Write a code to investigate the type of the critical point for the given linear system and construct a phase portrait.

Question

Want to see the full answer?

Answer 1

Question

Chapter 6.2, Problem 26P

Program Plan Intro

Write a code to investigate the type of the critical point for the given linear system and construct a phase portrait.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

2. calculates the trajectory r(t) and stores the coordinates for time steps At as a nested list trajectory that contains [[xe, ye, ze], [x1, y1, z1], [x2, y2, z2], ...]. Start from time t = 0 and use a time step At = 0.01; the last data point in the trajectory should be the time when the oscillator "hits the ground", i.e., when z(t) ≤ 0; 3. stores the time for hitting the ground (i.e., the first time t when z(t) ≤ 0) in the variable t_contact and the corresponding positions in the variables x_contact, y_contact, and z_contact. Print t_contact = 1.430 X_contact = 0.755 y contact = -0.380 z_contact = (Output floating point numbers with 3 decimals using format (), e.g., "t_contact = {:.3f}" .format(t_contact).) The partial example output above is for ze = 10. 4. calculates the average x- and y-coordinates 1 y = Yi N where the x, y, are the x(t), y(t) in the trajectory and N is the number of data points that you calculated. Store the result as a list in the variable center = [x_avg, y_avg]…

A damper (or dashpot) is connected to the mass M of the previous problem. This could represent air resistance. The entire system could be a simple model of an automobile wheel suspension system (assuming the automobile body immobile in a vertical direction). Then the damper acts as a shock absorber. As before, the system is displaced and released and x(tg) = x, and v(to) = vo - It can be shown that the motion of the system Is described by the following differential equation: Mx + Dx + Kx(t) = 0 where D is the damping factor of the dashpot and x = v(t) = velocity at time t. Model and simulate the motion of the system from timet= to to t= tf, using a digital computer program, FIG. 1 DAMPER 3 SPRING FIG.I M MASS

Q.4 In an experimental setup, mineral oil is filled in between the narrow gap of two horizontal smooth plates. The setup has arrangements to maintain the plates at desired uniform temperatures. At these temperatures, ONLY the radiative heat flux is negligible. The thermal conductivity of the oil does not vary perceptibly in this temperature range. Consider four experiments at steady state under different experimental conditions, as shown in the figure Q1. The figure shows plate temperatures and the heat fluxes in the vertical direction. What is the steady state heat flux (in W m) with the top plate at 90°C and the bottom plate at 45°C? [4] 30°C 70°C 40°C 90°C flux = 39 Wm-2 flux =30 Wm2 flux = 52 Wm 2 flux ? Wm-2 60°C 35°C 80°C 45°C Experiment 1 Experiment 2 Experiment 3 Experiment 4