The validation of the fact that bioorganic substances are much more abundant than bioinorganic substances concerning human body composition, in terms of mass percent has to be stated. Concept introduction: The chemical substance found in the living organism is called biochemical substance. The biochemical substance is further subdivided into bioinorganic substance and bioorganic substance. Bioinorganic substances do not contain carbon, for example water and inorganic salts. On the other hand bioorganic substances contain carbon, for example lipids and carbohydrates.

Question

Want to see the full answer?

Answer 1

Question

Chapter 18, Problem 18.2EP

(a)

Interpretation Introduction

Interpretation: The validation of the fact that bioorganic substances are much more abundant than bioinorganic substances concerning human body composition, in terms of mass percent has to be stated.

Concept introduction: The chemical substance found in the living organism is called biochemical substance. The biochemical substance is further subdivided into bioinorganic substance and bioorganic substance. Bioinorganic substances do not contain carbon, for example water and inorganic salts. On the other hand bioorganic substances contain carbon, for example lipids and carbohydrates.

(b)

Interpretation Introduction

Interpretation: The validation of the fact that bioinorganic substances are slightly less abundant than bioorganic substances concerning human body composition, in terms of mass percent has to be stated.

Concept introduction: The chemical substance found in the living organism is called biochemical substance. The biochemical substance is further subdivided into bioinorganic substance and bioorganic substance. Bioinorganic substances do not contain carbon, for example water and inorganic salts. On the other hand bioorganic substances contain carbon, for example lipids and carbohydrates.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?