Concept explainers
(a)
Interpretation:
Among the
Concept Introduction:
Graham’s law of effusion:
Graham’s law of effusion states that “at constant temperature and pressure, the rate of effusion of gas molecule from a particular hole is inversely proportional to the square root of the molecular weight of the gas” and is given as,
Where,
(b)
Interpretation:
Among the
The experimental change needed to be done for reaching the end of long tube by
Concept Introduction:
Graham’s law of effusion:
Graham’s law of effusion states that “at constant temperature and pressure, the rate of effusion of gas molecule from a particular hole is inversely proportional to the square root of the molecular weight of the gas” and is given as,
Where,
Want to see the full answer?
Check out a sample textbook solutionChapter 5 Solutions
General Chemistry - Standalone book (MindTap Course List)
- When calcium carbonate is heated strongly, it evolves carbon dioxide gas. CaCO3(s)CaO(s)+CO2(g) 25 g of CaCO3 is heated, what mass of CO2would be produced? What volume would this quantity of CO2 (CU at STP?arrow_forwardA student prepares phosphorous acid, H3PO3, by reacting solid phosphorus triiodide with water. PI3(s)+3H2O(l)H3PO3(s)+3HI(g) The student needs to obtain 0.250 L of H3PO3(d=1.651g/cm3). The procedure calls for a 45.0% excess of water and a yield of 75.0%. How much phosphorus triiodide should be weighed out? What volume of water (d=1.651g/cm3) should be used?arrow_forwardPyruvic acid, HC3H3O3, is involved in cell metabolism. It can be assayed for (that is, the amount of it determined) by using a yeast enzyme. The enzyme makes the following reaction go to completion: HC3H3O3(aq)C2H4O(aq)+CO2(g) If a sample containing pyruvic acid gives 21.2 mL of carbon dioxide gas, CO2, at 349 mmHg and 30C, how many grams of pyruvic acid are there in the sample?arrow_forward
- Silane, SiH4, is the silicon analogue of methane, CH4. It is prepared industrially according to the following equations: Si(s)+3HC1(g)HSiCl3(l)+H2(g)4HSiCl3(l)SiH4(g)+3SiCl4(l) a. If 156 mL HSiCl3 (d = 1.34 g/mL) is isolated when 15.0 L HC1 at 10.0 atm and 35C is used, what is the percent yield of HSiCl3? b. When 156 mL HSiCl3 is heated, what volume of SiH4 at 10.0 atm and 35C will be obtained if the percent yield of the reaction is 93.1%?arrow_forwardWhat does “STP’ stand for? What conditions correspond to STP? What is the volume occupied by one mole of an ideal gas at STParrow_forwardYou have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.arrow_forward
- Analyze When nitroglycerin (C3H5N3O9) explodes, itdecomposes into the following gases: CO2 , N2 , NO, and H2O . If 239 g of nitroglycerin explodes, what volumewill the mixture of gaseous products occupy at 1.00 atmpressure and 2678°C?arrow_forward62 Ammonium dinitramide (ADN), NH4N(NO2)2, was considered as a possible replacement for aluminium chloride as the oxidizer in the solid fuel booster rockets used to launch the space shuttle. When detonated by a spark, AND rapidly decomposes to produce a gaseous mixture of N2,O2, and H2O. (This is not a combustion reaction. The ADN is the only reactant.) The reaction releases a lot of heat, so the gases are initially formed at high temperature and pressure. The thrust of the rocket results mainly from the expansion of this gas mixture. Suppose a 2.3-kg sample of ADN is denoted and decomposes completely to give N2,O2, and H2O. If the resulting gas mixture expands until it reaches a temperature of 100°C and a pressure of 1.00 atm, what volume will it occupy? Is your answer consistent with the proposed use of ADN as a rocket fuel?arrow_forwardHow would the graph in Figure 9.12 change if the number of moles of gas in the sample used to determine the curve were doubled?arrow_forward
- What volume (in liters) of O2, measured at standard temperature and pressure, is required to oxidize 0.400 mol of phosphorus (P4)? P4(s) + 5 O2(g) P4O10(s)arrow_forwardA mixture contained zinc sulfide, ZnS, and lead sulfide, PbS. A sample of the mixture weighing 6.12 g was reacted with an excess of hydrochloric acid. The reactions are ZnS(s)+2HCL(aq)ZnCl2(aq)+H2S(g)PbS(s)+2HCL(aq)PbCl2(aq)+H2S(g) If the sample reacted completely and produced 1.049 L of hydrogen sulfide, H2S, at 23C and 762 mmHg, what were the percentages of ZnS and PbS in the mixture?arrow_forward
- ChemistryChemistryISBN:9781305957404Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCostePublisher:Cengage LearningChemistry: An Atoms First ApproachChemistryISBN:9781305079243Author:Steven S. Zumdahl, Susan A. ZumdahlPublisher:Cengage Learning
- Chemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningChemistry for Engineering StudentsChemistryISBN:9781337398909Author:Lawrence S. Brown, Tom HolmePublisher:Cengage LearningIntroductory Chemistry: A FoundationChemistryISBN:9781337399425Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage Learning