Physics for Scientists and Engineers with Modern Physics
10th Edition
ISBN: 9781337553292
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Videos
Question
Chapter 31, Problem 50CP
(a)
To determine
The reason why this configuration of conductors has an inductance.
(b)
To determine
The factor that constitutes the magnetic flux loop for the configuration.
(c)
To determine
To show: The inductance of the length
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solution
Students have asked these similar questions
Question #1. Consider a current-carrying circular wire with radius r. Find the angle between the infinitesimal length dl and some distance h?
+z
dl
h
dB
+y
y
Current-carrying circular wire
Note: radius r is perpendicular to the screen
Select one:
O 90°
O 0°
O 180°
O 270°
In earlier times when many households received nondigital
television signals from an antenna, the lead-in wires from
the antenna were often constructed in the form of two paral-
lel wires (Fig. P31.50). The two wires carry currents of equal
magnitude in opposite directions. The center-to-center
separation of the wires is w, and a is their radius. Assume
w is large enough compared with a that the wires carry the
current uniformly distributed over their surfaces and negli-
gible magnetic field exists inside the wires. (a) Why does this
configuration of conductors have an inductance? (b) What
TV antenna
TV set
Figure P31.50
constitutes the flux loop for this configuration? (c) Show
that the inductance of a length x of this type of lead-in is
w -
a
L
In
a
Chapter 32, Problem 006
A capacitor with square plates of edge length L is being discharged by a current of 0.59 A. The figure is a head-on view of one of the plates from inside the capacitor. A dashed rectangular path is
shown. If L = 8.3 cm, W = 5.1 cm, and H = 2.4 cm, what is the value of
ф8-ds around the dashed path?
Chapter 31 Solutions
Physics for Scientists and Engineers with Modern Physics
Ch. 31.1 - A coil with zero resistance has its ends labeled a...Ch. 31.2 - Prob. 31.2QQCh. 31.3 - Prob. 31.3QQCh. 31.4 - Prob. 31.4QQCh. 31.5 - (i) At an instant of time during the oscillations...Ch. 31 - Prob. 1PCh. 31 - Prob. 2PCh. 31 - Prob. 3PCh. 31 - Prob. 4PCh. 31 - Prob. 5P
Ch. 31 - A toroid has a major radius R and a minor radius r...Ch. 31 - Prob. 7PCh. 31 - Prob. 8PCh. 31 - Prob. 9PCh. 31 - Prob. 10PCh. 31 - Prob. 11PCh. 31 - Prob. 12PCh. 31 - Prob. 13PCh. 31 - You are working as a demonstration assistant for a...Ch. 31 - Prob. 15PCh. 31 - Prob. 16PCh. 31 - Prob. 17PCh. 31 - Prob. 18PCh. 31 - Prob. 19PCh. 31 - Prob. 20PCh. 31 - Prob. 21PCh. 31 - Prob. 22PCh. 31 - Prob. 23PCh. 31 - Prob. 24PCh. 31 - Prob. 25PCh. 31 - Prob. 26PCh. 31 - Prob. 27PCh. 31 - Prob. 28PCh. 31 - In the circuit of Figure P31.29, the battery emf...Ch. 31 - Prob. 30PCh. 31 - Prob. 31PCh. 31 - Prob. 32PCh. 31 - In Figure 31.15, let R = 7.60 , L = 2.20 mH, and C...Ch. 31 - Prob. 34PCh. 31 - Electrical oscillations are initiated in a series...Ch. 31 - Prob. 36APCh. 31 - A capacitor in a series LC circuit has an initial...Ch. 31 - Prob. 38APCh. 31 - Prob. 39APCh. 31 - At the moment t = 0, a 24.0-V battery is connected...Ch. 31 - Prob. 41APCh. 31 - Prob. 42APCh. 31 - Prob. 43APCh. 31 - Prob. 44APCh. 31 - Prob. 45APCh. 31 - At t = 0, the open switch in Figure P31.46 is...Ch. 31 - Prob. 47APCh. 31 - Prob. 48APCh. 31 - Prob. 49APCh. 31 - Prob. 50CPCh. 31 - Prob. 51CPCh. 31 - Prob. 52CPCh. 31 - Prob. 53CP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Coaxial cables are used extensively for cable television and other electronic applications. A coaxial cable consists of two concentric cylindrical conductors. The region between the conductors is completely filled with polyethylene plastic as shown in 26.8a. Current leakage through the plastic, in the radial direction, is unwanted. (The cable is designed to conduct current along its length, but that is not the current being considered here.) The radius of the inner conductor is a = 0.500 cm, the radius of the outer conductor is b = 1.75 cm, and the length is L = 15.0 cm. The resistivity of the plastic is 1.0 x 1013 Ω ⋅ m. Calculate the radial resistance of the plastic between the two conductors.arrow_forwardA portion of a long, cylindrical coaxial cable is shown in the figure below. An electrical current I = 3.0 amps flows down the center conductor, and this same current is returned in the outer conductor. Assume the current is distributed uniformly over the cross sections of the two parts of the cable. The values of the radii in the figure are r1 = 1.5 mm, r2 = 4.0 mm, and r3 = 7.0 mm. Using Ampere’s Law, find the magnitude of the magnetic field at the following distances from the center of the inner wire: a. 1.0 mm. b. 3.0 mm. c. 5.5 mm. d. 9.0 mm.arrow_forwardE13P5arrow_forward
- Two very long coaxial cylindrical conductors are shown in cross-section below. The inner cylinder has radius a = 2 cm and caries a total current of I1 = 1.0 A in the positive z-direction (pointing out of the page). The outer cylinder has an inner radius b = 4 cm, outer radius c = 6 cm and carries a current of I2 = 2.0 A in the negative z-direction (pointing into the page). You may assume that the current is uniformly distributed over the cross-sectional area of the conductors. a) Calculate the magnitude and direction of the magnetic field at a radius of r=20 cm. b) Calculate the magnitude and direction of the magnetic field at a radius of r=3 cm.arrow_forwardBiot-savart lawarrow_forwardHELPPParrow_forward
- The xy-plane serves as the interface between two different media. Medium 1 (z 0) is filled with a material whose H, = 4. If the interface carries current (1/H) a, mA/m, and B, = 5a, + 8a, mWb/m², find H, and B,. a12 =a, K O H1 =6arrow_forward7. A sheet of copper foil 1 mm thick, 5 cm wide and 1.75 m long is connected to a voltage source as shown. There is a magnetic field B = 2.5 T into the page. Assume copper has conductivity σ = 5.96 x 107 mho/m and a charge carrier density n = 1028 electrons/m³. a) What is the current density J in the foil? b) What is the Hall voltage as measured by the voltmeter? c) Which point is at a higher potential, a or b? Voltmeter 20 Varrow_forward00:33 7.00 ,4GM KB/S 49% O wire -wire 2 de K.- l, - K.- l2- A current carrying wire(wire-1) with i1 = 10 Amperesis placed at the origin on the Y-Z plane. Another current carrying wire(wire-2) with i2 = 12 Amperesis placed l = 8 mdistance apart on the Y-axis. The point P2 is l1 = 6 mfrom the wire-1. P1 (0, 6, –6) P2 (0, 6,0) and the point P3 (0, 6, 7) are on the same line. The direction of the current is given in the figure. Step 1: Consider a wire-1 only. a) Calculate magnetic field at P x component Give your answer up to at least three significance digits. y component Give your answer up to at least three significance digits. z component Give your answer up to at least three significance digits. Calculate the magnetic field at P2 x component Give your answer up to at least three significance digits. y component Give your answer up to at least three significance digits. z component Give your answer up to at least three significance digits. Step 2:Consider both wires b)Now what is the…arrow_forward
- A hollow copper tube carries a current along its length. Why is B = 0 inside the tube? Is B nonzero outside the tube?arrow_forwardA silver wire has resistivity p = 1.60 × 108 Q-m and a cross-sectional area of 2.20 mm2. The current in the wire is uniform and changing at the rate of 2850 A/s when the current is 180 A. (a) What is the magnitude of the (uniform) electric field in the wire when the current in the wire is 180 A? (b) What is the displacement current in the wire at that time? (c) What is the ratio of the magnitude of the magnetic field due to the displacement current to that due to the current at a distance r from the wire? (a) Number i Units (b) Number i Units (c) Number i Unitsarrow_forwardA length of copper wire carries a current of 10 A uniformly distributed through its cross section. Calculate the energy density of (a) the magnetic field and (b) the electric field at the surface of the wire. The wire diameter is 2.5 mm, and its resistance per unit length is 3.3 ohm/km.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning
Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
What is Electromagnetic Induction? | Faraday's Laws and Lenz Law | iKen | iKen Edu | iKen App; Author: Iken Edu;https://www.youtube.com/watch?v=3HyORmBip-w;License: Standard YouTube License, CC-BY