The molar absorptivities of compounds X and Y were measured with pure samples of each:                   ε (M-1 cm-1)  λ (nm)       X           Y       272    16,440    3,870       327      3,990     6,420 A mixture of compounds X and Y in a 1.00-cm cell had an absorbance of 0.957 at 272 nm and 0.559 at 327 nm. Find the concentrations of Y in the mixture. 4.43 x 10-5 M 3.03 x 10-6 M 5.95 x 10-5 M 3.56 x 10-4 M

Q: A solution containing a mixture of the compounds X and Y had an absorbance of 0.736 at 443 nm and an…

A:

Q: How will mistakenly using solution 1 to calibrate the spectrophotometer, instead of the blank effect…

A: Blank solution is used to calibrate the absorbance with Transmittance(%T) and set a zero value by…

Q: MASS SPECTRUM Exepected m/zis 130.231 a. Identify what each fragment listed indiactes. b. What is…

A: The objective of the question is to understand the information provided by the mass spectrum of a…

Q: A solution of altura red of concentration 307 ppm gives an absorbance of 0.616. What concentration…

A: It is given that the concentration of Altura red solution = 307 ppmAbsorbance value of Altura red…

Q: A 1.3 * 10-5M solution of an unknown substance has an absorbance of 0.345 at its λmax. Calculate the…

A:

Q: 18-16. A compound with a molecular mass of 292.16 was dissolved in a 5-mL volumetric flask. A…

A:

Q: Q5. Figure 2 shows the mass spectrum of the same compound from an El source and a Cl source. (a)…

A: a)The best way to figure out the molecular mass of a molecule is to look at its CI spectra. b. The…

Q: Caffeine was analyzed using UV-Vis spectroscopy. The average absorbance for 10 blanks is 0.01826.…

A: To calculate the signal detection limit (SDL), we use the formula: SDL = 3 x SD(blank) where…

Q: MASS SPECTRUM Exepected m/zis 130.231 a. Identify what each fragment listed indiactes. b. What is…

A: The objective of the question is to understand the information provided by the mass spectrum,…

Q: tion 13 of 24 > The standard curve was made by spectrophotographic analysis of equilibrated…

A: Given that: Absorbance = 0.179 Slope-intercept equation = y=4536.6x + 0.0392 Concentration of Fe3+ =…

Q: A specific steroid has a Amax of 285 nm and a molar absorptivity e of 11, 500 L mol-¹ cm-¹. What is…

A:

Q: one: Topic Molecular Spectroscopy (16 marks) You were given an unknown mixture that contains two…

A: Step 1: Calculate the absorbance of the mixture at each wavelength (510 nm for salt A and 575 nm for…

Q: A reaction was carried out with Fe3+ and SCN- to produce FeSCN2+. Two best-fit lines for Absorbance…

A: The linear regression gives the information about the perfection of the model and for the best-fit…

Q: What is the molar absorptivity, in M-1cm-1, for a 4.00×10-5 M solution placed in a 2.00 cm cuvette…

A:

Q: A 1.00 mL aliquot of a hydrogen peroxide (H2O2) solution was added to 2.00 mL of acidified Ti(IV)…

A: The concentration (C) of the substance can be calculated based on the absorbance (A) value using the…

Q: An absorbing solution transmits just 38 of every 140 photons to the detector. If the cell width was…

A: We have to calculate the molar absorptivity of the given solution.

Q: Find the [FeSCN^2+]eq ε=4.0×10^3 M-1 cm^-1 at 447 nm

A: According to Lambert-Beer Law, “There is a linear relationship between the concentration and the…

Q: An ethanol solution of 3.5 mg/100 ml of compound Y (150.0 g/mol) in a 1.00 cm quartz cell has an…

A: Note: As per guidelines we can answer the first question.  The molar extinction coefficient is a…

Q: For this experiment I prepared two solutions: each was an injection of 15 microliters of pure acetic…

A: 1 μL = 10-6 L 1 L = 1000 mL Volume of acetic anhydride (MW = 102.09 g/mol) taken in mL, V = 15.9 μL…

Q: A specific steroid has a Amax of 251 nm and a molar absorptivity e of 11, 500 L mol-¹ cm-¹. What is…

A:

Q: To determine the concentration of these analyte ions in a mixture, the mixture absorbance is…

A: This is application of the Lambert beer law . Here we are required the molar concentration of X3+…

Q: Suppose you measure the absorbance of a yellow dye solution in a 1.00 cm cuvette (b31.00 cm). The…

A:

Q: A 50.0 mL sample containing Cd2+ and Mn2+ was treated with 48.2 mL of 0.0600 M EDTA. Titration of…

A:

Q: How to calculate the concentration of the two salts?

A: The objective of this question is to determine the concentration of two metal salts, Co(NO3)2 and…

Q: At 21 °C, a solution of 12 mL each of 0.00200 M Fe3+ and 0.001000 M SCN- was mixed and brought to…

A: The given reaction is: Fe3+(aq) + SCN-(aq) → Fe(SCN)2+(aq) Here the product, Fe(SCN)2+(aq) is…

Q: The following data are obtained from three standard soltions using UV-Vis spectroscopy:  What is…

A: Given : Absorbance of solution at 255 nm= 0.180 And molar mass of analyte = 188.65 g/mol

Q: The measured absorbance of a solution with a pathlength of 1.00 cm is 0.544. If the concentration is…

A: pathlength (l) =1.00 cm Absorbance (A) = 0.544 concentration(c) = 1.40 x 10 —3M

Q: 10 cm 3 air saturated Fricke dosimetry solution in a 1 cm diameter tube is irradiated for 10 min in…

A: Absorbance is a measure of the quantity of light absorbed by a sample. It can be calculated by using…

Q: Maria was tasked to determine the concentration of a Fe2(SO4)3 solution. She prepared 5 different…

A:

Q: 5. A solution of certain dye has a calibration graph shown below when measured at 425 nm in 1.00cm…

A: Answer Using the Beer's lambert law The dye concentration at absorbance of 0.733M The equation of…

Q: The absorbance of the solution at 427 nm is 0.43. If the molar absorptivity of yellow dye at 427 nm…

A: