Calculation of multifactor productivity. Introduction Productivity can be explained as the measure of level of competitiveness of an organization. It is measured by calculating the ratio of number of outputs produced to the number of inputs used. An increase in the productivity increases the level of wages of the individuals.

Question

Want to see the full answer?

Answer 1

Question

Chapter 1, Problem 9P

a)

Summary Introduction

To determine: Calculation of multifactor productivity.

Introduction

Productivity can be explained as the measure of level of competitiveness of an organization. It is measured by calculating the ratio of number of outputs produced to the number of inputs used. An increase in the productivity increases the level of wages of the individuals.

b)

Summary Introduction

To determine: If there is increase in the pay for center 1, there will the change in productivity for center 1.

c)

Summary Introduction

To determine: Productivity after the installation of new plant in center 3.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

1. At syntecks, the output of a specific process is valued at $100 per unit. The cost of labor is $50 per hour including benefits. The accounting department provided the following information about the process for the past four weeks: week 1 week 2 week 3 week 4 units produced 1,124 1,310 1,092 981 labor ($) 12,735 14,842 10,603 9,526 materials ($) 21,041 24,523 20,442 18,364 overhead ($) 8,992 10,480 8,736 7,848 a. use the multifactor productivity ratio to see whether recent process improvements had any effect and, if so when the effect was noticeable b. has labor productivity changed? use the labor productivity ratio to support your answer

Prepare a flowchart of the field service division process atDEF, as described here. Start from the point where a call isreceived and end when a technician finishes the job.DEF was a multibillion dollar company that manufacturedand distributed a wide variety of electronic, photographic, andreprographic equipment used in many engineering and medi-cal system applications. The Field Service Division employed475 field service technicians, who performed maintenance andwarranty repairs on the equipment sold by DEF. Customerswould call DEF’s National Service Center (NSC), which receivedabout 3,000 calls per day. The NSC staffed its call center withabout 40 call-takers. A typical incoming service call was receivedat the NSC and routed to one of the call-takers, who enteredinformation about the machine, the caller’s name, and the typeof problem into DEF’s mainframe computer. In some cases,the call-taker attempted to help the customer fix the problem.However, call-takers were currently only able…

In reference to an Human Resource Management course 4th year college course at Malone University using the following textbook: Gomez-Mejia, L. R., Balkin, D. B., Cardy, R. L., & Carson, K. P. (2020). Managing human resources. (9th ed.). Boston: Pearson Education. Which one of the following functions is typically not a human resource management responsibility? a. Analysis and design of work b. Demand forecasting c. Performance management and development d. Exit interviews