The hardness of eutectoid steel, heated to 800 o C , quenched to 350 o C and held for 750 seconds needs to be explained. Concept Introduction: Material hardness is a property of the material due to which material resist the plastic deformation. Plastic deformation is a non-reversible change in the material after applying an external force. Hardness is the property of material which possess stiffness, resistance to bending, scratching or cutting. Hardness is not constant for fixed for all the material, but it depends upon strength and plasticity of metal. Material hardness is expressed in terms of Hardness number.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 12.88P

Interpretation Introduction

Interpretation:

The hardness of eutectoid steel, heated to 800oC, quenched to 350oC and held for 750 seconds needs to be explained.

Concept Introduction:

Material hardness is a property of the material due to which material resist the plastic deformation. Plastic deformation is a non-reversible change in the material after applying an external force. Hardness is the property of material which possess stiffness, resistance to bending, scratching or cutting. Hardness is not constant for fixed for all the material, but it depends upon strength and plasticity of metal. Material hardness is expressed in terms of Hardness number.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

The attached picture shows the RTCAPI memory mapped register which has the address 0x180. 1) Program the MCU's registers so that a) SIRC is the clock source b) the clock is divided by 16K c) the clock is enabled d) load is enabled

Write code to generate a PFM signal output to an output pin and then view it via an oscilloscope. The amplitude of the input signal should be changeable by pressing a button and the button presses should be counted via LEDs connected to the microcontroller. Specification: 1. When you start the program, nothing happens and all LED off. 2. When button pressed, use a starting frequency of 1kHz (and LED count 1) 3. With every new button pressed, frequency multiplies by 2 (i.e 2kHz, 4Khz, et.c) and the LED counts accordingly (i.e 2, 3, 4, …,7 and then go back to 0). 4. When the count is 7, it restarts from 0 again (meaning all LEDs are OFF and no signal at the oscilloscope) Recommended Steps: 1. Connect the Switch and the 3 LEDs 2. Connect the limiting resistors to the LED and the pull-up resistor to the switch (The resistor values will be determined in the lab) 3. Write the code to count the button presses (remember to debounce it if necessary) 4. Now generate the Pulses for each count.…

The device should boot up into the off state, that is, no LEDs are lit. On the depression of a switch on the development board, the first LED color should light and be steady. You you can use any LED colour combinations as you wish. On the depression of a switch a second time, the second LED color should flash with an on time of x msecs where the on duration is specified in the attached PDF and total cycle time of 1 second. The LED should remain flashing until the switch is depressed and the system returns to the off state and return to the start of the state transitions. This should form a cycle: off, steady, and then flashing. In addition, we are going to be storing variables in the EEPROM. You are to write into the EEPROM information so that when the board powers up again, the color of the lights are reversed. Steady should be the second color and flashing should be the first color given to you. Specifically, the 4 programs are as follows:…