Two identical pumps are connected in series and deliver water through an 45cm diameter, 2.2km long, commercial steel pipe from reservoir A (surface elevation = 50m) to reservoir B (surface elevation = 100m). Consider minor losses of a square-edged inlet, exit, and swing-type check valve. Determine the discharge, the total head added by the pumps, and the total power output. The pump characteristics for a single pump is tabulated below. Assume that the kinematic viscosity is 1x10-6 m 2 /s and a specific weight of 9.79kN/m 3 . Plot the system and pump characteristic curves on a single plot. Be sure to label the axes appropriately (i.e., include units). Be sure to include a legend to demark the system head curve and the pump characteristic curve.

Q: The machine in the following figure acts as a turbine during daytime to produce electricity and as a…

A:

Q: 1 QUESTION 1 Consider a desired pump operating condition which adds 35 psi at a flowrate of 500 gpm…

A: Given data  Flow rate = 500 gpm Pressure = 35 psi Density = 62 lbm/ft^3 Find the pump head

Q: Consider a desired pump operating condition which adds 35 psi at a flow rate of 500 gpa to water.…

A: Given data  Pressure = 35 psi Flow rate = 500 gpm Density of water = 62 lbs/ft^3 Find the pump head…

Q: 2. Water at 50°F is pumped from pond 1 to pond 2. Calculate the volumetric flow rate and pump power…

A:

Q: A pump delivers water at a temperature of 20 °C from one reservoir to another high reservoir. The…

A:

Q: Water at 20°C is to be pumped from Reservoir 1 to Reservoir 2 at a rate of 3 m³/min through a 2000 m…

A:

Q: (b) Two reservoirs are connected by a pipeline consisting of pipe 1, pipe 2, pipe 3 connected in…

A: Given: Length of the pipe 1→L1=170 m Length of the pipe 2→L2=300 m Length of the pipe 3→L3=210 m…

Q: Water at 20°C is transported from Tank 1 to Tank 2 at a rate of 0.5m 3 /s via a copper pipe of…

A:

Q: At a potential hydroelectric site, the average gross head is 73m. It has 9m width and depth of 15m…

A:

Q: KL elbow = 1.5 maib Filter exit KL valve = 6.0 KL filter = 12.0 KL ent = 0.8 200 ft. of…

A: The flow rate of the pipe is  diameter of the pipe length of the pipe

Q: Consider a positive displacement pump; Shaft speed is 1800rpm Pump push 0.003gal/revolution Leakage…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.