Answered: density

Science

Chemistry

density

Principles of Instrumental Analysis

7th Edition

ISBN:9781305577213

Author:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Publisher:Douglas A. Skoog, F. James Holler, Stanley R. Crouch

Chapter27: Gas Chromatography

Section: Chapter Questions

Problem 27.16QAP

See similar textbooks

Related questions

Q: MS: m/z=148 (M,100%),149 (11%) IR (liquid film): 3077‐2835 (multitude of weak peaks)…

A: The IR peaks observed are as shown below:IR (liquid film): 3077‐2835 (multitude of weak peaks),…

Q: I need to come up with a protocol of uv-vis spectrophotometer to detect water and chlorine-carbon.…

A: protocol for using a UV-Vis spectrophotometer to detect water and chlorine-carbon would typically…

Q: Cu Absorbance 1 Absorbance 2 Absorbance 3 Mean + SD standard (ppm) 0.0522 0.1013 1 0.0521 0.0520…

A: To determine the concentration of metal in unknown sample, we must first plot the mean absorbance (y…

Q: A 5.3 × 10-2 M solution is to be used to prepare a series of five 100 mL solutions of varying…

A: So basically, we are diluting the 5.3 X 10-2 M solution, every time taking 10 mL of it. As per the…

Q: The following volumes of a solution containing 1.10 ppm Zn2+ were pipetted into separatory funnels…

Q: A spectrophotometer method for the quantitative analysis of Pb2+ in blood uses Cu2+ as an internal…

A: given : SASIS = 0.8320.351= 2.37 CA = concentration of analyte = 1.75 CIS = concentration of…

Q: An absorbing solution transmits just 38 of every 140 photons to the detector. If the cell width was…

A: We have to calculate the molar absorptivity of the given solution.

Q: A mixture of four components (W-Z) was chromatographed on a silica gel column; 11 fractions were…

A: Here TlC plates is given and we have to find out with fraction should combined to get pure sample of…

Q: Consider a separation performed on a 50.0 mm long open tubular column with a 0.50 mm diameter and a…

A: Given , Length of column = 50.0 mmcolumn diameter, d= 0.5 mmthickness =2.0 μmCompound A eluted at…

Q: Mass spectral measurements were made on 10 replicate low concentration Cd-EDTA samples: 181.5,…

Q: For determining the %w/w of salicylamide and caffeine in an unknown sample using acetaminophen as an…

A: The objective of this question is to show the choice of wavelength in HPLC analysis should be based…

Q: A molecular exclusion column has a diameter of 7.8 mm and a length of 30 cm. The solid portion of…

A: (a)

Q: Scientists determined the %w/w H20 in methanol by GC, using a capillary column coated with a…

A: Answer: It is the equation of a straight line. To find out the value of x, we have to put the…

Q: Bradford assay was used to determine bovine serum albumin (BSA) concentrations. The method works by…

A: The above question pertains to the Bradford assay, a widely used method for determining protein…

Q: A solution containing 3.51 mM X (analyte) and 1.67 mM S (internal standard) gave peak areas of 3505…

A: Given : Solution containing 3.51 mM X(analyte) & 1.67 mM S(internal standard) gave…

Q: state/hexane, the sample showed a single spot at 3.4 cm (relative to vent had risen to 7.1 cm…

A: TLC ( thin layer chromatography) is the technique used in chemistry laboratories to identify the…

Q: A series of eight absorbance measurements using an atomic absorption spectrophotometer are as…

A: Given,

Q: 1. A mixture containing 0.500 mM chloroform and 0.800 mM DDT gave signals of 15.3 UA for chloroform…

Q: An atomic absorption method for the determination of the amount of iron present in used jet engine…

A: Solutions- a standard deviation s = 3.1 µg Fe/mL. calculate the 95 and 99% confidence intervals…

Concept explainers

Matter and Measurement

In the universe, there is matter, energy, and void space. The universe contains energy and void space. The definition of matter can be considered as something which possesses mass and consumes space. Chemistry is that branch of science which deals with the study of matter. Under chemistry, nature, composition, and the changes occurring to matter are discussed.

Question

A culture for spectrophotometric analysis was diluted 10-fold, then yielded the following readings: 0.24, 0.35, 0.67, 0.89. What is the average optical density of the culture?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

A mixture of three components is separated using paper chromatography, and each component is analyzed using absorption. With standards containing 100 ppm of each component run simultaneously, the following data were obtained: cmpd A, 0.72 absorbance; B, 0.55; C, 0.80. For the unknown mixture, the data obtined when run under identical conditions were as follows: cmpd A, 0.15 absorbance, B, 0.84; C, 0.75. a) Calculate the relative percentage composition of the unknown mixture. b) The distances traveled by the three components were 8.5, 6.3, and 5.5 cm, respectively. Sketch the appearance of the paper chromatogram. Label each spot. c) Calculate the Rf values if the solvent front is 18 cm.
A spectrophotometric method for the quantitative determination of the concentration ofPb2+ in blood yields an Ssamp of 0.133 for a 1 mL sample of blood that has been diluted to 6 mL. A second sample is spiked with 1 µL of a 1467 ppb Pb2+ standard and diluted to 6 mL, yielding an Sspike of 0.491. Determine the concentration of Pb2+ in the original sample of blood.
Six 10.00 mL samples of raw milk were treated with 0, 5.00, 10.00, 15.00, 20.00, and 25.00 µg of zinc ion and diluted to 50.00 mall The absorbances of these solutions were 0.235, 0.292, 0.346, 0.397, 0.458 and 0.510. a) Identify the calibration method used. (Standard Addition, Internal Standard, or External Standard?) b) Calculate the ppm Zn in the sample of milk.
A student researcher performed a chromatographic separation of caffeine and aspartame. The retention time for caffeine, te, was found to be 200.8 s with a baseline peak width, we, of 16.1 s. The retention time for aspartame, ta, was 258.7 s with a baseline peak width, wa, of 20.6 s. The retention time for the unretained solvent methanol was 44.2 s. Calculate the average plate height, H, in micrometers for this separation, given that it was performed on a 22.1 cm long column. H = Calculate the resolution, R, for this separation using the widths of the peaks. R = 88.2 R₂5N = 3.16 Calculate the resolution if the number of theoretical plates were to increase by a factor of 2.5. 3.533 Incorrect μm
Chloroform is an internal standard in the determination of the pesticide DDT in a polarographic analysis in which each compound is reduced at an electrode surface. A mixture containing 0.500 mM chloroform and 0.800 mM DDT gave signals of 15.3 µA for chloroform and 10.1 µA for DDT. An unknown solution (10.00 mL) containing DDT was placed in a 100-ml volumetric flask and 10.2 µl of chloroform (MW = 119.39, density = 1.484 g/mL) were added. After dilution to the mark with solvent, polarographic signals of 29.4 and 8.7 HA were observed for the chloroform and DDT, respectively. Find the concentration of DDT in the unknown. Dichlorodiphenyltrichloroethane (DDT) ÇI CI
The standard curve of a biuret assay gave the equation: y=0.4193x. The absorbance for Unknown A = 0.098 and Unknown B = 0.325. Are you equally confident in the accuracy of the protein %D concentrations you would calculate for samples Unknown A and Unknown B? Briefly explain your answer.
13. Electrospray time-of-flight mass spectrometry was used to analyze the eluate from a high-performance liquid chromatography separation. The mass spectrum of one chromatographic peak, containing a protein of unknown molecular mass, displays MH peaks at m/z = 5 654.208, 5 277.326, 4 947.590, 4 656.613, 4 397.990, and 4 166.576. Find the average molecular mass (M) of the neutral protein and its standard deviation.
In spectrophotometric analysis, the relationship between the absorbance A and the analyte's concentration C is: A = ebC + Ablank What is the molar extinction coefficient I and its absolute uncertainty if A is 0.68 ± 0.06; Ablank is 0.06 ± 0.01; b is 1.00 cm; and C is (0.45 ± 0.03)x10-5 mol/L?
Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave chromatographic peak areas of 306 for X and 511 for S. A second solution containing an unknown quantity of X plus 55.5 mM S had peak areas of 251 for X and 563 for S. Find [X] in the second solution.
The following results were obtained for the determination of calcium in a NIST limestone sample: %CaO = 50.33, 50.22, 50.36, 50.21, and 50.44. Five gross samples were then obtained for a carload of limestone. The average %CaO values for the gross samples were found to be 49.53, 50.12, 49.60, 49.87, and 50.49. Calculate the relative standard deviation associated with the sampling step
The following results were obtained for the determination of calcium in a NIST limestone sample: % CaO = 50.32, 50.22, 50.40, 50.21, and 50.44. Five gross samples were then obtained for a carload of limestone. The average percent CaO values for the gross samples were found to be 49.47, 50.10, 49.58, 49.76, and 50.49. Calculate the relative standard deviation associated with the sampling step. Relative standard deviation =
With the following information for a GC analysis using an internal standard, calculate the percentage of alcohol in the sample. The 1% ethanol standard sample has an ethanol peak area of 711 and a 1-propanol peak area of 9253; 3% is 3536 and 14432 for ethanol and 1-propanol respectively; 5% is 3506 and 10693; 7% is 5874 and 10847 and 9% is 5203 and 7522. The beer sample has an ethanol peak area of 5471 and 1-propanol of 14384. 4.95% 5.15% 5.05% 5.25%