2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formationso that two of the distances between conductors are 20 ft and the third is 40 ft. Theconductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mileand the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find thecapacitance to neutral and capacitive reactance of the line.

Answered: Image /qna-images/answer/8a5315a9-d4d8-4f70-80ed-a9be1843d4cc.jpg

Answered: 2. A three-phase 60-hz transmission…

Engineering

Electrical Engineering

2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and…

Q: Draw the network: 1 .Grounded Delta

A: A system in which the secondary side of the transformer is delta-connected and one corner of the…

Q: What is the voltage drop in kV on the transmission line?

Q: (b) Define the five of the following: Ampere's Law, Gauss's Law of electric field, Standing wave,…

Q: In an alternator delivering lagging pf load, the excitation emf leads terminal voltage by the power…

Q: For an unloaded generator the line-to-line voltage at terminals of b with respect to c is 13.8<-80°…

Q: A three phase line has a reactance of 4.32 Ohms and resistance of 4.15 Ohms. The load at the…

A: Given data:Sending end voltage Vs = 36 kV.Line resistance RLine = 4.15 Line reactance Xline = 4.32…

Q: A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a…

Q: Generator Load I Load 2

Q: QUESTIONS AND PROBLEMS 1. A three-phase transmission line has a react- ance of 100 ohms and at…

A: The line reactance is Xline=100 Ω. The sender and receiving end voltages at different times are…

Q: The single-line diagram of a subtransmision system is presented in the figure below. At point B a…

A: Three phase fault is the symmetrical fault and it is the most severe fault.

Q: Calculate the capacitance / phase / km of the line.

Q: R14. Two sequence components and the corresponding phase voltage of 3ø system are ollowing,…

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A: Given data, Corona loss P1=53 KW at V1=106 KV Corona loss P2=98 KW at V2=111 KV Phase voltage is…

Q: ば 52+GS+13

A: In the question Find the Inverse laplace transform of the given function. We know cos(at)…

Q: Fion 7 The effect of capacitance between line and ground in a short transmission line cannot be…

A: 7) Depending upon the length of the transmission line, it is categorized into the following three…

Q: Q1 Drive the equation of unknown impedance for Hay Bridge

A: From the figure, consider that, Z1=R1-jωC1 Zx=Rx+jωLx Z2=R2 Z3=R3 Where Zx is an unknown impedance.…

Q: Phase sequence in a balanced three phase system is RBY, if B reaches maximum at 210°, then Y reaches…

Q: For an unloaded generator the line-to-line voltage at terminals of b with respect to c is 13.8<-80°…

A: Let us assume that a balanced three-phase system, the voltage between any two phases is related to…

Q: the inductance due to the urrent in each side of the line and the inductance of the complete line in…

A: Solution -

Q: Shunt conductance of transmission line accounts for. losses. Ohmic O Windage O Series voltage drop…

A: Two conductors or transmission lines separated by very small distance ,a shunt conductance is formed…

Q: Why do we need 220 V at 60 Hz in outlets? Why don’t we use DC in our transmission lines instead?

A: Transmission lines- Transmission lines are used to transfer electrical power from one place to…

Q: j4 2 -j2 0 Vx3 20 +. ZL +)4/0° V

A: In this question we need to find a Zl for maximum average power transfer to Zl

Q: Determine: (i) Frequency of oscillations (ii) The maximum value of RRRV (iii) Time taken to…

A: Given, I(rms) = 8000 A L = 2.5 mH C = 1.4*10^(-7) uF

Q: In Transmission Line, the DC and AC Resistance will always be equal. Select one: True False

A: AC resistance is the resistance of the conductor, taking into effect the Skin and proximity effect.…

Q: 3-phase single circuit 132 kV overhead line has conductors of diameter 1.8 cm each. The spacing…

Q: The following single-phase loads are connected to a 415V three-phase supply. Z, = (25- j15)n, z,…

A: The data given in the question are: VL=415V, VPH=4153=239.6 VZR=25-j15 Ω, ZY=45+j10 Ω, ZB=5+j30 Ω…

Q: Problem-3, Find the characteristic impedance of a quarter wave transformer connected in between a…

A: Given- Quarter wave transformer- Load R2=100 ohm, Transmission line characteristic impedance Zo=225…

Q: If the pu impedance of a single-phase transformer is 0.01 + j0.05, then its regulation at p.f. of…

A: Given, The pu impedance of a 1-φ transformer, Z=R+jX=0.01+j0.05 pu Power factor, cosφ=0.8 lagging…

Q: A three-phase 50 Hz double circuit as shown below, assumed that the line is completely trasposed.…

A: Mutual GMD (Geometric mean distance) can be calculated Dabeq=DabDab'Da'bDa'b'14=6×24×12×614=10.09…

Q: In a resistive load, the current angle: Leads the voltage by 90. In phase with the voltage angle.…

A: In this answer let us try to explain how the current angle and the voltage angle are oriented with…

Q: DetermiNe z-Bus For the Network eee clee joz 12) joils 1, 13) Ś l:2 jisgら

A: The impedance circuit of the network is The Admittance circuit can be drawn by calculating…

Q: T or F, modify the wrong part if False, please underline twice your answer if True or False.…

A: The solution is given below

Q: 6. In symmetrical components, if IRI = 100 30° and Iy2= 20 Z90° What is the value of Is ?

Q: A 230V DC generator voltage is increased above the rated voltage when the field current increases…

A: In this question ,we will write about effect of field current on generator voltage ...

Q: A 54 conductors/phase single phase line has a GMR of 15.9mm and a GMD of 2.3m. The axial length is…

A: In this question we will find total inductance of single phase line.

Q: A certain 3-phase equilateral transmission line has a total corona loss of 53 kW at 106 kV and a…

Q: A54 conductors/phase single phase line has a GMR of 15.9mm and a GMD of 2.3m. The axial length is…

A: In this question we will find total inductance of single phase line.....

Q: A single phase, 60Hz, 200-km medium nominal-T transmission line receives 700 MW at 0.95 lagging pf…

Q: 72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage…

Q: 4. The characteristic impedance of a transmission line with impedance and admittance of 16 and 9…

A: In this question, We need to choose the correct options What is characteristics impedance Zc?

Q: Power Transmission and Distribution Discuss the advantages and disadvantages of single-phase and…

Q: 6. In symmetrical components, if IR1 90° What is the value of Ip ? 100 z 30° and Iy2 = 20 -

A: From the symmetrical components

Question

2. A three-phase 60-hz transmission line has its conductors arranged in a triangular formation
so that two of the distances between conductors are 20 ft and the third is 40 ft. The
conductors are ACSR Rook. Determine the capacitance to neutral in microfarads per mile
and the capacitive reactance to neutral in ohm-miles. If the line is 115 mi long, find the
capacitance to neutral and capacitive reactance of the line.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Multiple Order System and Steady State Error

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In a delta-delta system, a phase voltage of 100 V produces a line voltage of
Solve all the steps of d) and e) only showing all the steps in correct details
In a three-phase system the per-unit phase voltages are 100° , Vôn = 0.8Z180° Van 0.920° , Von = 0.92 - а What are the per-unit symmetrical components V0) and V)? Express in polar notation.
.............. compensators are connected at receiving end to generate reactive power to the line.
In a single phase equivalent circuit, the current in the a-phase conductor line is simply the voltage generated in the a-phase winding of the generator divided by the total impedance in the a-phase of the circuit. Select one: O True O False
The capacitance of one conductor with respect to the neutral plane is times the capacitance of the single-phase line. O four two 0.5 O three
Answer the question the below Image. A single phase transmission line is delivering 500 kVA load at 2 kv. Its resistance is 0-20 and inductive reactance is 0-40. Determine the voltage regulation if the load power factor is 0-707 lagging. O 8.5 % O 7.2 % O 6.4 % O 5.3 % Continue
Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.2 kn, velocity 0.5*108 m/s then the value of inductance per meter 4 µH 3 µH 2 µH None of choices
2. Determine the Ripple factor, Kr VA wt 2 2
please explain each part on paper thank you i will like
Phase velocity of voltage wave in a distortion less line having characteristic impedance 0.1 kQ, velocity 0.5*108 m/s then the value of inductance per meter
72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage that appears across the contacts of circuit breaker if a magnetising current of 10A is interrupted is (ii) 356 kV (iv) 176 kV (1) 156 kV (iii) 245 kV