The heat of formation of the dried fungus cells is to be calculated. Concept introduction: Heat of combustion is the heat released when a substance is combusted in presence of oxygen to yield specific products such as, CO 2 ( g ) , H 2 O ( l ) with both the reactants and products being at the standard temperature and pressure or the reference state. Heat of formation is the change in enthalpy associated with the formation of the compound at the reference temperature and pressure. Heat of reaction is the change in enthalpy for a process in which stoichiometric amounts of reactants react completely to form products in a single reaction at the reference temperature and pressure.

Question

Want to see the full answer?

Answer 1

Question

Chapter 9, Problem 9.11P

Interpretation Introduction

Interpretation:

The heat of formation of the dried fungus cells is to be calculated.

Concept introduction:

Heat of combustion is the heat released when a substance is combusted in presence of oxygen to yield specific products such as, CO2(g), H2O(l) with both the reactants and products being at the standard temperature and pressure or the reference state.

Heat of formation is the change in enthalpy associated with the formation of the compound at the reference temperature and pressure.

Heat of reaction is the change in enthalpy for a process in which stoichiometric amounts of reactants react completely to form products in a single reaction at the reference temperature and pressure.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

A parallel flow heat exchanger with surface area of 62.5 m2 is to be designed for cooling oil at 80oC with specific heat of 2.5 kJ/kg·oC and mass flow rate of 5.0 kg/s. Water at 15oC flowing at 9.94 kg/s is used as the cooling fluid (cp = 4.19 kJ/kg·oC). 1 W = 1 J/s Can you determine the heat transfer rate and outlet temperatures, assuming an overall heat transfer coefficient equal to 300 W/m2·oC. For heat transfer rate, use the effectiveness, ε, and Check the results with log-mean temperature difference approach. (Calculate the heat transfer rate and compare the value in (1))v

A 5 cm diameter, 60 cm long aluminum cylinder initially at 50 oC is submerged in an ice-water bath at 2 oC. The convective heat transfer coefficient between the metal and the bath is 550 W/m2·K. Using the lumped parameter analysis, derive the equation below. Show procedures in detail please.And determine the central temperature of the aluminum after 1 min. For aluminum, k = 236 W/m·K, ρ =2702 kg/m3, and cp= 896 J/kg·K. (1 W = 1 J/s) Then calculate the cumulative heat transfer for the first 1 min.(the first law of theromodynamics is attached and the. needed equation to derive)

Radioactive waste is stored in the spherical stainless-steel container as shown schematically in the figure below. Heat generated within the waste material must be dissipated by conduction through the steel shell and then by convection to the cooling water. Pertinent dimensions and system operating variables are Inside radius of steel shell, ri = 0.4 m; Outside radius of steel shell, ro = 0.5 m Volumetric rate of heat generated within waste material, q˙= 105 W/m3, Thermal conductivity of steel = 15 W/m·K; Thermal conductivity of waste = 20 W/m·K, Convective heat-transfer coefficient between steel shell and water, h = 800 W/m2·K, Water temperature, T∞ = 25 oC. In the stainless-steel shell, the temperature profile as a function of radius, r can be expressed as follows:Can you: At steady state, calculate the temperature at the outside steel surface (r = ro). And Calculate the temperature at the inside steel surface (r = ri).