A hydro station has the following data: Plant capacity 10 MW, water head 20 m, overall efficiency 0.8,load factor 0.4,The maximum actual generation output for one week is 1008*10³ kwh. Find the amount of total water required by the station for one week.

A hydro station has the following data: Plant capacity 10 MW, water head 20 m, overall efficiency 0.8,load factor 0.4,The maximum actual generation output for one week is 1008*10³ kwh. Find the amount of total water required by the station for one week.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.15P: Let a voltage source v(t)=4cos(t+60) be connected to an impedance Z=230. (a) Given the operating...

See similar textbooks

Related questions

Q: (a) The two systems y[n] 3x[n] 2x [n-1] and y[n] 5x[n] 4x[n-1] are connected in parallel. Compute…

Q: figu RA QUESTION 4 RAN R = E figure 4 12, R3 = 62, R4 = 40, and E = 24V, then Assume that on figure…

A: Question (4)

Q: Part iv and v. I keep on getting incorrect the answer I put were -1.8,-2.4, 5 and -2.44 and they are…

Q: EXERCISE PROBLEM Ex 4.2: For the circuit shown in Figure 4.1, VDD = 3.3 V and RD = 10 ks. The…

Q: Calculate the current across the capacitor shown in Fig. P8.6 if the voltage input is u2(t)-12 sin…

Q: I need an expert's solution for using the (emu8086) program.

A: Let's go through the steps and solve each one in detail.2. Encode the instructions into machine…

Q: Analyze each of the following rising-edge-triggered 3-bit counters. For each: 1) derive the…

A: Flip flop excitation equations are obtained by observing the given circuit diagram. Using the…

Q: Determine the capacitance and capacitive reactance per mile of this three-phase line shown below.…

A: To determine the capacitance and capacitive reactance per mile of the three-phase line, and then the…

Q: NEED HANDWRITTEN SOLUTION NOT USING AI

Q: ww 25 A 17 Ω ww 12 Ω 8 Ω ww 16 Ω www 10 mF ww 5 Ω 20 Ω The circuit above is in steady state at t = 0…

A: Step 1: Step 2: Step 3: Step 4:

Q: not use ai please

A: Step 1: Step 2: Step 3: Step 4:

Q: Help me so

A: Step 1: Step 2: Step 3: Step 4:

Q: Find the inductor current IL1 before the switch is opened at time zero.- Assume that the circuit has…

A: Step 1: Given that, V1 =10VR1=20 ΩR2=70 ΩR3=60 ΩR4=90 ΩL1=10 HThe inductor behaves like a short…

Q: Explain the steps please

Q: A 1 ΚΩ 1 ΚΩ 2 mA B E w 1 ΚΩ 1 ΚΩ C 1 ΚΩ x D 1 ΚΩ ww ww 21 x 'S + 12 V Part A Nodal Analysis: 1) At…

A: Step 1: Step 2: Step 3: Step 4:

Q: Don't provide AI solution otherwise I give lot of dislikes

A: Step 1: Step 2: Step 3:

Q: Handwritten solution required not using chatgpt..otherwise dislike

Q: Explain all the wteps

Q: Example: Atemperature sensor has a span of 20° 250°C. A measurement results in a value of 55°C for…

Q: Problem 1 (3 pts each). Consider the CT system defined in textbook page 146, problem 2.33, i.e., Eq.…

A: Step 1: an answer Step 2: b answer Step 3: remaining above Step 4: submited

Q: Find x(n) h(n) by using a graphical method. x(n) 1.5 0.5 -2 -1 0 1 A h(n) 0.5 0.2 • . n n 2 3 4 -2…

Q: practice exam question. the answer key says 6v is the answer but i dont see why

Q: EXERCISE PROBLEM Ex 4.1: For an n-channel MOSFET biased in the saturation region, the parameters are…

Q: TUTORIAL (1) Write 2's complement for x--3.510 and y--2.2510 (4-bits for integer and 2-bits for…

A: 1):- For the binary number 1000, the weight of the column with the 1 is:The binary number 1000…

Q: DO NOT SOLVE USING CHATGPT OR ANY OTHER AI OTHERWISE DOWNVOTE

A: Step 1: Step 2: Step 3:

Q: Define x(t) as x(t) = cos(wot +л/3) + 2 sin(wot - л/3) Find a complex-valued signal z(t) such that…

Q: hydro power station has a mean head of 25 m, water discharge of 8× 106 m³/day and overall efficiency…

A: Approach to solving the question:Please see attached photos for detailed solutions. Thank you.…

Q: 1. Calculate the impedance, current, voltage, and power values for the circuit in the following…

A: Step 1: Compute for the impedance. The formula for impedance is Z=R+j(XL-XC)No inductor is present…

Q: please show work on paper ty

A: A system is said to be linear if it satisfies two properties: additivity and homogeneity. Additivity…

Q: 3- Calculate the maximum sampling frequency to obtain five samples in the logic one of information…

A: To obtain five samples in the logic one of the information signal, we need to calculate the number…

Q: Find the state diagram that describes the operation of the sequential system in Fig. 1. This system…

A: Step 1: Here we have Given sequential circuit and has to find the state diagram. state diagram is a…

Q: Can you minimize the following expression using K-maps:

A: Step 1: Using k-map to minimize the expressionStep 2: writing the boolean expression for all pairs…

Q: 1. (5 points) Consider the signal 1 x(t): [u(ta)u(ta)] for finite a € R, a > 0 2a Compute the energy…

