The diagram that better represents the solution of NaF dissolved in water is to be identified and reason behind the choice should be explained. Also, whether the solution will conduct electricity or not should be determined. Concept introduction: An electrolyte may be defined as the ionic compound that on dissolution in polar solvents dissociates to produces cationic and anionic species. There are three kinds of electrolyte namely strong electrolyte, weak electrolyte, and non-electrolyte. The strong electrolytes are those which on dissolution dissociates completely into its constituent ions however, the weak electrolytes are not completely dissociated. For example, sodium chloride and sulphuric acids are regarded as strong electrolytes while acetic acid is regarded as a weak electrolyte. Benzene and urea that don not dissociate at all and are termed as non -electrolytes.

Question

Want to see the full answer?

Answer 1

Question

Chapter 8, Problem 8.40P

Interpretation Introduction

Interpretation:

The diagram that better represents the solution of NaF dissolved in water is to be identified and reason behind the choice should be explained. Also, whether the solution will conduct electricity or not should be determined.

Concept introduction:

An electrolyte may be defined as the ionic compound that on dissolution in polar solvents dissociates to produces cationic and anionic species. There are three kinds of electrolyte namely strong electrolyte, weak electrolyte, and non-electrolyte.

The strong electrolytes are those which on dissolution dissociates completely into its constituent ions however, the weak electrolytes are not completely dissociated. For example, sodium chloride and sulphuric acids are regarded as strong electrolytes while acetic acid is regarded as a weak electrolyte.

Benzene and urea that don not dissociate at all and are termed as non -electrolytes.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

What impact would adding twice as much Na2CO3 than required for stoichiometric quantities have on the quantity of product produced? Initial results attached

Given that a theoretical yield for isolating Calcium Carbonate in this experiment would be 100%. From that information and based on the results you obtained in this experiment, describe your success in the recovery of calcium carbonate and suggest two possible sources of error that would have caused you to not obtain 100% yield. Results are attached form experiment

5) Calculate the flux of oxygen between the ocean and the atmosphere(2 pts), given that: (from Box 5.1, pg. 88 of your text): Temp = 18°C Salinity = 35 ppt Density = 1025 kg/m3 Oxygen concentration measured in bulk water = 263.84 mmol/m3 Wind speed = 7.4 m/s Oxygen is observed to be about 10% initially supersaturated What is flux if the temperature is 10°C ? (2 pts) (Hint: use the same density in your calculations). Why do your calculated values make sense (or not) based on what you know about the relationship between gas solubility and temperature (1 pt)?