FIGURE P5.49 Problems 49 and 50.
Suppose the system of blocks in Problem 49 is initially held motionless and, when released, begins to accelerate. a. If m1 = 7.00 kg, m2 = 2.00 kg, and the magnitude of the acceleration of the blocks is 0.134 m /s2, find the magnitude of the kinetic frictional force between the second block and the ledge. b. What is the value of the coefficient of kinetic friction between the block and the ledge?
(a)
What is the kinetic friction force between the second block and ledge?
Answer to Problem 50PQ
The kinetic friction force between the second block and ledge is
Explanation of Solution
The free body diagram is given below.
Applying Newton’s laws.
Here,
Here,
Write the equation for gravitational force.
Here,
Conclusion:
Using equation III find the gravitational force on each object.
From the free body diagram the find the value of
Substitute the above values and
Substitute above values in equation II to get friction force.
Therefore, the kinetic friction force between the second block and ledge is
(b)
Find the coefficient of kinetic friction force between the block and ledge.
Answer to Problem 50PQ
The coefficient of kinetic friction force between the block and ledge is
Explanation of Solution
Applying Newton’s laws for y direction on block 2.
Here,
Write the equation for friction force.
Here,
Conclusion:
From the free body diagram the find the value of
Substitute
Substitute
Therefore, the coefficient of kinetic friction force between the block and ledge is
Want to see more full solutions like this?
Chapter 5 Solutions
Physics for Scientists and Engineers: Foundations and Connections
- air is pushed steadily though a forced air pipe at a steady speed of 4.0 m/s. the pipe measures 56 cm by 22 cm. how fast will air move though a narrower portion of the pipe that is also rectangular and measures 32 cm by 22 cmarrow_forwardNo chatgpt pls will upvotearrow_forward13.87 ... Interplanetary Navigation. The most efficient way to send a spacecraft from the earth to another planet is by using a Hohmann transfer orbit (Fig. P13.87). If the orbits of the departure and destination planets are circular, the Hohmann transfer orbit is an elliptical orbit whose perihelion and aphelion are tangent to the orbits of the two planets. The rockets are fired briefly at the depar- ture planet to put the spacecraft into the transfer orbit; the spacecraft then coasts until it reaches the destination planet. The rockets are then fired again to put the spacecraft into the same orbit about the sun as the destination planet. (a) For a flight from earth to Mars, in what direction must the rockets be fired at the earth and at Mars: in the direction of motion, or opposite the direction of motion? What about for a flight from Mars to the earth? (b) How long does a one- way trip from the the earth to Mars take, between the firings of the rockets? (c) To reach Mars from the…arrow_forward
- No chatgpt pls will upvotearrow_forwarda cubic foot of argon at 20 degrees celsius is isentropically compressed from 1 atm to 425 KPa. What is the new temperature and density?arrow_forwardCalculate the variance of the calculated accelerations. The free fall height was 1753 mm. The measured release and catch times were: 222.22 800.00 61.11 641.67 0.00 588.89 11.11 588.89 8.33 588.89 11.11 588.89 5.56 586.11 2.78 583.33 Give in the answer window the calculated repeated experiment variance in m/s2.arrow_forward
- How can i solve this if n1 (refractive index of gas) and n2 (refractive index of plastic) is not known. And the brewsters angle isn't knownarrow_forward2. Consider the situation described in problem 1 where light emerges horizontally from ground level. Take k = 0.0020 m' and no = 1.0001 and find at which horizontal distance, x, the ray reaches a height of y = 1.5 m.arrow_forward2-3. Consider the situation of the reflection of a pulse at the interface of two string described in the previous problem. In addition to the net disturbances being equal at the junction, the slope of the net disturbances must also be equal at the junction at all times. Given that p1 = 4.0 g/m, H2 = 9.0 g/m and Aj = 0.50 cm find 2. A, (Answer: -0.10 cm) and 3. Ay. (Answer: 0.40 cm)please I need to show all work step by step problems 2 and 3arrow_forward
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning