Concept explainers
(a)
Interpretation:
The effect on the pressure of the gas should be identified if the initial volume is halved and double the temperature.
Concept introduction:
Different laws have been put forward to introduce properties of gases:
Boyle’s law:
At fixed temperature, the volume of a fixed amount of gas is inversely proportional to the pressure exerted by the gas.
Charles law: States that volume is directly proportional to temperature when the gas is held
at constant pressure and number of molecules.
General
(b)
Interpretation:
The effect on the pressure of the gas should be identified if the initial volume is doubled and halved the temperature.
Concept introduction:
Different laws have been put forward to introduce properties of gases:
Boyle’s law:
At fixed temperature, the volume of a fixed amount of gas is inversely proportional to the pressure exerted by the gas.
Charles law: States that volume is directly proportional to temperature when the gas is held
at constant pressure and number of molecules.
General Gas Law: Combining Charles’s law and Boyle’s law we get the General gas law or Combined gas law.
Want to see the full answer?
Check out a sample textbook solutionChapter 8 Solutions
FUND.OF GEN CHEM CHAP 1-13 W/ACCESS
- A bicycle pump contains 0.682 liters of air at 99.3 kpa . If the handle is pressed down decreasing the volume of the inside air to 0.151 L, what is the pressure inside the pump ? Assume temperature is constantarrow_forwardA typical room is 4.0 m long, 5.0 m wide, and 2.5 m high. What is the total mass of the oxygen in the room assuming that the gas in the room is at STP and that air contains 21% oxygen and 79% nitrogen?arrow_forwardWhat is the volume of a container if 8.98 mol of a gas at 2.88 atm of pressure is at a temperature of 22°C? 75.5 L O 70.9 L 43.2 L 42.5 L 32.4 Larrow_forward
- According to Dalton’s law, what is the partial pressure of amixture of gases? What is water vapor pressure?arrow_forwardFor the gas - phase equilibrium A(g) + 2 B(g) = C(g) the initial partial pressures of A, B, and C are all 0.300 atm. After equilibrium is established at 25 \deg C, it is found that the partial pressure of C is 0.220 atm. What is AG\deg for this reaction? (R = 8.314 J/mol ·K).arrow_forwardA sample of 8.00 mol of gas in a 10.00 L container is at 45.0 °C. What is the pressure (in atm) of the gas?arrow_forward
- 15.0 L of an ideal gas at 298 K and 3.36 atm are heated to 383 K with a new pressure of 6.05 atm. What is the new volume in liters?arrow_forwardA sample of nitrogen gas occupies a volume of 2.00 L at 756 mm Hg and 0.00° C. Thevolume increases by 2.00 L and the temperature decreases to 137 K. What is the finalpressure exerted on the gas?arrow_forwardDetermine and report the pressure of collected hydrogen gas in atmospheres. Report this result to one more digit than allowed by applying the rules of significant figures. (1 atm = 760 mm Hg, an exact conversion factor.) Determine the moles of hydrogen collected by substituting the appropriate quantities into the ideal gas equation and solving. Report this result to one more digit than allowed by applying the rules of significant figures. Notes: the gas temperature is the same as the listed temperature; R = 0.082057 L-atm/mol-K. Be mindful of units. Determine the experimental atomic mass of Cu. Round this result to the correct number of significant figures. Determine the percent relative error (= ????????????−?h????????? ? 100). The molar mass of Cu is 63.546 g/mol. Mass of copper before electrolysis 6.008 g Mass of copper after electrolysis 5.860 g Volume of H2 collected 58.9 mL Pressure of H2, PH2 720.8 mm Hg Temperature 24.0 oCarrow_forward
- How does the kinetic–molecular theory of gases explain gas pressure?arrow_forwardHow many liters of dry hydrogen gas, measured at 798 mmHg and 21C, will be released by the decomposition of 230 mL of H20 at 1.42atm and 30C? 2 H20 (g) → 2 H2 (g) + O2 (g) Answer to 3 decimal places. Your Answer: Answer unitsarrow_forwardA quantity of gas in a piston cylinder had a volume of 0.539 m^3 and a pressure of 200 Pa. the piston compresses the gas to 0.222 m^3 in an isothermal (constant-temperature) process. What is the final pressure of the gas?arrow_forward
- Basic Clinical Lab Competencies for Respiratory C...NursingISBN:9781285244662Author:WhitePublisher:Cengage