Ms. Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid chromatography using C-18 column with 10 cm long. She has observed that a chromatogram with compound elute in 9.0 min with W% = 2.0 min. Find the number of theoretical plate and plate height (in mm).

Ms. Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid chromatography using C-18 column with 10 cm long. She has observed that a chromatogram with compound elute in 9.0 min with W% = 2.0 min. Find the number of theoretical plate and plate height (in mm).

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter88: Column Chromatography

Section: Chapter Questions

Problem 6P

See similar textbooks

Related questions

Q: In molecular exclusion (size exclusion) chromatography, molecules have the the longest retention…

A: Molecular exclusion chromatography is base on size of molecules. It is a separation technique that…

Q: Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave…

Q: Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol by liquid…

A: LIQUID CHROMATOGRAPHY(LC): An analytical technique which is used to isolate a chemical sample into…

Q: explain what a response ratio is in Gas Chromatography and why it might be needed to quantify…

A: Gas chromatography (GC) is an analytical technique used to separate the chemical components of a…

Q: 4. On a 20 cm paper chromatography plate, an analyte was spotted 1 cm from the bottom edge. The…

Q: A student analyzes sample 1, and sample 2 chromatograms of a mixture containing two compounds (A +…

A: The two samples( Compound A+Compound B ) are undergone chromatography : Compound A and Compound B

Q: 4. The chromatogram below shows the separation of a mixture obtained by gas chromatography (GC)…

A: The principle of separation in gas chromatography (GC) is based on the partitioning of the sample…

Q: 23. An aqueous mixture of two substances are analysed by both paper chromatography and high…

A: Few questions based on general chemistry that are to be accomplished.

Q: what is chromatography? Explain different types of chromatography and explain how to seperate…

A: Chromatography is a laboratory technique. It is use for the separation of the components or solutes…

Q: A certain mixture contains the following compounds: propionic acid, 2-hexanol, isoamyl acetate, and…

Q: 6. Say you are trying to separate two compounds by column chromatography. You run a column and…

A: Column chromatography is a sub-class of liquid chromatography in which we have a solid as a…

Q: Swer sections C, D and E in the same answer book. ction D (Chromatography) The following data were…

A: N = 1757.286 K' = 9.285 RS = 1.578

Q: 6. A certain mixture contains the following compounds: propionic acid, 2-hexanol, isoamyl acetate,…

A: The components of a mixture in Normal liquid phase chromatography elute at different rates based on…

Q: Suppose that you try separating an unknown mixture by normal-phase chromatography with the solvent…

A: Whether to use a higher or lower percentage of hexane in the next run for the separation of an…

Q: A chromatogram gives an ideal Gaussian peak with tr = 8.70 min and win = 0.19 min. How many…

A: 1. The number of theoretical plates (N) = 11616 2. The plate height of the column (H) = 0.00938 mm

Q: Describe 4 similarities and 4 differences between Thin layer chromatography (TLC) and column…

A: The chromatography technique is used to isolate the components of mixtures that have two phases, one…

Q: True or False: Liquid-solid phase column chromatography is used to separate large up to multigram…

A: The above statement is true.

Q: A student places an unknown sample on a thin-layer chromatography plate and develops it in…

A: The important points in the question are: An unknown sample was placed on a thin-layer…

Q: A chemist was able to extract a biologically active compound and wants to purify the sample since he…

A: THIN LAYER CHROMATOGRAPHY: A chromatographic technique which is used to separate or purify the…

Q: All types of chromatography have mobile phaseand stationary phase. What is a stationary phase and a…

A: Stationary phase: It could be solid, or liquid supported on a solid layer or coating on the…

Q: Internal standard. A solution containing 3.47 mM X (analyte) and 1.72 mM S (standard) gave peak…

A: (a) Calculate the response factor for X: Response factor=Area of analyte peak/Concentration of…

Q: stationary phase and mobile phase

Q: Internal standard (As , Cs ), analyte with known concentration (Ax , Cx ) In a chromatographic…

A: Formula used: Area of analyte signalConc of analyte= F×Area of standard signalConc of…

Q: If retention times found on a chromatogram are 0.60 min for CH4 (=tm), 7.0 min for pentane, 8.0 min…

A: We use the formula below to find Kovat's retention index(I): Kovat's retention index, I = 100*n +…

Q: The table contains data for a liquid chromatography separation of four compounds, A, B, C, and D, on…

Q: Paper Chromatography and TLC are examples of planar chromatography. True or FalsE?

