An op amp with an open-loop gain of 106 and Vcc = 12 V has an inverting-inputvoltage of 22 μV and a noninverting-input voltage of 6 μV. What is its outputvoltage?Your Answer:Answerunits

Answered: An op amp with an open-loop gain of 106…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 13PP: In an R-L parallel circuit, IT=1.25 amps, R=1.2k, and XL=1k. Find IR

See similar textbooks

Similar questions

#3. The output voltage of an op amp is -4 V when the non-inverting input is 1 mV. If the open-loop gain of the op amp is 2 × 10°, what is the inverting input?
An op-amp is connected to power supplies so that its Vcc value is 15V. It has an open-loop gain of 8 x 106 V/V, and the non-inverting input is 1 µV. If the output voltage is equal to 2V, what is the magnitude of the voltage connected to the inverting terminal?
Consider the following op-amp circuit, where Vin = 2V. The Op-Amp is powered by ±15V power sources. R1 = 10 k2 and R₂ = 35 k. Part A - What is the power dissipated by a load resistor of 100 k between ground and the output pin? ANSWER: Part B - mW For the circuit in part A, what is the total power supplied by the op amp? ANSWER: Part C- mW What would the total power supplied by the op amp be if the load resistor was 10 kQ? ANSWER: mW Part D- If the op amp can provide at most +/- 35 mA, what is the smallest load resistor you could have before hitting the current limit of the op amp? ANSWER: Ω
Choose the correct answer. *Please answer it ASAP if you can*
An ideal op-amp circuit is shown above, with dc supply Vcc = -Vcc = 12V. Assume that vs = 3V, R1 = 2Ω, Rf = 4Ω. Please find the output voltage vo in volts.
An ideal op-amp circuit is shown above, with dc supply Vcc = -Vcc = 12V.Assume that v1 = 2V, v2 = 2V, R1 = 3Ω, R2 = 3Ω. Please determine Rf (in ohm's) so that the output voltage vo = -10 volts.
1. For the circuit below assume an ideal op amp. Find Vo/Vs. R1 =2kQ2, R2 =5k0, R3 =8k and R4 =20k02. VB R1 www R4 VO
The Op-Amp is configured as shown below, and the input is a sinusoid with frequency = 1kHz, and 1 Vpp. Draw the output voltage waveform and indicate min and max amplitude of it if your biasing voltage of Op-Amp is +- 15V. Vin V out Rf=10 Rg=1 Figure: 1 If input is changed to DC voltage in Figure 1, which goes from 0 V to 5 V, draw the output with respect to input DC voltage.
For the op-amp circuit shown, fill the values of the output voltage for the given input voltage values.
For the op amp circuit, find the voltage gain vo/vs. assume R1= 100 ohms, R2= 150 ohms, Rf= 500 ohms
Please answer in typing format solution please only typing Please I will like it Thanks sir
An ideal op-amp circuit is shown above, with dc supply Vcc = -Vcc = 20V on both op-amps.Assume that v1 = 4V, v2 = 2V, R1 = R4 = 9kΩ, R2 = R5 = 4kΩ, R3 = 5kΩ. Please determine the output voltage vo in volts.

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

An op amp with an open-loop gain of 106 and Vcc = 12 V has an inverting-input voltage of 22 μV and a noninverting-input voltage of 6 μV. What is its output voltage? Your Answer: Answer units