(a)
Interpretation:
Whether
Concept Introduction:
Intermolecular forces are forces that are responsible for interaction between molecules. Such forces include both attractive as well as repulsive forces.
Types of intermolecular forces:
1. Ion-dipole forces: These forces come into play when ions interact with polar molecules. Ion gets attracted to oppositely charged end of polar molecule.
2. Dipole-dipole forces: These forces arise when there is interaction between oppositely charged ends of different dipoles.
3. London forces: These forces exist when there is interaction between nonpolar molecules. There occurs distortion in symmetry of electron clouds when two nonpolar molecules come closer to each other. Such forces exist in all molecules and therefore London forces are called universal.
4. Hydrogen bonding: This intermolecular force exists when hydrogen atoms are connected to highly electronegative elements like
(b)
Interpretation:
Whether
Concept Introduction:
Refer to part (a).
(c)
Interpretation:
Whether
Concept Introduction:
Refer to part (a).
(d)
Interpretation:
Whether
Concept Introduction:
Refer to part (a).
Want to see the full answer?
Check out a sample textbook solutionChapter 3 Solutions
Chemical Principles: The Quest for Insight
- (a) Magnesium (Mg) has a hexagonal close-packed (HCP) crystal structure with the lattice parameter of a = 0.321 nm and c= 0.521 nm and the atomic radius is 0.173 nm. (i) What is the number of atoms per unit cell in HCP structure? (ii) Determine the atomic packing factor of the Mg unit cell. (iii) Is Mg containing an ideal atomic packing factor? You may justify your answer by evaluating the HCP c/a ratio. Subsequently, will slip be harder in Mg compared to the ideal HCP structure? Justify your answer.arrow_forward(a) How do the viscosity and surface tension of liquids change as intermolecular forces become stronger? (b) How do the viscosity and surface tension of liquids change as temperature increases? Accounts for these trendsarrow_forwardA 0.640 g sample of a metal, M, reacts completely with sulfuric acid according to M(s) + H,SO,(aq) – MSO, (aq) + H,(g) A volume of 291 mL of hydrogen is collected over water; the water level in the collecting vessel is the same as the outside level. Atmospheric pressure is 756.0 Torr, and the temperature is 25 °C. The vapor pressure of water at 25 °C is 23.8 Torr. Calculate the molar mass of the metal. molar mass: g/mol Question Source: McQuarrie, Rock, And Gallogly 4e - General Chemsitry | Pubarrow_forward
- A 0.580 g sample of a metal, M, reacts completely with sulfuric acid according to M(s) + H,SO, (aq) – MSO, (aq) + H, (g) A volume of 225 mL of hydrogen is collected over water; the water level in the collecting vessel is the same as the outside level. Atmospheric pressure is 756.0 Torr, and the temperature is 25 °C. The vapor pressure of water at 25 °C is 23.8 Torr. Calculate the molar mass of the metal. molar mass: 63.1189 g/molarrow_forward(a) Which kind of intermolecular attractive force is shownin each case here? (b) Predict which of the four interactions is the weakest.arrow_forward4. A. Use the list of intermolecular and interparticle forces listed below to account for the following phenomena. Justify your answer in each case. London Dispersion Forces lonic Bonding Dipole-Dipole Interactions Metallic Bonding Hydrogen Bonding Covalent Bonding (i) Nacl has a very high heat of vaporization. (ii) The high volatility of helium (boiling point is - 267 °C, lowest of any element). (iii) What are the strongest attractive forces that must be overcome to boil carbon tetrachloride, (CCl,)? B. Read the following statement: NaF has a higher melting point than F2 because it has a greater molar mass. Do you agree with the statement? Explain why you believe the statement is true or falsrarrow_forward
- A 7.40 g sample of solid Ni(CN), ·4H,0 was heated such that the water turned to steam and was driven off. Assuming ideal behavior, what volume would that steam occupy at 1.00 bar and 100 °C? It may be useful to consult the periodic table. volume: Larrow_forwardA mole of air, (80.0% N2 and 20.0% O2, by volume) at 24.8oC is brought into contact with liquid water which has a vapor pressure of 3118 Pa at this temperature. (A) What is the volume of the dry air, if the pressure is 1 bar? (B) What is the final volume of the air saturated with water vapor, if the total pressure is kept as 1 bar? (C) What is the mole fraction of each gas in the moist air?arrow_forwardFor the shown crystal structure, write down (a) the Bravais lattice and (b) the basis of the primitive unit cell. For this structure a=b= c and a=B=y%3D90°. The green (A) atoms at the vertices; blue (B) atom at the center, pink (C) atoms are the centers of two opposite faces; and brown (D) atoms at the centers of four edges of the unit cell. Note that the a, b and c translation vectors are along the positive x, y and z axes, respectively, as shown. CODarrow_forward
- Hydrazine (H2NNH2), hydrogen peroxide (HOOH), andwater (H2O) all have exceptionally high surface tensionscompared with other substances of comparable molecularweights. (a) Draw the Lewis structures for these three compounds.(b) What structural property do these substanceshave in common, and how might that account for the highsurface tensions?arrow_forwardA metal X has an atomic radius of 0.126 nm. If the density and molar mass of X are 7.87 g cm3 and 55.85 g mol1, respectively. 1. (a) (i) Determine the number of atoms per unit cell and the crystal structure of metal X. (ii) Determine the volume of the unit cell. (ii) Determine its planar density in [100], [110] and [111] directions. (iv) Explain which direction would be the most possible slip direction when shear stress is applied. (b) Explain the role of matrix and reinforcement phase in a composite material.arrow_forwardPrior to the discovery that freon-12 (CF2Cl2) is harmful to the Earth’s ozone layer it was frequently used as the dispersing agent in spray cans for hair spray etc. Estimate the pressure that a can of hair spray using freon-12 has to withstand at 40 °C, the temperature of a can that has been standing in sunlight. The enthalpy of vaporization of freon-12 at its normal boiling point of −29.2 °C is 20.25 kJ mol−1; assume that this value remains constant over the temperature range of interest.arrow_forward
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningIntroduction to General, Organic and BiochemistryChemistryISBN:9781285869759Author:Frederick A. Bettelheim, William H. Brown, Mary K. Campbell, Shawn O. Farrell, Omar TorresPublisher:Cengage LearningChemistry: Principles and PracticeChemistryISBN:9780534420123Author:Daniel L. Reger, Scott R. Goode, David W. Ball, Edward MercerPublisher:Cengage Learning