Q: 4. The paper chromatogram of an unknown mixture is shown below: final solvent level 5.3 cm 6.0 cm B…

Q: Qno1: why there is a need of chromatography and chromatography thecniqs. B) when and where we should…

Q: You are trying to separate a sample with 2 components: X and Y with GC. X has a lower boiling point…

A: Chromatography techniques are used to separate two r more compounds. The carrier gas is the mobile…

Q: 3. If we want to analyze Mg+2 ion, give an example of ion exchange resin carier, spacer and…

A: Ion-exchange chromatography is an important analytical technique where the ionic compounds are…

Q: The write-up says “A C18-silica column is used in this experiment, a 0.46 x 15 cm column with 5-µm…

A: Column dimensions: Particle size: Flow rate: Buffer concentration: 0.010 MBuffer pH: 7.2

Q: Which statement(s) are correct for gas chromatography? A) the components in a mixture can be…

A: To find, the true statement form the below, A) the components in a mixture can be identified from…

Q: Two components of a 12-mg sample are adequately separated by chromatography through a column 1.5 cm…

A: Given: 1) There are two components of a 12-mg sample = Small column mass 2) The column is 1.5 cm in…

Q: der the peaks for pentafluorobenzene and benzene in the gas chromatogram shown here. The elution…

A: Given data: Elution time for unretained solute = 1.06 min Length of column = 30 m Diameter of column…

Q: A young researcher set out to develop a method for quantifying the polycyclic aromatic hydrocarbon…

A: In order to get resolution in GC there are three things you need. Right capacity factor…

Question

(6)
Ms. Muna Al Naabi in the Analytical chemistry laboratory wanted to separate chlorophenol
by liquid chromatography using C-18 column with 10 cm long. She has observed that a
chromatogram with compound elute in 9.0 min with W½ = 2.0 min. Find the number of
theoretical plate and plate height (in mm).

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The same polar compound is gas chromatographed on an SE-30 (very nonpolar) column and then on a Carbowax 20M (very polar column). I low will K=cS/cM vary between the two columns?
a. Separation of Peaks Below are two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used? HPLC: 15% H₂O, 85% CHCN, CIS Revane Phase, 100 mm long, 5pm particles (1) Area (1)-14750 Arta (2)-53538 MIN HPLC: 59% 10,49% CHCN, CIS Reverse Phase, 100 m long, 5 pm particles (2) Mes (1)-2256 A(2)-9536 A(3)-25638 13H
What are the mechanisms of samples separation work in Thin layer Chromatography? Please shortly answer at your own words. Answer should be to the point (specific 4-5 lines).
9
(vi) Complete the following statementComponent A spends ___ times as much time on the stationary phase as in the mobile phase;component B spends ___ times as much time on the stationary phase as in the mobile phase.
The options are larger or smaller.
A young researcher set out to develop a method for quantifying the polycyclic aromatic hydrocarbon (PAH) content in a contaminated soil sample using open tubular gas chromatography. During the initial stages of method development, the researcher was unable to separate the early eluting compounds, anthracene and naphthalene, with baseline resolution. Select the possible modifications the researcher could make to improve the resolution. use a column with a smaller inner diameter decrease the column length increase the stationary phase thickness increase the temperature choose a different stationary phase
The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds labeled A and B. The separation employed a 2.50 meter packed column under isothermal conditions (90 °C) and a flow rate of 10 mL/min. (a) Detector Signal 300.0 250.0 200.0 150.0 100.0 50.0 0.0 1.0 1.1 Unretained 1.2 1.5 time (min) Find the retention times for A and B. 1.7 O
A student places an unknown sample on a thin-layer chromatography plate and develops it in dichloromethane as a solvent. Only one spot whose Rf is 0.98 is observed. Does this result indicate that the unknown material is a pure compound? If not a pure compound, suggest an alternate procedure to verify the purity of the sample.
two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used?
1 24) The method of internal standard was used to analyze and measure the concentration of chemical X by GC A known mixture of compounds X and Y (internal standard) gave the following chromatographic results: Compound X Y Concentration (M) 6.3 x 10-8 2.0 x 10-7 a) 2.0 x 10-6 M b) 8.4 x 10-7 M c) 6.6 x 10-7 M d) 4.1 x 10-7 M e) 2.9 x 10-7 M Peak Area 395 787 Then, an unknown was analyzed as follows. 3.0 mL of unknown X was treated with 0.100 mL of 1.6 x 10-5 M Y and the mixture diluted to 10.0 mL final volume. Peak areas were 633 (for X) and 520 (for Y). What is the concentration of X in the unknown. (The original 3.00 sample?)
The figure below shows a portion of a GC chromatogram for a mixture of two aromatic compounds labeled A and B. The separation employed a 2.50 meter packed column under isothermal conditions (90 °C) and a flow rate of 10 mL/min. (d) Detector Signal 300.0 250.0 200.0 150.0 100.0 50.0 0.0 1.0 1.1 Unretained 1.2 1.3 1.4 1.5 time (min) 1.5 Calculate the selectivity factor for the separation of A and B. 1.0