Q3/For a square interior panel, Determine the maximum length of span (L), so that the steel in all beam sections not exceeding to the minimum value? Use the following data:- f'c=21Mpa live load=3 kN/m², bw=250mm, d=400mm, h=460mm thickness of slab=120mm, all column (300*300) mm, fy=350Mpa imposed dead load=D1.5 kN/m? 24KN / m3

Q3/For a square interior panel, Determine the maximum length of span (L), so that the steel in all beam sections not exceeding to the minimum value? Use the following data:- f'c=21Mpa live load=3 kN/m², bw=250mm, d=400mm, h=460mm thickness of slab=120mm, all column (300*300) mm, fy=350Mpa imposed dead load=D1.5 kN/m? 24KN / m3

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Draw a free-body-diagram showing the loads on girder G1 in the floor plan shown below. The floor supports 40 psf. Show process work
A simply supported rectangular beam of length L has a width of b and an effective depth of d. Compression steel bars are placed at a distance d' from the extreme concrete compressive fiber. The beam supports service dead loads of wD and wl, respectively. Use fc'= 28 MPa and fy = 420 MPa. For the reinforcements, use 4 20 mm tension steel bars and 4 10 mm compression steel bars. b= 390 mm d= 615 mm d'= 165 mm L= 5.85 m Wd= 27.79 kN/m WI= 32. 25 KN/m Questions 1. Calculate the height of the neutral axis measured from the extreme compression fiber. 2. Calculate the strength reduction factor for the given beam. B. Calculate the design moment for the given beam.
Please answer. Ty
I need the answer to the question in reinforced concrete
1. For the given singly reinforced beam section, fy =352 MPa, and f's = 28MPA. Calculate the required parameters for the different section condition in the table. d = 257mm h = 307mm 200mm Concrete Steel of Location Limit for No. of 16mm Area of diameter bar Condition Depth strain strain compression of block "a". neutral steel in to meet the axis "c". sq.mm. given beam condition. Units N/A N/A mm mm Sq.mm bars Balanced 0.003 Condition Compression 0.003 controlled Transition 0.003 controlled Tension 0.003 controlled
Do not use chatgpt and pls don't provide image solution otherwise I will downvote you
Please solve part A and B Subject is reinforced concrete design show all steps
Please give explanations with formulas and referencing the diagram where possible
Q2/ Determine the amount of steel required to create a balanced condition for the beam that has height 500 mm, width 300 mm, effective depth (d) 450 mm as shown in figure 2, where f'c 25 MPa and fy = 400 MPa. (50 marks) %3D 300 mm 500 mm Figure 2
I need the answer to the question in reinforced concrete
For the following plan it is required to: 1- Design all beams for flexure and shear, where they have additional 30 kN/m distributed factored load 2- Design the columns. The concrete has a strength of 30 MPa, and the yield strength of the steel is 420 MPa. Show full calculations and neat sketches. All dimensions are in m. I 03 B2 0,3 7 B1 Wu=20 kN/m2 B1
Please answer part 4