Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave chromatographic peak areas of 306 for X and 511 for S. A second solution containing an unknown quantity of X plus 55.5 mM S had peak areas of 251 for X and 563 for S. Find [X] in the second solution.

Internal standard. A mixture containing 12.8 mM analyte (X) and 44.4 mM standard (S) gave chromatographic peak areas of 306 for X and 511 for S. A second solution containing an unknown quantity of X plus 55.5 mM S had peak areas of 251 for X and 563 for S. Find [X] in the second solution.

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter34: Miscellaneous Separation Methods

Section: Chapter Questions

Problem 34.1QAP

See similar textbooks

Similar questions

Internal standard. A solution containing 3.47 mM X (analyte) and 1.72 mM S (standard) gave peak areas of 3 473 and 10 222, respectively, in a chromatographic analysis. Then 1.00 mL of 8.47 mM S was added to 5.00 mL of unknown X, and the mixed solution was diluted to 10.0 mL. This solution gave peak areas of 5 428 and 4 431 for X and S, respectively. (a) Find the response factor for X relative to S in Equation 5-9. (b) Find [S] (mM) in the 10.0 mL of mixed solution. (c) Find [X] (mM) in the 10.0 mL of mixed solution.(d) Find [X] in the original unknown.
Internal standard (As , Cs ), analyte with known concentration (Ax , Cx ) In a chromatographic equipment, a solution containing 0.006727 X and 0.008331 M S give peak area of Ax= 2316 and As= 207. To analyze an unknown sample, 5.0mL of 0.008331M S was added to 5.0mL of X, and the mixture was diluted to 50.0mL. This mixture gave a chromatography spectrum with area Ax= 3206 and As= 200. Find Cx.
A solution with 0.083 7 M X and 0.050 0 M S9 gave areas AX = 423 and AS9 = 372. Then 10.0 mL of 0.05 0 M S9 plus 10.0 mL of unknown were diluted to 25.0 mL. The chromatogram gave AX = 553 and AS9 = 286. Find [X] in the unknown.
Give answer all questions with explanation
A solution containing 2.30 mM of X (analyte) and 1.15 mM of S (standard) gave peak areas of 1728 and 6482, respectively, in a chromatographic analysis. Then, O.620 mL of 3.82 mM S was added to 2.75 mL of unknown X and the mixture was diluted to 10.0 mL. This solution gave peak areas 2501 and 2281 for X and S, respectively. Find the concentration of X in the original unknown.
a. Separation of Peaks Below are two chromatograms after LC separation. Which chromatogram is better to proceed for MS analysis? What mobile phase condition/composition (LC separation) was used? HPLC: 15% H₂O, 85% CHCN, CIS Revane Phase, 100 mm long, 5pm particles (1) Area (1)-14750 Arta (2)-53538 MIN HPLC: 59% 10,49% CHCN, CIS Reverse Phase, 100 m long, 5 pm particles (2) Mes (1)-2256 A(2)-9536 A(3)-25638 13H
Two components of a 12-mg sample are adequately separated by chromatography through a column 1.5 cm in diameter and 25 cm long at a flow rate of 0.8 mL/min. What size column and what flow rate should be used to obtain similar separation with a 250-mg sample?
A solution containing 3.47 mM of copper and 1.73 mM of a standard gave peak areas of 3473 and 10 222, respectively in a chromatographic separation. Calculate the response factor.
A standard solution containing 6.3 x 10-8 M iodoacetone and 2.0 x 10-7 M p-dichlorobenzene (an internal standard) gave peak areas of 395 and 787, respectively, in a gas chromatogram. A 3 mL unknown solution of iodoacetone was treated with 0.100 mL of 1.6 x 10-5 M p-dichlorobenzene and the mixture was diluted to 10 mL. Gas chromatography gave peak areas of 633 and 520 for iodoacetone and p-dichlorobenzene respectively. Find the concentration of the iodoacetone in the 3 mL of original unknown.
1a) Hexane, CH3(CH2)4CH3, is found to have a long retention time when separated from a mixture. A column with a C18 (18-carbon chain) stationary phase and a methanol-water modal phase is used for the separation. Explain why hexane has a long retention time. 1b)You wish to chromatographically seperate a mixtureof the follwing compunds. Which of the two compounds will be most difficult to seperatate from one another? Why?
A student researcher performed a chromatographic separation of caffeine and aspartame. The retention time for caffeine, tc, was found to be 209.6 s with a baseline peak width, w., of 14.4 s. The retention time for aspartame, ta, was 260.0 s with a baseline peak width, wa, of 21.2 s. The retention time for the unretained solvent methanol was 49.2 s. Calculate the average plate height, H, in micrometers for this separation, given that it was performed on a 22.1 cm long column. H = um %3D Calculate the resolution, R, for this separation using the widths of the peaks. R = Calculate the resolution if the number of theoretical plates were to increase by a factor of 2. R2N =
Q1: The following are relative peak areas for chromatograms of standard solutions of methyl vinyl ketone (MVK) MVK concentration mmol/L 0.5 Relative peak area 3.76 1.5 9.16 2.5 15.03 3.5 20.42 4.5 25.33 5.5 31.97 A sample containing MVK yielded relative peak area of 21.3. Calculate the concentration of MVK in the sample.(use excel)