Concept explainers
Explorers in the jungle find an ancient monument in the shape of a large isosceles triangle as shown in Figure P9.25. The monument is made from tens of thousands of small stone blocks of density 3 800 kg/m3. The monument is 15.7 m high and 64.8 m wide at its base and is everywhere 3.60 m thick from front to back. Before the monument was built many years ago, all the stone blocks lay on the ground. How much work did laborers do on the blocks to put them in position while building the entire monument? Note: The gravitational potential energy of an object–Earth system is given by Ug = MgyCM, where M is the total mass of the object and yCM is the elevation of its center of mass above the chosen reference level.
Want to see the full answer?
Check out a sample textbook solutionChapter 9 Solutions
Physics For Scientists And Engineers With Modern Physics, 9th Edition, The Ohio State University
- A block of mass m = 200 g is released from rest at point along the horizontal diameter on the inside of hemispherical bowl of radius R = 30.0 cm, and the surface of the bowl is rough (Fig. P8.23). The blocks speed at point is 1.50 m/s. Figure P8.23 (a) What is its kinetic energy at point ? (b) How much mechanical energy is transformed into internal energy as the block moves from point to point ? (c) Is it possible to determine the coefficient of friction from these results in any simple manner? (d) Explain your answer to part (c).arrow_forwardA trough is 4 m long, 5 m wide, and 2 m deep. The vertical cross-section of the trough parallel to an end is shaped like an isosceles triangle. The trough is full of water. 5 m 4 m 2 m The mass density of water is 1000 . Use g 9.8 m as the acceleration constant due to gravity. Find the amount of work (in joules) required to empty the trough by pumping the water to the top of the tank.arrow_forwardQuestion #30. Please use the attached equation sheet and start with an equation from the sheet and work from there. You can manipulate anyway you want you just have to start from the equation sheet.arrow_forward
- A cylindrical tank, shown in the figure, has height 8 m and radius 4 m. Suppose the water tank is half-full of water. Determine the work required to empty the tank by pumping the water to a level 6 m above the top of the tank. Use 1000 kg/m³ for the density of water and 9.8 m/s² for the acceleration due to gravity. 4 m Draw a y-axis in the vertical direction (parallel to gravity) and choose the center of the bottom of the tank as the origin. For 0 ≤ y ≤8, find the cross-sectional area A(y). A(y) = (Type an exact answer, using as needed.) 8 marrow_forwardA leaky bucket which initially has 20 L of water and leaks at a constant rate is hanging from a 60 m rope. The rope weighs 3 kg in total. A person starts to pull up the bucket at constant speed, and when all the rope has been pulled up, the bucket has 8L of water left. How much work is done in pulling the bucket up?arrow_forwardA tank in the shape of an inverted right circular cone has height 5 meters and radius 2 meters. It is filled with 3 meters of hot chocolate. Find the work required to empty the tank by pumping the hot chocolate over the top of the tank. The density of hot chocolate is ?=1070 kg/m3. Your answer must include the correct units.arrow_forward
- Explorers in the jungle find an ancient monument in the shape of a large isosceles triangle as shown in the figure below. The monument is made from tens of thousands of small stone blocks of density 3 293 kg/m. The monument is 14.0 m high and 64.0 m wide at its base and is everywhere 2.50 m thick from front to back. Before the monument was built many years ago, all the stone blocks lay on the ground. How much work did laborers do on the blocks to put them in position while building the entire monument? Note: The gravitational potential energy of an object-Earth system is given by U, = Mgy CM, where M is the total mass of the object and yCM is the elevation of its center of mass above the chosen reference level.arrow_forwardA trough is 2 meters long, 3 meters wide, and 2 meters deep. The vertical cross-section of the trough parallel to an end is shaped like an isoceles triangle (with height 2 meters, and base, on top, of length 3 meters). The trough is full of water (density 1000. Find the amount of work in joules required to empty the trough by kg m m 9.8- as the s² - pumping the water over the top. (Note: Use g acceleration due to gravity.) 3 Joules ).arrow_forwardArteriosclerotic plaques forming on the inner wall of arteries can decrease the effective cross-sectional area of an artery. Even small changes in the effective area of an artery can lead to very large changes in the blood pressure in the artery and possibly to the collapse of the blood vessel. Imagine a healthy artery, with blood flow velocity of vo equals 0.14 m/s and mass per volume of p = 1050 kg/m³. The kinetic energy per unit volume of blood is given pv². This is one of the terms in Bernoulli's equation. Imagine that plague has narrowed an artery to 1/10 of its normal cross-sectional area, a 90% blockage. 1 2 by ko = a) Compared to normal blood flow velocity, vo, what is the velocity of blood as it passes through this blockage? b) By what factor does the kinetic energy per unit of blood volume change as the blood passes through this blockage? c) Using Bernoulli's equation as the blood passes through this blockage, what happens to the blood pressure?arrow_forward
- I need help with this homework problem.arrow_forwardA tank in the shape of a right circular cone, apex down, is filled with olive oil weighing 45lbs/ft^3. If the tank is 5 feet high and 4 feet in diameter across the top, how much work is required to pump the olive oil out of the top of the tank?arrow_forwardA tank has the shape of an inverted circular cone (point at the bottom) with height 6 feet and radius 4 feet. The tank is full of water. We pump out water (to a pipe at the top of the tank) until the water level is 3 feet from the bottom. The work W required to do this is given by W = foot-pounds.arrow_forward
- Physics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning