Review Question 15.1 Imagine that a balloon expands when brought from a cold garage into a warm room. Both the room and the garage are at atmospheric pressure. The change in the volume of the ballon is ΔV. What is the work that the air in the room does on the balloon during the process?
The work done by air on the balloon, such that the balloon is expanding in a warm room after it is brought there from a cold garage, considering that the change in volume is
Answer to Problem 1RQ
Solution:
Explanation of Solution
Introduction:
Work done by an environment on a system under consideration has a magnitude that is evaluated by multiplying the change in volume and the constant pressure acting on the system. It is important to understand that if the volume of the system increases, the work done by the environment on the system is negative and if the volume decreases, the work done is positive.
Explanation:
Consider the provided case, in which the gas in the balloon expands. So, as the gas expands, its volume increases and the gas does positive work on the environment, that is, the air at atmospheric pressure present in the room. As a result of this, the air in the warm room does the same amount of negative work on the gas in the balloon.
The work done by the environment on the gas at constant pressure is calculated using the expression:
Here,
Conclusion:
The work done by the air on the balloon is equal to
Want to see more full solutions like this?
Chapter 15 Solutions
College Physics
Additional Science Textbook Solutions
The Cosmic Perspective Fundamentals (2nd Edition)
Conceptual Physics (12th Edition)
Physics for Scientists and Engineers: A Strategic Approach, Vol. 1 (Chs 1-21) (4th Edition)
College Physics (10th Edition)
- Consider these scenarios and state whether work is done by the system on the environment (SE) or by the environment on the system (ES): (a) opening a carbonated beverage; (b) filling a flat tire; (c) a sealed empty gas can expands on a hot day, bowing out the walls.arrow_forwardIn a cylinder of an automobile engine, immediately after combustion the gas is confined to a volume of 50.0 cm3 and has an initial pressure of 3.00 106 Pa. The piston moves outward to a final volume of 300 cm3, and the gas expands without energy transfer by heat, (a) What is the final pressure of the gas? (b) How much work is done by the gas in expanding?arrow_forwardA hand-driven tire pump has a piston with a 2.50-cm diameter and a maximum stroke of 30.0 cm. (a) How much work do you do in one stroke if the average gauge pressure is 2.1105 N/m2 (about 35 psi)? (b) What average force do you exert on the piston, neglecting friction and gravitational force?arrow_forward
- Air (a diatomic ideal gas) at 27.0C and atmospheric pressure is drawn into a bicycle pump (Figure P17.53) that has a cylinder with an inner diameter of 2.50 cm and length 50.0 cm. The downstroke adiabatically compresses the air, which reaches a gauge pressure of 8.00 105 Pa before entering the tire. We wish to investigate the temperature increase of the pump. (a) What is the initial volume of the air in the pump? (b) What is the number of moles of air in the pump? (c) What is the absolute pressure of the compressed air? (d) What is the volume of the compressed air? (e) What is the temperature of the compressed air? (f) What is the increase in internal energy of the gas during the compression? What If? The pump is made of steel that is 2.00 mm thick. Assume 4.00 cm of the cylinders length is allowed to come to thermal equilibrium with the air. (g) What is the volume of steel in this 4.00-cm length? (h) What is the mass of steel in this 4.00-cm length? (i) Assume the pump is compressed once. After the adiabatic expansion, conduction results in the energy increase in part (f) being shared between the gas and the 4.00-cm length of steel. What will be the increase in temperature of the steel after one compression? Figure P17.53arrow_forwardEngineers are frequently called on to inspect and, if necessary, repair equipment in nuclear power plants. Suppose that the city lights go out. After inspecting the nuclear reactor, you find a leaky pipe that leads from the steam generator to turbine chamber, (a) How do the pressure readings for the turbine chamber and steam condenser compare? (b) Why is the nuclear reactor not generating electricity?arrow_forwardOne mole of an ideal gas is contained in a cylinder with a movable piston. The initial pressure, volume, and temperature are Pi, Vi, and Ti, respectively. Find the work done on the gas in the following processes. In operational terms, describe how to carry out each process and show each process on a PV diagram. (a) an isobaric compression in which the final volume is one-half the initial volume (b) an isothermal compression in which the final pressure is four times the initial pressure (c) an isovolumetric process in which the final pressure is three times the initial pressurearrow_forward
- A power plant has been proposed that would make use of the temperature gradient in the ocean. The system is to operate between 20.0C (surface water temperature) and 5.00C (water temperature at a depth of about 1 km). (a) What is the maximum efficiency of such a system? (b) If the useful power output of the plant is 75.0 MW, how much energy is absorbed per hour? (c) In view of your answer to part (a), do you think such a system is worthwhile (considering that there is no charge for fuel)?arrow_forwardFigure P20.45 shows a phase diagram of carbon dioxide in terms of pressure and temperature, a. Use the phase diagram to explain why dry ice (solid carbon dioxide) sublimates into vapor at atmospheric pressure rather than melting into a liquid. At what temperature does the dry ice sublimate when at atmospheric pressure? b. Estimate what pressure would be needed to liquefy carbon dioxide at room temperature.arrow_forwardWhat is the change in internal energy of a car if you put 12.0 gal of gasoline into its tank? The energy content of gasoline is 1.3108J/gal. All other factors, such as the car‘s temperature, are constant.arrow_forward
- What is the net work output of a heat engine that follows path ABBA in the figure above, with a straight line from B to D? Why is the work output less than for path ABCDA? Explicitly show how you follow the steps in the Problem Solving Strategies for Thermodynamics.arrow_forwardThe squeaker on a dog’s squeaky toy is broken so that no air can enter or escape. The volume of the squeaky toy is 0.5 liters. The initial pressure inside the squeaky toy is 4.5×105 Pa. The dog can bite down with a pressure of 2.6×106 Pa. Assume the inside of the dog’s mouth is a constant 29◦C. How much work does the dog do on the squeaky toy when it bites down? (This should be a negative number because the force exerted by the dog successfully squishes the squeaky toy, doing positive work, while the gas in the toy pushes back, trying to slow the closing of the dog’s mouth, doing negative work.)arrow_forwardA hand-driven tire pump has a piston with a 2.2 cm diameter and a maximum stroke of 34 cm. How much work do you do in one stroke if the average gauge pressure is 2.6 × 10° N/m²? W = What average force do you exert on the piston, neglecting friction and gravitational force? F =arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningUniversity Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStax
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegePhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning