A short 3-o transmission line with an impedance of (6+j 8)2 per phase has receiving end of 22000 kw, 120 KV, 0.8 lagging p.f. Determine (i) Sending voltage (ii) Sending current (iii) Sending power factor (iv) voltage regulation.

A short 3-o transmission line with an impedance of (6+j 8)2 per phase has receiving end of 22000 kw, 120 KV, 0.8 lagging p.f. Determine (i) Sending voltage (ii) Sending current (iii) Sending power factor (iv) voltage regulation.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.10MCQ: Transmission line conductance is usually neglected in power system studies. True False

See similar textbooks

Similar questions

Develop a small-scale equivalent transmission line pi model (per phase) of the transmission lines with the specification given in table 1. The conductors are placed with a flat horizontal spacing of 7.25 meters. Consider that the load connected against the line 125MW at 0.85 lagging power factor. You are required to develop an equivalent model for a maximum 220V (RMS) sending and receiving end voltage and a maximum of 5A load current. Sr. NTDC Transmission Line Length Conductor No. Туре 220 kV DG Khan-Loralai Transmission Line (227 km) 227km Pheasant TABLE AJ Electrical characteristics of bare aluminum conductors steel-relnforced (ACSR)+ Reniertance Reactance per conductor 1-ft apacing. 60 Ha Ae, 60 Ha Capaitive Aluminum ares, emil Layers of Outaide aluminum diameter, in a/1,000 ft soC, D/ml GMR Induetive Stranding AL/8t De, 20°C. 20C, a/mi Code word D. t Ma-mi Waswing Partridge Ostrieh Merlin Linnet Oriole Chickndee Ibin Pelienn Flicker Hawk 266,800 206,800 300,000 336, 400 336.400…
1) A 60-Hz, ...-km, three-phase overhead transmission line has a series impedance z = 0.8431L79.04 ohm/km and a shunt admittance y = 5.105 × 106 L90 S/km. The load at the receiving end is 125 MW at unity power factor and at 215 KVLL. Determine the voltage, current, real and reactive power at the sending end and the percent voltage regulation of the line for nominal pi network. (Please determine the length of the transmission line within the specified limits: 150-220 km. By considering the length value you determined yourself, solve the question.)
The VSWR on an 50-Ohm transmission line is 5. The distance between successive voltageminima is 80 cm while the distance from the load to the first minimum is 30 cm. What are thereflection coefficient and load impedance
2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation so that two of the distances between conductors are 20 ft and the third is 40 ft. The conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the capacitance to neutral and capacitive reactance of the line.
A 220 kV, three phase transmission line is 50 km long. The resistance per phase is r 2 per km and the inductance per phase is L mH per km. The shunt capacitance is negligible. If the line supplies a three-phase load of 229 MVA at 0.8 power factor lagging at 220 kV with an efficiency of 97.13% and a voltage regulation of 4.7581%. Use the short line model to find the line resistance and inductance of the line.
Please help
Power System: Please Show All Works
1/ Power loss due to corona is: a. Inversely proportional to frequency. b. Proportional to frequency. c. Frequency does not effect. d. All these answers are wrong. 2/ We prefer High voltage DC (HVDC) transmission system than High Voltage AC transmission system according to the cost, when: a. The distance of the line is more than B00 km. b. The distance of the line is less than 300 km. c. The distance of the line is equal to 300 km. d. All the above answers are wrong. 3/ HVDC Transmission has lower corona losses than HVAC Transmission because: a. HVDC Transmission tower is less height than HVAC Transmission tower. b. HVDC Transmission system work with zero frequency than HVAC Transmission system of 50 Hz. c. HVDC Transmission currents is uniform distributed in the all cross section of the system conductors than HVAC Transmission due to skin effect. d. All of the above answers are wright.
A 60-Hz, 230-mile, three-phase overhead transmission line has a series impedance z = 0.8431279.04° 0/mi and a shunt admittance y = 5.105 x 10-6290° S/mi. The load at the receiving end is 174 MW at unity power factor and at 215 kV. Using per-unit calculations, determine the sending-end line-to-line voltage (in kV) and line current (in A). (Enter the magnitudes. Use a base of 174 MVA and 215 kV.) voltage 154.2 current x kv A
High voltage engineering subject
A 3-phase overhead transmission line has a total series impedance per phase of 200 ∠80º ohms and a total shunt admittance of 0·0013∠90º siemen per phase. The line delivers a load of 80 MW at 0·8 p.f. lagging and 220 kV between the lines. Determine the sending end line voltage and current by rigorous method.
A three-phase transmission line operating at 345 kV, 600 MVA, 0.95 power factor lagging. The CT ratio is 1000:5 and the VT ratio is 3000:1. Determine the CT secondary current and the VT secondary voltage.