A: Here is the step-by-step explanation: Step 1: Understanding the Signal:The given signal…

Q: solve these please and explain step by step how u reached the correct solution

Q: not use ai please don't

A: Step 1:Step 2: Step 3:

Q: A certain channel has ideal amplitude, but nonideal phase response, given by |H(f)| = 1…

A: Step 1: Step 2:Step 3: Step 4:

Q: I need a step by step solution I cannot get the correct answer

Q: Auto Determine the average power absorbed by the 1 ohm resistor using a Thevenin's equivalent…

A: Step 1:Step 2:

Q: Can you minimize the following using K-maps:

A: Approach to solving the question: 1. Construct the K-map:We will use a 4-variable K-map since there…

Q: I need an expert's solution to the following questions in a simple manner, without too much…

A: 1: Losses in X-mer:2: Output vs Efficiency3: When V increases without f:

Q: 1 ΚΩ B (+- 10V 2 ΚΩ 13mA E 12 V 4 mA ww 4ΚΩ D 6 mA 2ΚΩ a) At which nodes can KCL be applied? b)…

A: a) At which nodes can KCL (Kirchhoff's Current Law) be applied?KCL can be applied at any node where…

Q: In the circuit below, R1 = 2k 2, R2 = 3k Q, C = 0.5µF and L = 20mH. Find | Vout || | Vin]=10V@ W =…

A: Step 1: Step 2: Step 3: Step 4:

Q: 2.20. Express the following functions in the general form of the unit step function u(±1-10): (b)…

A: Step 1:Step 2:

Q: 1.)Convert the reactance diagram into admittance Diagram . 2.) Find the Equation using KCL. 3.)…

A: Step 2: Apply Kirchhoff's Current Law (KCL) and Include Voltage Sources # Re-solving the system…

Q: for the magnitude of the vector <1,2,-1>

A: Approach to solving the question:Please see attached photo for detailed solutions. Thank you.…

Q: Experiment 4. Objective: To demonstrate how basic gates can be used to implement any logic function…

Q: x(t) Doppler ultrasound signals used for measuring blood flow are often complex, and Fourier…

A: Final answer-

Q: Solve this using Partial Fraction Decomposition

A: Step 1:Step 2:Step 3: Step 4:

Q: -11 A voltmeter is accurate to 98% of its full-scale reading. (a) If a voltmeter reads 175 V on the…

A: Approach to solving the question:Please see attached photos for detailed solutions.thank…

Q: 20. Given the information provided in Fig. 15, determine RC, RB, RE, VCE and VB. 12V 2mA Re Re 7.6v…

A: Step 1: According to the question, for the given circuit as shown below we need to calculate the…

Question

A hydro station has the following data: Plant capacity 10 MW,
water head 20 m, overall efficiency 0.8,load factor 0.4,The maximum
actual generation output for one week is 1008*10³ kwh.
Find the amount of total water required by the station for one week.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Consider two interconnected voltage sources connected by a line of impedance Z=jX, as shown in Figure 2.27. (a) Obtain expressions for P12 and Q12. (b) Determine the maximum power transfer and the condition for it to
This question is about electrical power and I want to answer in 20 minutes
Suppose 300 gal/min of water is taken from a creek and delivered through 1000 feet of 3-in-diameter polyethylene pipe to a turbine 200 feet lower than the source. Assuming 80% efficiency for the turbine/generator, estimate the energy delivered in a 30-day month.a. 3423 KWhb. 3586 KWc. 4565 KWhd. 2771 KWhe. 2690 KWh
3. A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic meters. The net head of water at the turbine is 50 m. If the efficiencies of turbine and generator are 85% and 95% respectively, calculate the total energy in kWh that can be generated from this station. If a load of 15000 kW has been supplied for 4 hours, find the fall in reservoir.
A single-phase energy meter having meter constant of 200 rev/kWh is operating on 230V, 50 Hz supply with a load of 10A and at unity power factor for three hours continuously. The number of revolutions shown by the meter during this period is
The annual load factor of a power plant feeding a set of loads is 75%, the annual average load is 30000 kW and the utilization factor for this plant 0.8, determine the rated capacity of this plant in kW. 50000kW
A generating plant has a maximum capacity of 100 kW and costs Rs 2,000,000.The annual fixed charges are 12% consisting of 6% interest, 4% depreciation and 2% taxes. Find the fixed charges per kWh if the load factor is (i) 1o0% and (ii) 60%.
This is my last and remaining question. Please answer what is asked in 2 & 3. Thank you!
Q2) A generating station has a maximum demand of 30 MW, a load factor of 0.6 and plant use factor of 0.8. Determine i) The daily energy produced ii) The reserve capacity of the plant iii) The maximum energy that could be produced if the plant were running all the time iv) The maximum energy that could be produced daily, if the plant when running according to operating schedule were fully loaded
Type your question here A power plant has to meet the following load demand: Load A: 100 MW from 8 AM - 6 PM Load B: 150 MW from 6 AM - 10 AM Load C: 50 MW from 6 AM - 10 AM Load D: 20 MW from 10 AM - 6 AM Plot the daily load curve and determine (a) diversity factor (b) load factor (c) daily energy produced.
I need the correct expert solution
Pls answer thank you! A hydro power plant is to be used as peak load plant at an annual load factor of 30%. The electrical energy obtained during the year is 750 x 105 kWh. Determine the maximum demand. If the plant capacity factor is 24% find reserve capacity of the plant in KW.