The standard heat reaction of the neutralization reaction and the standard heat of the reaction and the physical significance of the two calculated values should be calculated. Concept introduction: Neutralization reaction is the one which forms water and salt when there is a reaction between strong acids and base. The chemical reaction which release amount of heat absorbed or release from the formation of 1 mole of the chemical at 25’ Celsius is known as standard heat reaction △ H ^ f 0 . The difference between the two values represents the total amount of heat involved in conversion between standard states of each compound solution.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 9.47P

Interpretation Introduction

Interpretation:

The standard heat reaction of the neutralization reaction and the standard heat of the reaction and the physical significance of the two calculated values should be calculated.

Concept introduction:

Neutralization reaction is the one which forms water and salt when there is a reaction between strong acids and base.

The chemical reaction which release amount of heat absorbed or release from the formation of 1 mole of the chemical at 25’ Celsius is known as standard heat reaction △H^f0.

The difference between the two values represents the total amount of heat involved in conversion between standard states of each compound solution.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

In a surface coating operation, a polymer (plastic) dissolved in liquid acetone is sprayed on a solid surface and a stream of hot air is then blown over the surface, vaporizing the acetone and leaving a residual polymer film of uniform thickness. Because environmental standards do not allow discharg- ing acetone into the atmosphere, a proposal to incinerate the stream is to be evaluated. The proposed process uses two parallel columns containing beds of solid particles. The air– acetone stream, which contains acetone and oxygen in stoichiometric proportion, enters one of the beds at 1500 mm Hg absolute at a rate of 1410 standard cubic meters per minute. The particles in the bed have been preheated and transfer heat to the gas. The mixture ignites when its temperature reaches 562 C, and combustion takes place rapidly and adiabatically. The combustion products then pass through and heat the particles in the second bed, cooling down to 350 C in the process. Period- ically the flow is…

Propane is burned completely with excess oxygen. The product gas contains 24.5 mole% CO2, 6.10% CO, 40.8% H2O, and 28.6% O2. (a) Calculate the percentage excess O2 fed to the furnace. (b) A student wrote the stoichiometric equation of the combustion of propane to form CO2 and CO as: 2C3H8 + 11O2 → 3CO2 + 3CO + 8H2O According to this equation, CO2 and CO should be in a ratio of 1/1 in the reaction products, but in the product gas of Part (a) they are in a ratio of 24.8/6.12. Is that result possible? (Hint: Yes.) Explain how

Enumerate the various methods for catalyst preparation and discuss vividly any one of the methods