Physics for Scientists and Engineers with Modern Physics
10th Edition
ISBN: 9781337553292
Author: Raymond A. Serway, John W. Jewett
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 31, Problem 43AP
To determine
The current in the capacitor in the circuit after
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A resistor of resistance R = 10 Ω is connected in series with an inductor of L = 15 mH. The RL combination is connected to a variable voltage power supply (V = 4.5 V) by a switch as shown.
a. What is the time constant (τ) of the combination in seconds?
b. The power supply is set to maintain a constant voltage of V = 4.5 V and the switch is closed. Calculate the current, in amperes, through the circuit at t = 0.29 ms after the switch is closed.
c. Calculate the current through the circuit, in amperes, after the switch has been closed for a long time.
Consider the circuit shown in the figure below, where
L = 5.45 mH
and
R2 = 500 Ω.
The switch S can be positioned at either a or b.
A circuit contains a battery, a switch, an inductor, and two resistors. The battery is labeled 24.0 V and is on the left side of the circuit. The positive terminal is above the negative terminal. The circuit starts at the positive terminal and extends directly up, then directly to the right where it reaches the switch at a point labeled a. The switch is labeled S and allows the circuit to alternate between two paths. The first path starts at the positive terminal of the battery, goes up and then to the right through the switch from the point labeled a to a point without a label, goes to the right through the inductor labeled L at the top of the circuit, goes down through the resistors labeled R1 and R2 placed in parallel with each other on the right side of the circuit, goes to the left through a wire running directly from the right side of the circuit…
A battery of emf E is connected in series with a resistor, an inductor L, and a switch S. A capacitor C is connected in parallel to the inductor. When the switch is left in the closed position for a long time, the potential difference across the
capacitor is zero. The switch is opened and the maximum potential difference across the capacitor is measured to be 140 V. Determine the capacitance of the capacitor if E = 60 V, R = 125 N, and L = 54.0 mH.
ww
R
Chapter 31 Solutions
Physics for Scientists and Engineers with Modern Physics
Ch. 31.1 - A coil with zero resistance has its ends labeled a...Ch. 31.2 - Prob. 31.2QQCh. 31.3 - Prob. 31.3QQCh. 31.4 - Prob. 31.4QQCh. 31.5 - (i) At an instant of time during the oscillations...Ch. 31 - Prob. 1PCh. 31 - Prob. 2PCh. 31 - Prob. 3PCh. 31 - Prob. 4PCh. 31 - Prob. 5P
Ch. 31 - A toroid has a major radius R and a minor radius r...Ch. 31 - Prob. 7PCh. 31 - Prob. 8PCh. 31 - Prob. 9PCh. 31 - Prob. 10PCh. 31 - Prob. 11PCh. 31 - Prob. 12PCh. 31 - Prob. 13PCh. 31 - You are working as a demonstration assistant for a...Ch. 31 - Prob. 15PCh. 31 - Prob. 16PCh. 31 - Prob. 17PCh. 31 - Prob. 18PCh. 31 - Prob. 19PCh. 31 - Prob. 20PCh. 31 - Prob. 21PCh. 31 - Prob. 22PCh. 31 - Prob. 23PCh. 31 - Prob. 24PCh. 31 - Prob. 25PCh. 31 - Prob. 26PCh. 31 - Prob. 27PCh. 31 - Prob. 28PCh. 31 - In the circuit of Figure P31.29, the battery emf...Ch. 31 - Prob. 30PCh. 31 - Prob. 31PCh. 31 - Prob. 32PCh. 31 - In Figure 31.15, let R = 7.60 , L = 2.20 mH, and C...Ch. 31 - Prob. 34PCh. 31 - Electrical oscillations are initiated in a series...Ch. 31 - Prob. 36APCh. 31 - A capacitor in a series LC circuit has an initial...Ch. 31 - Prob. 38APCh. 31 - Prob. 39APCh. 31 - At the moment t = 0, a 24.0-V battery is connected...Ch. 31 - Prob. 41APCh. 31 - Prob. 42APCh. 31 - Prob. 43APCh. 31 - Prob. 44APCh. 31 - Prob. 45APCh. 31 - At t = 0, the open switch in Figure P31.46 is...Ch. 31 - Prob. 47APCh. 31 - Prob. 48APCh. 31 - Prob. 49APCh. 31 - Prob. 50CPCh. 31 - Prob. 51CPCh. 31 - Prob. 52CPCh. 31 - Prob. 53CP
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Figure P29.84 shows a circuit that consists of two identical emf devices. If R1 = R2 = R and the switch is closed, find an expression (in terms of R and ) for the current I that is in the branch from point a to b.arrow_forwardEach of the three situations in Figure P32.68 shows a resistor in a circuit in which currents are induced. Using Lenzs law, determine whether the current in each situation is from a to b or from b to a. a. If the current I in the wire in Figure P32.68A is increased from zero to I, what is the direction of the current induced across the resistor R? b. The switch in Figure P32.68B is initially closed and is thrown open at t = 0. What is the direction of the current induced across the resistor R immediately afterward? c. A bar magnet is brought close to the circuit shown in Figure P32.68C. What is the direction of the current induced across the resistor R?arrow_forwardYou connect a battery, resistor, and capacitor as in (Figure 1), where R = 14.0 Ω and C = 3.00 ×10^-6 F. The switch S is closed at t = 0. When the current in the circuit has magnitude 3.00 A, the charge on the capacitor is 40.0 × 10^−6 C. At what time t after the switch is closed is the charge on the capacitor equal to 40.0 x 10^-6 C? When the current has magnitude 3.00 A, at what rate is energy being stored in the capacitor?arrow_forward
- You are working as a demonstration assistant for a physics professor. He shows you the circuit in Figure P31.14, which he wants you to build for an upcoming class. The lightbulb is a household incandescent bulb that receives energy at the rate of 40.0 W when operating at 120 V. It has a resistance Ry, which, for simplicity, we will assume is constant at all operating voltages. The battery in the circuit has an emf of 12.0 V. When the switch has been closed for a long time, the bulb glows dimly, since it is powered by only 12.0 V. When the switch is opened, however, the bulb flashes brightly and then gradually dims to darkness. Your professor wants you to determine two values: (a) the resistance R, that is neces- sary for the bulb to initially flash, when the switch is opened, at the same brightness it would have if plugged into a 120-V socket; (b) the inductance L necessary to keep the current in the lightbulb above 50.0% of its value when the switch is opened, for a time interval of…arrow_forwardIn the figure, suppose the switch has been closed for a length of time sufficiently long for the capacitor to become fully charged. For this circuit, R1 = 12.0 kΩ, R2 = 15.0 kΩ, R3 = 3.000 kΩ, C = 10.0 μF , and emf = 9.00 V. Find (d) the potential differance across R2. (e) the charge on the capacitor.arrow_forwardAn RLC circuit consists of a 69.3 2 resistor, a 3.66 µF capacitor, and a 73.5 mH inductor. Initially, the voltage across the capacitor is 1.20 V, and no current is flowing in the circuit. What is the magnitude of the charge on the capacitor after 0.0104 s? It is not acceptable to let w' = w. i nCarrow_forward
- The figure below shows a capacitor, with capacitance C = 20.0 µF, and a resistor, with resistance R = 75.0 kN, con E = 21.0 V. The circuit has a switch, which is initially open. The circuit is a rectangular loop. The bottom side of the loop has an open switch S. The right side has a resistor R below a capacitor C. The left side has a battery labeled emf, oriented with the positive terminal above the negative terminal. (a) What is the circuit's time constant (in s)? (b) After the switch is closed for one time constant, how much charge (in C) is on the capacitor?arrow_forwardTime t < 0, the circuit is in DC Steady State. The switch is opened instantly at time t=0. When t<0, I₂ = 7 A, and I₃ = 9 A. R₁ = 5 Ω, R₂ = 4 Ω, and R₃ = 4 Ω. The solution for I₂ is I2 = I 0 e^ − R t / L. With several resistors in the circuit, the question is, what resistance do we use for R? Answer this question (in Ohms).arrow_forwardHi, I've sent you two questions, and according to the policy, you only answered one of them. And It's fine with me. Now I am missing answers to the second part of my questions. Who says: 1- Opg. 32.16: An AC source with AVmax = 150 V and f = 50 Hz is connected between points a and d in Figure P32.16. Calculate the maximum voltages between (a) points a and b, (b) points b and c, (c) points c and d, and (d) points b and d le 185 mH 65.0 µF Figur P32.16 40.0 N 2- How does the (phasor diagram) look for this assignment? Now, I send both parties together because they are related to each other. But I only want an answer to the second part. Many thanks for the help.arrow_forward
- A: What is v at t = 18.5 ms? B: What is vR at t = 18.5 ms? C: What is vL at t = 18.5 ms? D: What is vC at t = 18.5 ms? F: What is VR? G: What is VC? H: What is VL?arrow_forwardConsider the RL circuit in the figure with R=10.00 Ω, L1=1.80 H, L2=3.90 H, and V=5.0 V. At time t=0, the switch is closed to connect the circuit to a constant emf. How long (in seconds) does it take for the current to reach a value of Imax/2.71828 of its maximum value, where Imax is the maximum current through the circuit?arrow_forwardA circuit consists of a 35 N resistor and a 580 mH inductor connected in series to a 12 V battery. What is the value of the current when the current is increasing at the rate of 6 A/s? Answer in units of A.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
Principles of Physics: A Calculus-Based Text
Physics
ISBN:9781133104261
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Physics for Scientists and Engineers, Technology ...
Physics
ISBN:9781305116399
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning