Under physiological condition, behavior of amino acid to be identified. Concept Introduction : Proteins: Proteins are condensation polymers formed from amino acids. Proteins provide structural support, help organisms move, store and transport chemicals from one area to another. Proteins are polymers, in which the amino acids called monomers bonded each other by eliminating water molecule, and the formation of amide linkage which known as condensation process. The bonding between two amino acids otherwise known as peptide bonds; all together the proteins are condensation polymers of amino acids or amino acids are the building blocks of proteins.

Question

Want to see the full answer?

Answer 1

Question

Chapter 24.1, Problem 2RC

Interpretation Introduction

Interpretation: Under physiological condition, behavior of amino acid to be identified.

Concept Introduction:

Proteins: Proteins are condensation polymers formed from amino acids. Proteins provide structural support, help organisms move, store and transport chemicals from one area to another. Proteins are polymers, in which the amino acids called monomers bonded each other by eliminating water molecule, and the formation of amide linkage which known as condensation process. The bonding between two amino acids otherwise known as peptide bonds; all together the proteins are condensation polymers of amino acids or amino acids are the building blocks of proteins.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Complete the clean-pushing mechanism for the given ether synthesia from propanol in concentrated sulfurica140°C by adding any mining aloms, bands, charges, nonbonding electron pairs, and curved arrows. Draw hydrogen bonded to cayan, when applicable. ore 11,0 HPC Step 1: Draw curved arrows Step 2: Complete the intend carved Q2Q 56 QQQ Step 3: Complete the intermediate and add curved Step 4: Modify the structures to draw the QQQ QQQ

6. In an experiment the following replicate set of volume measurements (cm3) was recorded: (25.35, 25.80, 25.28, 25.50, 25.45, 25.43) A. Calculate the mean of the raw data. B. Using the rejection quotient (Q-test) reject any questionable results. C. Recalculate the mean and compare it with the value obtained in 2(a).

A student proposes the transformation below in one step of an organic synthesis. There may be one or more reactants missing from the left-hand side, but there are no products missing from the right-hand side. There may also be catalysts, small inorganic reagents, and other important reaction conditions missing from the arrow. • Is the student's transformation possible? If not, check the box under the drawing area. • If the student's transformation is possible, then complete the reaction by adding any missing reactants to the left-hand side, and adding required catalysts, inorganic reagents, or other important reaction conditions above and below the arrow. • You do not need to balance the reaction, but be sure every important organic reactant or product is shown. + T G OH де OH This transformation can't be done in one step.