Determine the maximum discharge obtainable in a 0.4 m diameter commercial ste that carries water from a mountain reservoir to a hydroelectric power plant. The penstock entrance is squared-edge entrance. It is 2500 m long, contains a bend and a globe valve, and discharges water into a tailwater as shown in Figure 3. VElevation 150m Water (20°C) K=0.20 Penstock Elevation 100m Elevation 50m Turbine at Elevation 55 m Elevation 47m Figure 3. Profile view of a hydroclectric seheme Tailwater

Q: The spiral conical draft tube are connected to Francis turbine. The diameters of the internal and…

A:

Q: ... 600mm water diameter 300mm 1. diameter 150mm Mercury (SG = 13.6) %3D A venturi meter with…

A: A Venturi meter is a device used for measuring the rate of flow of a fluid flowing through a pipe.…

Q: The flow rate through a 10-cm-diameter wrought iron pipe shown below is 0.04 m³/s. Find the…

A:

Q: EB, Fluid Transport. Water is pumped from a reservoir to top of the mountain through a 1800m long…

A: Given:Lenght of the pipe, L=1800 mPipe=6 inch schedule 120 pipeAverage velocity of fluid, v=5…

Q: 3. Determine the flow rate of water, in m3/s, at 5 C though the piping system as shown in the…

A:

Q: 0.60 m lighest water level Lowest water level 21.0 m 1.5 m 672.00 m E Dacil + Water will be…

A: Q=3790  LminQ=3790×10-360Q=.0631 m3secVs=1.5 msec,vb=3…

Q: the flow rate in each pipe (+ is out and - is into the reservoir) Assume hA = 60 m, hg = 90 m, hc =…

A: To given…

Q: A reducing elbow as shown in Figure 5.1 is used to turn water flow at a rate of 0.4 m/s in a…

A:

Q: (a) Two vertical cylindrical tanks of 3.00- meter and 2.00-meter diameter containing water are…

A:

Q: 1. A 10-cm-diameter siphon tube is used to empty the reservoir and discharge it into the air (Figure…

A:

Q: Elevation = ? reservoir on the right at a rate of 0.45 m/s. The formula for the head losses in the…

A:

Q: Head losses in pipe: 1 to 2: 3.00 m 2 to 3: 9.00 m 3 to 4: 18.00 m 4 to 5: 6.00 m W.S. |ELEV. 140…

A: Given diameter of pipe = 6 in Diameter of jet = 2 in Nozzle loss = 8 % of velocity head

Q: A long 1.5 km pipeline with size of 300 mm laid between two reservouirs having difference in surface…

A: From the Darcy Weisbach equation  hf=fLQ212.1 d5

Q: Water flows through a Venturi as shown in the figure at a flow rate of 5.4x10 m /s. What is the…

A:

Q: A channel of width 450 mm branches into two sub- channels having width 300 mm and 200 mm as shown in…

A: Given data: The width of the upper sub channel is W1 = 300 mm. The width of the lower sub channel…

Q: Q.1 A horizontal tube of 60 m lenght is connected to a water vessel at one end discharges freely…

A: Given: Total length of pipe= 60 m Length of 1st pipe, L1= 35 m Diameter of the 1st pipe, d1= 0.12 m…

Q: peton with a relative density of 0.78 flows upward in a vertical venturimeter having a discharge…

A:

Q: A straight pipe has a daimater of 25 mm, a roughness height of 0.1 mm, and is inclined upward at and…

A: Write the properties of water at 10°C. Draw the diagram of the pipe. From the diagram,

Q: A reciprocating pump running at 1 rps and discharges oil (p = 850 kg/m3) at a rate of 366.1 gpm. The…

A: Given:Pump speed, N=1 rpsDensity of oil, ρ=850 kg/m3Oil flow rate, Qact=366.1 gpmBore, D=250 mm=0.25…

Q: Determine the TDH for the system shown below taking into account that the discharge in

A: Given:

Q: Water stored in reservoir to a depth of 2 m above the entrance of pipe a 20 cm diameter pipe…

A: We have given data from the question: h=2 m, d=20 cm=0.1 m L=80 m Slope=1 in 100,  f=0.017

Q: A 500m pipeline of diameter 15 cm connects the two tanks having difference of 15m in their water…

A: For solution refer below images.

Q: Water flows naturally from a tank A located at 20 m above the ground level , to a ground level tank…

A: Given data as per the question Height =20 m  Equialent loss coefficient =k we know thatAcording to…

Q: An engineer is making an estimate for a home owner. This owner has a small stream (Q = 0.05 m³/s)…

A: The given information in the problem is listed in the following attached image:

Q: 200mm ● diameter 400mm diameter 1 Mercury (SG = 13.6) Water In the 200mm diameter vertical venturi…

A:

Q: (b) The throat and full bore diameters of a venturi meter are 18mm and 55mm, respectively. The…

A: To find: The theoretical discharge through the venturi meter. Given: The throat diameter of a…

Q: EB, Pump System. Water is extracted from a reservoir, pumped up and over an obstruction, and…

A: Given: h=2mL=20 mA=0.05 m2Q=0.5 m3/sη=0.8 To Find: a) Input pump power b)∆P across pump and exit…

Q: Two identical pumps are connected in series and deliver water through an 45cm diameter, 2.2km long,…

A: Given:

Q: For the branching pipe system given below, determine the flow to and the elevation of the third…

A: The friction factor for all the pipes is .The flow from reservoir to junction  is .The flow from…

Q: What is the exit point elevation of the 1.5-m-diameter steel pipe (e discharges water into the upper…

A:

Q: KL elbow = 1.5 maib Filter exit KL valve = 6.0 KL filter = 12.0 KL ent = 0.8 200 ft. of…

A: The flow rate of the pipe is  diameter of the pipe length of the pipe

Q: Water (viscosity of 0.001 kg/m.s and density of 1000 kg/m ) is to be pumped through 50 m of pipe…

A: for solution refer below images.

Q: Q4 Water flows from a large reservoir to a smaller one through a 5cm diameter cast iron piping…

A: Given data as per the question Diameter of the pipe =5cm =0.05 m Flow rate =5L/s Dynamic viscosity…

Q: The flow rate through a 10-cm-diameter wrought iron pipe shown below is 0.04 m³/s. Find the…

A: Given data: d=10 cmQ=0.04 m3/s Need to determine the difference in elevation (H).

Q: What power can be delivered by the turbine if its efficiency is 100%? The water flow rate is 0.01…

A: in real world no equipment is 100 % efficient , turbines having an efficiency upto 95% is pretty…

Q: The flow rate of the system is 1 cubic meter per second. Determine the major and minor losses of the…

A: The flow rate of the system, Q=1 m3/s=35.3147 ft3/s                                       1…

Q: HW. 2) An inclined rectangular gate AB (1.2 m height and 3.5 m width) is installed to control the…

A:

Q: Water is flowing in a conical tube. the inlet conditions are D=100mm, v=1m/s & density = 1000kg/m3.…

A: