The operations are organized into particular sequence of stages. It attempts to follow a uniform sequence for all instructions. The description of stages are shown below: Fetch: It uses program counter “PC” as memory address to read instruction bytes from memory. The 4-bit portions “icode” and “ifun” of specifier byte is extracted from instruction. It fetches “valC” that denotes an 8-byte constant. It computes “valP” that denotes value of “PC” plus length of fetched instruction. Decode: The register file is been read with two operands. It gives values “valA” and “valB” for operands. It reads registers with instruction fields “rA” and “rB”. Execute: In this stage the ALU either performs required operation or increments and decrements stack pointer. The resulting value is termed as “valE”. The condition codes are evaluated and destination register is updated based on condition. It determines whether branch should be taken or not in a jump instruction. Memory: The data is been written to memory or read from memory in this stage. The value that is read is determined as “valM”. Write back: The results are been written to register file. It can write up to two results. PC update: The program counter “PC” denotes memory address to read bytes of instruction from memory. It is used to set next instruction’s address.

Question

Want to see the full answer?

Answer 1

Question

Chapter 4.3, Problem 4.16PP

Program Plan Intro

Processing stages:

The processing of an instruction has number of operations.

The operations are organized into particular sequence of stages.

It attempts to follow a uniform sequence for all instructions.

The description of stages are shown below:

Fetch:

It uses program counter “PC” as memory address to read instruction bytes from memory.

The 4-bit portions “icode” and “ifun” of specifier byte is extracted from instruction.

It fetches “valC” that denotes an 8-byte constant.

It computes “valP” that denotes value of “PC” plus length of fetched instruction.

Decode:

The register file is been read with two operands.

It gives values “valA” and “valB” for operands.

It reads registers with instruction fields “rA” and “rB”.

Execute:

In this stage the ALU either performs required operation or increments and decrements stack pointer.

The resulting value is termed as “valE”.

The condition codes are evaluated and destination register is updated based on condition.

It determines whether branch should be taken or not in a jump instruction.

Memory:

The data is been written to memory or read from memory in this stage.

The value that is read is determined as “valM”.

Write back:

The results are been written to register file.

It can write up to two results.

PC update:

The program counter “PC” denotes memory address to read bytes of instruction from memory.

It is used to set next instruction’s address.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Create a static function in C# where poachers appear and attempt to hunt animals. It gets the location of the closest animal to itself. Take account of that the animal also move too, so it should update the closest location (x, y) everytime it moves to a new location. Use winforms to show the movements of poachers.

Create a static function in C# where poachers appear and attempt to hunt animals. It gets the location of the closest animal to itself. Take account of that the animal also moves too, so it should update the closest location (x, y) everytime it moves to a new location. Use winforms to show to movements

I have to develop an efficient parallel numerical integration program on a 2-D mesh but I'm struggling. And it has to be in Cstar