A rectangular beam has a width of 300mm and an effective depth pf 537.50mm to the centroid of tension steel bars. Tension reinforcements consists of 6-28mm bars in two rows, compression reinforcement consists of 2-22mm bars, fc' = 27.6MPa, fy = 414.7MPa, d'=60mm. The maximum total tension steel allowed by specification is  mm^2.   A. 6400 B. 3800 C. 2700 D. 4200

Q: Find the nominal moment strength capacity of the beam. (kN.m)

A:

Q: Compute the Modulus of Rupture of the beam shown, in MPa.

A: "Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q2 : Design the beam showing below for shear by using Ultimate Strength Design method according to…

A:

Q: simply supported beam is reinforced with 4 – 28 mm ø at the bottom and 2 – 28 mm ø at the top of the…

A: Given  fc’ = 30 MPa, fy = 415 MPa. Balanced steel ratio ρb = 0.031 Reduction factor= 0.9

Q: Assume Grade 50 steel and use f. = 5,000 psi for parts (a) thru (b). (a) The beam below is subjected…

A:

Q: Design Beam AB: The beam carries the distributed loads and the concentrated loads as shown: Select…

A: Answer  (1) Selection of section In order to select a section we need to equate Maximum Moment on…

Q: The rectangular RC members under uniform load, the cross section of the beam is b×h = 250×500 mm. A…

A: The compression strength means the material or structure's ability to resist loads that tend to…

Q: 3.4 The required flexural (bending moment) strength is of a reinforced concrete beam is Mu= 260…

A:

Q: GIVEN; A column made of 2 materials: a W 6 x15 structural steel section Page 3 encased in concrete…

A: area os  steel section  As=4.43 in2Area of concrete  AC=75 in2modular ratio…

Q: A composite beam is made of two brass [E = 119 GPa] plates bonded to an aluminum [E = 73 GPa] bar,…

A:

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.