Jörgen et al. Extracted acrylamide from potato chips by soxhlet extraction. They used methanol as a solyent for this and calculated the acrylamide yield in Gas Chromatography (GS-MS) by taking samples at certain day intervals. Accordingly, calculate the effect of the time parameter on the yield and the approximate % yield. 14000 12000 10000 8000 6000 4000 2000 50 100 150 200 250 Zaman (h) Acrylamide (ug/kg)

Jörgen et al. Extracted acrylamide from potato chips by soxhlet extraction. They used methanol as a solyent for this and calculated the acrylamide yield in Gas Chromatography (GS-MS) by taking samples at certain day intervals. Accordingly, calculate the effect of the time parameter on the yield and the approximate % yield. 14000 12000 10000 8000 6000 4000 2000 50 100 150 200 250 Zaman (h) Acrylamide (ug/kg)

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

The following data was obtained for an experiment on the gas chromatographic determination of toluene in an unknown sample using the internal standard method. Concentration (mass %) Toluene Peak Area Ethylbenzene Peak Area 0.50 0.539 1.970 1.00 1.150 2.051 2.00 2.174 2.018 3.00 3.308 2.009 unknown 1.382 2.015 a) Plot the calibration curve for this analysis and calculate the slope, y-intercept, and Pearson correlation coefficient. b) Find the % of toluene in the unknown.
Calculate the separation factor (or selectivity factor), between two compounds, 1 and 2, whose retention volumes are 6mL and 7mL, respectively. The dead volume of the column used is 1mL. Show that this factor is equal to the ratio of the distribution coefficients K2/K1 of these compounds tR(1)<tR(2).
A solution containing orange rind extract was analyzed using gas chromatography to measure its limonene content. The parameters used to analyze the standards and samples are listed below. Calculate the concentration of limonene in the solution in ug/mL
A simple paper chromatography experiment involved the analysis of the food dyes in lollipop samples. A chocolate-flavored lollipop was dissolved using various solvents and was spotted in the chromatogram (E). Four food dye standards (blue, green, red, and orange) were tested alongside the chocolate-flavored lollipop. The mobile phase used for the analysis was 0.1% NaCl. After the analysis, the resulting chromatogram revealed the separation of three colors, which were attributed to the food dyes indigo carmine (blue), tartrazine (yellow), and erythrosine (red). 10 Ruler is in cm unit в с B C D A E A E BEFORE AFTER Calculate the rf for each dye. Express answers in 3SF. erythrosine: indigocarmine: tartrazine: Which dye is the most polar? Choose.. Which dye is the least polar? Choose...
In order to improve the peptide separation by using a HPLC system, trifluoroacetic acid acts as mobile-phase modifier was added during the preparation of mobile phase. The preparation was performed by a postgraduate student as following:“2.851 g trifluoroacetic acid (MW: 114.02 g/mol) was made up to 500 cm3 in a graduated flask. To this solution, 50 cm3 of ethanol was added, and after mixing the mobile phase was placed in the solvent reservoir and pumping was commenced at 1.5 cm3 min-1.”Based on the given preparation procedure, identify THREE mistakes that were made.
Which of the following types of liquid chromatography uses immobilized biochemical as a stationary phase? affinity chromatography ion exchange chromatography gel permeation chromatography exclusion chromatography
The following statements are true for any chromatographic analysis except: The analyte component interacting most strongly with the stationary phase elute faster than those with weaker interactions. On the other hand, those with least interaction with the mobile phase elute the slowest. Interactions between mobile phase-analyte - stationary phase can be both chemical and physical in nature. Chromatography is a separation technique. Electromagnetic radiation source for XPS. Gamma ray X-ray UV-Visible Infra red Radiowave The part of SEM that is responsible for the production of electrons. * Electron guns Condenser lens Secondary detector Electron beam
A 20-cm long packed column was used to perform the separation of A and B by LC. TRA=16.28 min, TR,B=17.50 min, WA=1.11 min, WB=1.19 min, tм=1.30 min. (a) Calculate the retention factor (k') for A and B. (b) Calculate the average number of theoretical plates and plate height.
How much iron ore (that assays at 10.18% Fe) must be used in an analytical procedure that is known to have a low bias of −0.15 g if an overall relative error of 0.48 ppth in the iron content is desired?
Give the solution of question
Injection of ethane, propane, butane, pentane, and hexane on a squalene column under isothermal conditions gives retention times of 3.51, 4.98, 7.30, 11.00, and 16.85, respectively. Air, which is nonretained, elutes at 1.00 min. An injection of pyridine under the same conditions gives a retention time of 10.05 min. What is the Kováts retention index for pyridine under these conditions? O A. 334 O B. 300 O C. 485 O D. 478 O E. 370
How much iron ore (that assays at 16.54%16.54% Fe)Fe) must be used in an analytical procedure that is known to have a low bias of −0.15 g if an overall relative error of 2.26 ppth in the iron content is desired?