The optimum pH for the trypsin enzyme should be determined. Concept Introduction: The enzymes are considered as the catalyst for the biochemical reaction. They involve in the biochemical reactions to speed them up but again regenerate at the end of the reaction or process. The Lock and Key model was purposed to explain the reactivity of enzymes. It states that each enzyme has certain active sites that can only allow the bonding of certain subtract molecules.

Question

Want to see the full answer?

Answer 1

Question

Chapter 21.10, Problem 21.24P

Interpretation Introduction

Interpretation:

The optimum pH for the trypsin enzyme should be determined.

Concept Introduction:

The enzymes are considered as the catalyst for the biochemical reaction. They involve in the biochemical reactions to speed them up but again regenerate at the end of the reaction or process. The Lock and Key model was purposed to explain the reactivity of enzymes. It states that each enzyme has certain active sites that can only allow the bonding of certain subtract molecules.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Complete the following table. The only density needed is already given. Show your calculations in a neat and easy-to-follow manner in the space below the table. All units should be included and significant figures should be given close attention. Be sure to notice that the amount of material should be in millimoles rather than moles, and the theoretical mass of the product should in milligrams rather than grams. LOCH 3 + H2SO4 HNO 3 O=C-OCH 3 NO2 x H₂O F.W. 4.0 mL 1.3 M amount 0.50 mL in H2SO4 mg Theoretical Theoretical mmoles density 1.09

Kumada Coupling: 1. m-Diisobutylbenzene below could hypothetically be synthesized by Friedel-Crafts reaction. Write out the reaction with a mechanism and give two reasons why you would NOT get the desired product. Draw the reaction (NOT a mechanism) for a Kumada coupling to produce the molecule above from m-dichlorobenzene. Calculate the theoretical yield for the reaction in question 2 using 1.5 g of p-dichlorobenzene and 3.0 mL isobutyl bromide. What signals appeared/disappeared/shifted that indicate that you have your intended product and not starting material? What other impurities are present in your product and how do you know?

Wintergreen from Aspirin: 1. In isolating the salicylic acid, why is it important to press out as much of the water as possible? 2. Write the mechanism of the esterification reaction you did. 3. What characteristic absorption band changes would you expect in the IR spectrum on going from aspirin to salicyclic acid and then to methyl salicylate as you did in the experiment today? Give approximate wavenumbers associated with each functional group change. What signals appeared/disappeared/shifted that indicate that you have your intended product and not starting material? What other impurities are present in your product and how do you know?