A simply supported rectangular beam of length 6.45m has a width of 437.5 and an effective depth of 692.5. The beam is to be reinforced using 12 ?? bars. The beam supports service dead loads of 31 kN/m and 39.5kN/m., respectively.  1. Calculate the ultimate moment capacity of the beam. 2. Calculate the height of the equivalent stress block. 3. Determine the number of bars required for this beam

Q: 2 loads P acts at right angles to one another at the free end of a cantilever beam having square d x…

A: Cantilever Beam is a type of beam in which 9ne end is fixed and the another end is free. As per the…

Q: 10. Calculate the normal stresses at points A, B, C and D (at section A'A') for the beam shown…

A: To find out the normal stress at point A, B, C and D.

Q: A 3 m B W 50 mm 3 m- 100 mm - Change the height of the cross section from 100 mm to 68.70 mm the…

A: Height of cross section = (5068.7) mmFind:(a) Maximum shear stress in the beam(b) Maximum bending…

Q: The beam shown has a rectangular cross section with a depth h = 240 mm. Determine the width b of the…

A: It is required to find the width of the beam.

Q: Consider a circular beam 8 m long and 600 mm in diameter subjected to uniformly distributed load of…

A: For given circular beam,Length,L= 8 mDiameter, D= 600 mmLoading, 30 kN/m uniformly distributed load

Q: Cross section below is under a Moment as shown in the a. Normal stress at B b. Normal stress at D B…

A:

Q: 6 kip 1 ft 1 ft 3 kip 1 ft

A: Height= 6 in  Width= 3 in

Q: Design the beam using IPE shape.

A: Since you have mentioned designing the beam using the IPE section, subpart 5 is solved below: Given:…

Q: Determine the normal stress on the a-a plane. 45 MPa a 30° (а) -7.14 МРа (b) 7.14 МPа (c) -62.2 MPa…

A: Solution:- Given information: σx=-25 MPa,  σy=45 MPaτxy=40 MPaθ=90°-30°=60° Therefore the normal…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.