A long 1.5 km pipeline with size of 300 mm laid between two reservouirs having difference in surface elevation of 24 m carries a maximum flowrate of 0.15m/s. A 600 m parallel pipe of the same size and friction factor is looped beside this one and connected to it as shown in figure, What is the expected increase in maxmum flowrate.

Q: water at 20°C is pumped through a smooth 12-cm-diameter pipe 10 km long, at a flow rate of 75 m3/h.…

A:

Q: Water at 20°C is transported from Tank 1 to Tank 2 at a rate of 0.5m 3 /s via a copper pipe of…

A:

Q: Two identical pumps are connected in series and deliver water through an 45cm diameter, 2.2km long,…

A: Given:

Q: Water at 40 °C is pumped from an open tank through 200 m of 50-mm-diameter smooth horizontal pipe as…

A: The pressure encountered by a fluid on the suction side of a centrifugal pump is measured by NPSH,…

Q: Two 32-in pumps from Fig.  are to be used in seriesat 1170 r/min to lift water through 500 ft of…

A: Reynold's number Re = 4 ρ Q / π µ d Q = 44.56 ft3 / s d = 16 ft µ = 0.0000209 slug / ft-sec Re = 4 *…

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.