Concept explainers
A 10.0-g sample of white phosphorus was burned in an excess of oxygen. The product was dissolved in enough water to make 500.0 mL of solution. Calculate the
Interpretation:
The pH of the solution formed by the combustion of phosphorus and consequential dissolution in water is to be determined.
Concept introduction:
The first ionization of a poly-protic acid takes place as
Percent ionization is the percentage of acid that gets dissociated upon addition to water. It depends on the hydronium ion concentration.
Here,
pH of the solution is calculated as
Molarity
Answer to Problem 140AP
Solution:
The pH of the solution is
Explanation of Solution
Given information:
White phosphorous is burned in oxygen according to the reaction:
According to the stoichiometry,
So,
Molar mass of
Number of moles of
Now,
According to the stoichiometry, 1 mole of
Use equation (4) to calculate molarity of the solution as
Refer to table
When phosphoric acid is dissolved in water, dissociation takes place in three steps as it is a triprotic acid. First, one proton is partially dissociated, becausephosphoric acid is a weak acid. Thus, the pH of the solution is determined by the contribution made by all the three proton dissociation steps.
The reaction of the first proton dissociation of phosphoric acid is represented as
Prepare an equilibrium table and represent each of the species in terms of
Now, substitute these concentrations in equation (1) as
Since the value of
Thus,
Calculate the percent dissociation from equation (2) as
Since the percent dissociation is more than
Since concentration cannot be negative, so
Thus,
The second and third ionization constants for phosphoric acid have a low value. Thus, it will have negligible contribution in the hydronium ion concentration.
Now, use equation (3) to calculate pH of the solution as
The pH of the solution is calculated to be
Want to see more full solutions like this?
Chapter 16 Solutions
Chemistry
- Acids You make a solution by dissolving 0.0010 mol of HCl in enough water to make 1.0 L of solution. a Write the chemical equation for the reaction of HCl(aq) and water. b Without performing calculations, give a rough estimate of the pH of the HCl solution. Justify your answer. c Calculate the H3O+ concentration and the pH of the solution. d Is there any concentration of the base OH present in this solution of HCl(aq)? If so, where did it come from? e If you increase the OH concentration of the solution by adding NaOH, does the H3O+ concentration change? If you think it does, explain why this change occurs and whether the H3O+ concentration increases or decreases. f If you were to measure the pH of 10 drops of the original HCl solution, would you expect it to be different from the pH of the entire sample? Explain. g Explain how two different volumes of your original HCl solution can have the same pH yet contain different moles of H3O+. h If 1.0 L of pure water were added to the HCl solution, would this have any impact on the pH? Explain.arrow_forwardFollow the directions of Question 19 for the following acids: (a) hypochlorous acid (b) formic acid, HCHO2 (c) acetic acid, HC2H3O2 (d) hydrobromic acid (e) sulfurous acidarrow_forwardOne half liter (500. mL) of 2.50 M HCl is mixed with 250. mL of 3.75 M HCl. Assuming the total solution volume after mixing is 750. mL, what is the concentration of hydrochloric acid in the resulting solution? What is its pH?arrow_forward
- . Calculate the pH corresponding to each of the pOH values listed, and indicate whether each solution is acidic, basic, or neutral. a. pOH = 4.32 b. pOH = 8.90 c. pOH = 1.81 d. pOH = 13.1arrow_forwardWhat are the major species in solution after NaHSO4 is dissolved in water? What happens to the pH of the solution as more NaHSO4 is added? Why? Would the results vary if baking soda (NaHCO3) were used instead?arrow_forwardThe weak base methylamine, CH3NH2, has Kb=4.2104. It reacts with water according to the equation. CH3NH2(aq)+H2O(l)CH3NH3+(aq)+OH(aq) Calculate the equilibrium hydroxide ion concentration in a 0.25 M solution of the base. What are the pH and pOH of the solution?arrow_forward
- The chemistry of gallium: (a) Gallium hydroxide, like aluminum hydroxide, is amphoteric. Write a balanced equation to show how this hydroxide can dissolve in both HCl(aq) and NaOH(aq). (b) Gallium ion in water, Ga3+(aq), has a Ka value of 1.2 103. Is this ion a stronger or a weaker acid than Al3+(aq)?arrow_forwardCalculate the pH of the solution. Assume 1.0 L of solution. You must identify the type of solution before calculating the pH. Express all pH values to two decimal places. 0.250 moles HClO and 0.250 moles RbOH Ka (HClO) = 2.9 x 10-8arrow_forwardThe hydroxide ion concentration in a dilute ammonia solution is 0.0025M. Calculate the PH of the solution.arrow_forward
- calculate the ph of a 2.00M solution of HNO2. The KA for nitrous acid is 4.5 x 10^-4arrow_forwardAfter dissolving 0.35 g of magnesium hydroxide in 135 mL of water, how many mL of a 1 L hydrochloric acid solution with a pH of 2.5 should be used to neutralize it completely?arrow_forwardCalculate the pH of a 0.032M H2SO4 solution.arrow_forward
- Chemistry: The Molecular ScienceChemistryISBN:9781285199047Author:John W. Moore, Conrad L. StanitskiPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781337399074Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage LearningChemistry & Chemical ReactivityChemistryISBN:9781133949640Author:John C. Kotz, Paul M. Treichel, John Townsend, David TreichelPublisher:Cengage Learning
- Chemistry: Principles and ReactionsChemistryISBN:9781305079373Author:William L. Masterton, Cecile N. HurleyPublisher:Cengage LearningIntroductory Chemistry: A FoundationChemistryISBN:9781285199030Author:Steven S. Zumdahl, Donald J. DeCostePublisher:Cengage Learning