Result nad Discussion Lead Acetate Reaction: Samples: lysine, cysteine, methionine Reagents: 10% Sodium Hydroxide (NaOH) and Lead Acetate Pb(CH3COO)2 -To 1 ml of the amino acid solution taken in a test tube, add few drops of sodium hydroxide (40%) and boil the contents for 5-10 mins over a bunsen burner. Cool the contents and add few drops of 10% Lead acetate solution and observe.

Result nad Discussion Lead Acetate Reaction: Samples: lysine, cysteine, methionine Reagents: 10% Sodium Hydroxide (NaOH) and Lead Acetate Pb(CH3COO)2 -To 1 ml of the amino acid solution taken in a test tube, add few drops of sodium hydroxide (40%) and boil the contents for 5-10 mins over a bunsen burner. Cool the contents and add few drops of 10% Lead acetate solution and observe.

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter21: Heparin Infusion Calculations

Section: Chapter Questions

Problem 1.4P

See similar textbooks

Similar questions

Table 4- Determination of the optimum pH of catechol oxidase enzyme Potato extract (mL) Tube # 2d 3d 4d 5d 6d 7d dH₂O (mL) 0 0 0 0 0 0 Catechol (mL) 6 6 6 6 6 6 pH buffer added 4mL pH 2 4mL pH 4 4mL pH 6 4mL pH 7 4mL pH 8 4mL pH 10 1 1 1 1 1 1 Absorbance (0 mins) A: 0.010 Start Time: 3:24 A: 0.008 Start Time: 3:34 A: 0.023 Start Time: 3:36 A: -0.006 Start Time: 3:36 0.018 A: Start Time: 3:36 A: 0.011 Start Time: 3:36 Absorbance (after 10 mins in 40°C water bath) -0.030 A: Take reading at: 3:44 A: 0.154 Take reading at: 3:46 A: 0-105 Take reading at: 3:46 A: 0-132 Take reading at: 3:46 A: 0.074 Take reading at: 3:46 A: 0.018 Take reading at: 3!46 Q15) What is the enzyme's optimum pH(s)? Answer: Q16) Use the difference between 2nd and 1st absorbance to support your conclusion for the optimum pH. Subtract Omin from 10min absorbance -0.04 0.0012 0.082 0.138 0.056 0.007
Results and Discussion: Sakaguchi Reaction: Samples: arginine , glycine, tryptophan Reagents: a-naphthol , Sodium Hypobromite (1ml Bromine water added to 1ml 10% NaOH, freshly prepared) -Mix 1 ml of 10% NaOH with 0.5 ml of the sample and add 1 ml of alpha-naphthol reagent. Then add drop by drop (about 5 drops) of the sodium hypobromite solution. Note the color formed.
#2
Phenol Red Test Question: Assuming you tested an organism using Phenol Red glucose and Phenol Red Base broths, which of the combinations of results in the following table would be reliable. Interpret each of the combinations and explain how the results might be obtained
Table 1 - Comparison of the effect of catechol concentration on the amount of product formed. Absorbance Potato extract Absorbance 0 mins after 30mins (2nd reading) (mL) 1st reading 1 Tube # la blank 2a 3a 4a 1 1 1 dH₂O Catechol (mL) (mL) 7 5 3 1 0 2 4 6 0.00 0.060 0.033 0-05-2 Q4) Give 2 reasons for adding dH₂O to these tubes in Table 1? Time for reading: 3:21 -0.11 Absorbance: Time for reading: 3.36 Q5) Tube la serves as a control, but why is this control needed? Absorbance: 0.197 Time for reading: 3.37 Based on the data from Table 1 answer these questions: Q1) What is the name of the enzyme found in potato extract? Answer: catechol Q2) What is the substrate? Answer: THO Q3) Name of product of this enzyme catalyzed reaction? Answer: Absorbance: 0.152 Time for reading: 3:39 Absorbance: . 166 ness Catechol Benzoquinone Subtract 1st from 2nd reading -0.01 0-137 0.11.19 0.119 Q6) Notice that your 1st absorbance reading in tubes 2a-4a are quite similar but it then becomes very different…
Computation: Ratio Strength, PPM, mg%Show your complete solution.1. How many grams of a 1:80 trituration of strychnine sulfate should be used for this prescription?RxStrychnine sulfate 45mgBelladonna extract 360mgSucrose 36gFt. chart; Div. in #XXXVIAmount of Strychnine in grams = ?
Size Size Crude Anion Cation 2) Exclusion Exclusion Lysate Exchange Exchange 1 2 Total Protein Concentration 15.2 6.6 2 3.75 4.7 (mg/mL) Final Sample Volume 60 30 20 4 3 (mL) Enzyme Specific Activity 0.43 1.7 7.25 18.3 12.5 (units/mgprotein) Based on your protein purification sample data, in which of the purification steps in your protocol did you effectively purify your enzyme? Select all that apply. a) anion exchange correct b) cation exchange correct c) size exclusion 1 correct d) size exclusion 2
Results and Discussion: Folin's McCarthy Sullivan Test: Samples: proline, methionine, alanine Reagents: sodium hydroxide (5N), Glycine (1%) and 10% sodium nitroprusside solution, 6N HCl -To 1 ml of the amino acid solution taken in a test tube, add few drops of sodium hydroxide (5N), followed by addition of few drops of glycine (1%) and 10% sodium nitroprusside solution (HANDLE WITH CARE)and vortex. Place the test tube in a hot water bath, maintained at 40 C, for 15 minutes. Cool the test tube in ice cold water for 5 minutes and add 0.5 ml of 6N HCl. Vortex the contents and allow to stant fpr 15 minutes at room temperature.
Example of a Protein Purification Scheme: Purification of the Enzyme Xanthine Dehydrogenase from a Fungus Volume Total Total Specific Percent Fraction (mL) Protein (mg) Activity Activity Recovery 1. Crude extract 2. Salt precipitate 3. Ion-exchange chromatography |4. Molecular-sieve chromatography 5. Immunoaffinity chromatography 3,800 22,800 2,460 0.108 100 165 2,800 1,190 0.425 48 65 100 720 7.2 29 40 14.5 23 1.8 275 152.108 11 Calculate the specific activity of step#4. Note that percent recovery=% Yield.
COLOR REACTION OF PROTEINS Question Guide: 1. Write the positive result, the chemical group responsible for the positive and the importance of each test. Test Positive Result Chemical Group Biuret Ninhydrin Xanthoprotei Millon's Hopkins-Cole Lead Acetate Pauly Bromine Water Sakaguchi
Alligation Alternate. Show your complete solution. Note: Indicate the unit. Indicate your answer in whole numbers. 1. The solvent for the extraction of a vegetable drug is 75% alcohol. How many milliliters may 95%, 60% and 50% alcohol be mixed to prepare 75% of 4 pints of alcohol? Amount of 95% alcohol needed = ? Amount of 60% alcohol needed = ? Amount of 50% alcohol needed = ?
Draw the Fischer projection for L-glucose. Drag the appropriate labels to their respective targets. H as OH H =0 C CH₂OH Reset Help