Concept explainers
(a)
Interpretation:
The greater pressure between the initial pressure of helium and the initial pressure of neon should be determined.
Concept Introduction:
Pressure of a given mass of gas at a particular temperature is defined as the force exerted per unit area of the walls of the container by colliding gas molecules.
(b)
Interpretation:
The diagram of the set-up after the stopcock between the two flasks opened should be drawn.
Concept Introduction:
At a given temperature and pressure, equal volumes of gases contain same number of moles of gas molecules.
(c)
Interpretation:
The final partial pressures of helium and neon in terms of their original pressures should be determined.
Concept Introduction:
The pressure exerted by one gas in a gaseous mixture when it occupies the same volume of the gas mixture is known as the partial pressure.
(d)
Interpretation:
The final pressures in terms of the original pressures of helium and neon should be determined.
Concept Introduction:
At constant temperature, volume of a given mass of gas is inversely proportional to its pressure.
Want to see the full answer?
Check out a sample textbook solutionChapter 13 Solutions
Introductory Chemistry: A Foundation
- How would the use of a volatile liquid affect the measurement of a gas using open-ended manometers vs. closed-end manometers?arrow_forward93 The complete combustion of octane can be used as a model for the burning of gasoline: 2C8H18+25O216CO2+18H2O Assuming that this equation provides a reasonable model of the actual combustion process, what volume of air at 1.0 atm and 25°C must be taken into an engine to burn 1 gallon of gasoline? (The partial pressure of oxygen in air is 0.21 atm and the density of liquid octane is 0.70 g/mL.)arrow_forwardEthanol, C2H5OH, is produced industrially from ethylene, C2H4, by the following sequence of reactions: 3C2H4+2H2SO4C2H5HSO4+( C 2 H 5)2SO4C2H5HSO4+( C 2 H 5)2SO4+3H2O3C2H5OH+2H2SO4 What volume of ethylene at STP is required to produce 1.000 metric ton (1000 kg) of ethanol if the overall yield of ethanol is 90.1%?arrow_forward
- You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.arrow_forward5-25 A gas in a bulb as in Figure 5-3 registers a pressure of 833 mm Hg in the manometer in which the reference arm of the U-shaped tube (A) is sealed and evacuated. What will the difference in the mercury levels be if the reference arm of the U-shaped tube is open to atmospheric pressure (760 mm Hg)?arrow_forward5-114 Carbon dioxide gas, saturated with water vapor, can be produced by the addition of aqueous acid to calcium carbonate based on the following balanced net ionic equation: (a) How many moles of wet CO (g), collected at 60.°C and 774 torr total pressure, are produced by the complete reaction of 10.0 g of CaCO3 with excess acid? (b) What volume does this wet CO2 occupy? (c) What volume would the CO2 occupy at 774 torr if a desiccant (a chemical drying agent) were added to remove the water? The vapor pressure of water at 60.°C is 149.4 mm Hg.arrow_forward
- An organic compound contains C, H, N, and O. Combustion of 0.1023 g of the compound in excess oxygen yielded 0.2766 g CO2 and 0.0991 g H2O. A sample of 0.4831 g of the compound was analyzed for nitrogen by the Dumas method (see Exercise 129). At STP, 27.6 mL of dry N2 was obtained. In a third experiment, the density of the compound as a gas was found to be 4.02 g/L at 127C and 256 torr. What are the empirical and molecular formulas of the compound?arrow_forwardExplain how the volume of the bubbles exhausted by a scuba diver (Figure 9.16) change as they rise to the surface, assuming that they remain intact.arrow_forwardGiven that a sample of air is made up of nitrogen, oxygen, and argon in the mole fractions 0.78 N2, 0.21 O2, and 0.010 Ar, what is the density of air at standard temperature and pressure?arrow_forward
- Chemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage LearningChemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage Learning
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning