There are some descriptions given about some lipoproteins in the question. We have to match them. Concept Introduction: Lipoproteins are assembly of proteins and lipids that helps in hydrophobic fats in water inside and outside of cells. They are classified as: 1. Low Density Lipoproteins 2. High Density Lipoproteins 3. Chilomicron 4. Very Low Density Lipoprotein 5. Intermediate Density Lipoprotein To match: The given lipoproteins: 1. Chylomicrons 2.VLDL 3. LDL 4. HDL with the following functions: a. Good cholesterol b. transports most of cholesterol to cells c. carries triacylglycerols from intestines to fat cells d. transports cholesterols to liver

Question

Want to see the full answer?

Answer 1

Question

Chapter 17, Problem 17.89CQ

Interpretation Introduction

Interpretation: There are some descriptions given about some lipoproteins in the question. We have to match them.

Concept Introduction: Lipoproteins are assembly of proteins and lipids that helps in hydrophobic fats in water inside and outside of cells. They are classified as: 1. Low Density Lipoproteins 2. High Density Lipoproteins 3. Chilomicron 4. Very Low Density Lipoprotein 5. Intermediate Density Lipoprotein

To match: The given lipoproteins: 1. Chylomicrons 2.VLDL 3. LDL 4. HDL with the following functions:

a. Good cholesterol

b. transports most of cholesterol to cells

c. carries triacylglycerols from intestines to fat cells

d. transports cholesterols to liver

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Complete the clean-pushing mechanism for the given ether synthesia from propanol in concentrated sulfurica140°C by adding any mining aloms, bands, charges, nonbonding electron pairs, and curved arrows. Draw hydrogen bonded to cayan, when applicable. ore 11,0 HPC Step 1: Draw curved arrows Step 2: Complete the intend carved Q2Q 56 QQQ Step 3: Complete the intermediate and add curved Step 4: Modify the structures to draw the QQQ QQQ

6. In an experiment the following replicate set of volume measurements (cm3) was recorded: (25.35, 25.80, 25.28, 25.50, 25.45, 25.43) A. Calculate the mean of the raw data. B. Using the rejection quotient (Q-test) reject any questionable results. C. Recalculate the mean and compare it with the value obtained in 2(a).

A student proposes the transformation below in one step of an organic synthesis. There may be one or more reactants missing from the left-hand side, but there are no products missing from the right-hand side. There may also be catalysts, small inorganic reagents, and other important reaction conditions missing from the arrow. • Is the student's transformation possible? If not, check the box under the drawing area. • If the student's transformation is possible, then complete the reaction by adding any missing reactants to the left-hand side, and adding required catalysts, inorganic reagents, or other important reaction conditions above and below the arrow. • You do not need to balance the reaction, but be sure every important organic reactant or product is shown. + T G OH де OH This transformation can't be done in one step.