The reason of addition of ether to the nutmeg which is removed at the end of the experiment needs to be explained. Concept Introduction: Lipids are biomolecules which involve in different biochemical reactions. They are special types of organic molecules which can only identify with the help of their physical properties, not by the presence of any certain functional group . Triacylglycerols are the most abundant lipids, which are triesters of glycerol, therefore in the formation of one molecule of triacylglycerol, three molecules of fatty acids react with one molecule of glycerol as given below; CH 2 (OH)CH(OH)CH 2 (OH) + 3 R- COOH → CH 2 (OCOR)CH(OCOR)CH 2 (OCOR) + 3 H 2 O

Question

Want to see the full answer?

Answer 1

Question

Chapter 5.4, Problem 7E

Interpretation Introduction

Interpretation: The reason of addition of ether to the nutmeg which is removed at the end of the experiment needs to be explained.

Concept Introduction:

Lipids are biomolecules which involve in different biochemical reactions. They are special types of organic molecules which can only identify with the help of their physical properties, not by the presence of any certain functional group. Triacylglycerols are the most abundant lipids, which are triesters of glycerol, therefore in the formation of one molecule of triacylglycerol, three molecules of fatty acids react with one molecule of glycerol as given below;

CH2(OH)CH(OH)CH2(OH) + 3 R- COOH→CH2(OCOR)CH(OCOR)CH2(OCOR) + 3 H2O

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

LABORATORY REPORT FORM Part I. Determination of the Formula of a Known Hydrate 1. Mass of empty evaporating dish 3. Mass of hydrate Using subtraction or mass by difference, find the mass of the hydrate 76.96 -75.40 75.40g 76.968 1.568 01.56 76.90 g 2. Mass of evaporating dish + hydrate 4. Mass of evaporating dish + hydrate (after heating) First 76.98 g Third 76.66g Second Fourth (if necessary) 76.60g 5. Mass of anhydrate 6. Mass of water lost by the hydrate 7. Percent of water of hydration (Show Calculations) 8. Moles of water (Show Calculations) mol mass of water = MM of water (g/m) 9. Moles of anhydrate (Show Calculations) 10. Ratio of moles of water to moles of anhydrate 11 F(Show Calculations) 11. Formula of hydrate - Mass of water (g) x 100 % water hydration g g % Mass of hydrate (9) x IC % = (Mass of hydrate- mass of an) mass of hydrate (g) % = (1.569- × 100= mol 1.569 mol Mol Mass of anhydrate/MM of anhydrate 12. What was the color of the hydrate? blue What was the color of the…

compared t-critical with t-calculated and 95% confidence interval to answer this question

Comparing two means. Horvat and co-workers used atomic absorption spectroscopy to determine the concentration of Hg in coal fly ash. Of particular interest to the authors was developing an appropriate procedure for digesting samples and releasing the Hg for analysis. As part of their study they tested several reagents for digesting samples. Their results using HNO3 and using a 1+3 mixture of HNO3 and HCl are shown here. All concentrations are given as ppb Hg sample. HNO3: 161, 165, 160, 167, 166 1+3 HNO3–HCl: 159, 145, 140, 147, 143, 156 Determine whether there is a significant difference between these methods at the 95% confidence interval.