Concept explainers
Two identical pieces of rectangular plate glass are used to measure the thickness of a hair. The glass plates are in direct contact at one edge and a single hair is placed between them hear the opposite edge. When illuminated with a sodium lamp
Want to see the full answer?
Check out a sample textbook solutionChapter 3 Solutions
UNIVERSITY PHYSICS,VOL.3 (OER)
Additional Science Textbook Solutions
Campbell Biology: Concepts & Connections (9th Edition)
Introductory Chemistry (6th Edition)
Applications and Investigations in Earth Science (9th Edition)
Human Anatomy & Physiology (2nd Edition)
Fundamentals of Anatomy & Physiology (11th Edition)
Campbell Essential Biology (7th Edition)
- Optical flats are flat pieces of glass used to determine the flatness of other optical components. They are placed at an angle above the component as shown in Figure P36.49A, and monochromatic light is incident and observed from above, leading to interference fringes. Figure P36.49C shows the results of one of these tests. What is the approximate difference in the gap thickness between the left and right sides of the optical flat and the component? Is it possible to determine from this figure alone which side has the greater gap thickness (left or right)? Figure P36.49 Problems 49 and 50.arrow_forwardAn air wedge is formed between two glass plates separated at one edge by a very line wire of circular cross section as shown in Figure P27.25. When the wedge is illuminated from above by 600-nm light and viewed from above, 30 dark fringes are observed. Calculate the diameter d of the wire.arrow_forwardA narrow beam of white light enters a prism made of crown glass at a 45.0° incident angle, as shown in Figure 25.57. At what angles, R and V, do the red (660 nm) and violet (410 nm) components of the light emerge from the prism? Figure 25.57 This prism will disperse the while light into a rainbow of colors. The incident angle is 45.0°, and the angles at which the red and violet light emerge are R and V.arrow_forward
- Figure CQ27.4 shows an unbroken soap film in a circular frame. The film thickness increases from top to bottom, slowly at first and then rapidly. As a simpler model, consider a soap film (n = 1.33) contained within a rectangular wire frame. The frame is held vertically so that the film drains downward and forms a wedge with flat faces. The thickness of the film at the top is essentially zero. The film is viewed in reflected white light with near-normal incidence, and the first violet ( = 420 nm) interference band is observed 3.00 cm from the top edge of the film. (a) Locate the first red ( = 680 nm) interference band. (b) Determine the film thickness at the positions of the violet and red bands. (c) What is the wedge angle of the film?arrow_forwardLight enters a prism of crown glass and refracts at an angle of 5.00 with respect to the normal at the interface. The crown glass has a mean index of refraction of 1.51. It is combined with one flint glass prism (n = 1.65) to produce no net deviation. a. Find the apex angle of the flint glass. b. Assume the index of refraction for violet light (v = 430 nm) is nv = 1.528 and the index of refraction for red light (r = 768 nm) is nr = 1.511 for crown glass. For flint glass using the same wavelengths, nv = 1.665 and nr = 1.645. Find the net dispersion.arrow_forwardBoth sides of a uniform film that has index of refraction n and thickness d are in contact with air. For normal incidence of light, an intensity minimum is observed in the reflected light at λ2 and an intensity maximum is observed at λ1, where λ1 > λ2. (a) Assuming no intensity minima are observed between λ1 and λ2, find an expression for the integer m in Equations 27.13 and 27.14 in terms of the wavelengths λ1 and λ2. (b) Assuming n = 1.40, λ1 = 500 nm, and λ2 = 370 nm, determine the best estimate for the thickness of the film.arrow_forward
- An optical fiber has an index of refraction n and diameter d. It is surrounded by vacuum. Light is sent into the fiber along its axis as shown in Figure P34.31. (a) Find the smallest outside radius Rmin permitted for a bend in the fiber if no light is to escape. (b) What If? What result does part (a) predict as d approaches zero? Is this behavior reasonable? Explain. (c) As n increases? (d) As n approaches 1? (c) Evaluate Rmin assuming the fiber diameter is 100 m and its index of refraction is 1.40. Figure P34.31arrow_forwardInto one arm of a Michelson interferometer, a plastic sheet of thickness 75 m is inserted, which causes a shift in the interference pattern by 86 fringes. The light source has wavelength of 610 nm in air. What is the index of refraction of this plastic?arrow_forwardA film of oil on water will appear dark when it is very thin, because the path length difference becomes small compared with the wavelength of light and there is a phase shift at the top surface. If it becomes dark when the path length difference is less than one-fourth the wavelength, what is the thickest the oil can be and appear dark at all visible wavelengths? Oil has an index of refraction of 1.40.arrow_forward
- A plano-convex lens has index of refraction n. The curved side of the lens has radius of curvature R and rests on a flat glass surface of the same index of refraction, with a film of index nflim between them, as shown in Figure P36.42. The lens is illuminated from above by light of wavelength . Show that the dark Newtons rings have radii given approximately by r=mRnfilm where r R and m is an integer. Figure P36.42arrow_forwardA thin sheet of transparent material has an index of refraction of 1.40 and is 15.0 µm thick. When it is inserted in the light path along one arm of an interferometer, how many fringe shifts occur in the pattern? Assume the wavelength (in a vac- uum) of the light used is 600 nm. Hint: The wavelength will change within the material.arrow_forwardThe Michelson interferometer can be used to measure the index of refraction of a gas by placing an evacuated transparent tube in the light path along one arm of the device. Fringe shifts occur as the gas is slowly added to the tube. Assume 610-nm light is used, the tube is 5.40 cm long, and 168 bright fringes pass on the screen as the pressure of the gas in the tube increases to atmospheric pressure. What is the index of refraction of the gas? Hint: The fringe shifts occur because the wavelength of the light changes inside the gas-filled tube. (Give your answer to at least five decimal places.)arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningUniversity Physics Volume 3PhysicsISBN:9781938168185Author:William Moebs, Jeff SannyPublisher:OpenStaxCollege PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage Learning